Vacuum-free electric arc method for synthesis of lanthanum hexaboride
| Parent link: | Ceramics International.— .— Amsterdam: Elsevier Science Publishing Company Inc. Vol. 51, iss. 26, pt. A.— 2025.— P. 48443-48448 |
|---|---|
| מחברים אחרים: | Svinukhova A. A. Arina Andreevna, Li Yu. V. Yuliya Vladimirovna, Pak A. Ya. Aleksandr Yakovlevich, Spodina A. V. Anastasiya Vyacheslavovna, Stovpets D. E. Daniil Evgenjevich |
| סיכום: | Title screen This study reports on a method for producing lanthanum hexaboride (LaB6) by vacuum-free electric arc synthesis using lanthanum oxide powder (La2O3) and amorphous boron. The obtained experimental and analytical results demonstrate the feasibility of synthesizing cubic lanthanum hexaboride. The recommended arc reactor operating parameters determined for the maximum yield of the desired phase are shown. The resulting synthesis product contains LaB6 crystals, primarily in the micron range, with a distribution maximum of about 100 μm Текстовый файл AM_Agreement |
| שפה: | אנגלית |
| יצא לאור: |
2025
|
| נושאים: | |
| גישה מקוונת: | https://doi.org/10.1016/j.ceramint.2025.08.097 |
| פורמט: | אלקטרוני Book Chapter |
| KOHA link: | https://koha.lib.tpu.ru/cgi-bin/koha/opac-detail.pl?biblionumber=682517 |
פריטים דומים
Electric arc synthesis of lanthanum hexaboride
מאת: Spodina A. V. Anastasiya Vyacheslavovna
יצא לאור: (2025)
מאת: Spodina A. V. Anastasiya Vyacheslavovna
יצא לאור: (2025)
Vacuum-free arc synthesis and characterization of crystalline molybdenum borides as instrumental material
יצא לאור: (2025)
יצא לאור: (2025)
Effect of Conditions of the Pulsed Plasma-chemical Synthesis on Physicochemical Properties of the CuxOy/TiO2 Nanocomposite
יצא לאור: (2022)
יצא לאור: (2022)
Structural-Phase State and Morphology of a Composite Based on Magnesium Hydride and Magnesium Oxide Fabricated by Electric Arc Sputtering
יצא לאור: (2024)
יצא לאור: (2024)
In vitro evaluation of Ag doped hydroxyapatite coatings in acellular media
יצא לאור: (2019)
יצא לאור: (2019)
Influence of Ti, Zr or Nb carbide adhesion layers on the adhesion, corrosion resistance and cell proliferation of titania doped hydroxyapatite to the Ti6Al4V alloy substrate, utilizable for orthopaedic implants
יצא לאור: (2019)
יצא לאור: (2019)
Structure Changes in the Surface Layers of Ti-6Al-4V Titanium Alloy under Electron Beam Treatment
יצא לאור: (2017)
יצא לאור: (2017)
Effect of Irradiation with a Pulsed Electron Beam on the Defect Structure Formation and the Properties of the Surface Layer of Zr–Nb–H System Alloys
יצא לאור: (2023)
יצא לאור: (2023)
Fabrication of customizable wedged multilayer Laue lenses by adding a stress layer
יצא לאור: (2015)
יצא לאור: (2015)
Effect of Surface Modification of a Titanium Alloy by Copper Ions on the Structure and Properties of the Substrate-Coating Composition
יצא לאור: (2020)
יצא לאור: (2020)
The Effect of Heat Treatment on the Microstructure and Phase Composition of Wrought and 3D-Printed Ti–5Al–3Mo–1V Titanium Alloy Samples
יצא לאור: (2023)
יצא לאור: (2023)
On synthesis of nanocrystalline Ti-B/Ti-B-N phases in a hypersonic plasma jet
יצא לאור: (2016)
יצא לאור: (2016)
Bremsstrahlung converter system with target in vacuum
יצא לאור: (2021)
יצא לאור: (2021)
A new approach to reducing slagging based on laser modification of heating surfaces: Field tests and mathematical modeling
יצא לאור: (2025)
יצא לאור: (2025)
Effect of the structure and the phase composition on the mechanical properties of Al–Cu–Li alloy laser welds
יצא לאור: (2021)
יצא לאור: (2021)
Synthesis of Molybdenum Borides by the Impact of an A.C. Arc Discharge in Air
יצא לאור: (2025)
יצא לאור: (2025)
Effect of Ultrasonic Impact Treatment on Structural Phase Transformations in Ti-6Al-4V Titanium Alloy
יצא לאור: (2022)
יצא לאור: (2022)
Effect of ion treatment on the structure and properties of ceramic materials (review)
מאת: Gyngazov (Ghyngazov) S. A. Sergey Anatolievich
יצא לאור: (2023)
מאת: Gyngazov (Ghyngazov) S. A. Sergey Anatolievich
יצא לאור: (2023)
Effect of Annealing on the Microstructure and Structural-Phase State of Nanoscale Multilayer Zr/Nb Coatings after Irradiation with He+ Ions
יצא לאור: (2024)
יצא לאור: (2024)
Microstructure and Deformation Behavior of Novel Metal–Ceramic Laminated Composites Ta/Ti3Al(Si)C2–TiC
יצא לאור: (2024)
יצא לאור: (2024)
Facile Synthesis of La-modified CeO2 with Microwave Method for CO2 Adsorption
יצא לאור: (2024)
יצא לאור: (2024)
Формирование наноразмерных силицидов меди в высокоскоростной струе электроразрядной плазмы
יצא לאור: (2024)
יצא לאור: (2024)
Plasma diagnostics and characterization of the Mg and Mg–Zn thin films deposited by thermionic vacuum arc (TVA) method
יצא לאור: (2019)
יצא לאור: (2019)
Analysis of Thermal-Induced Microstructural Changes in Nanoscale Zr/Nb Metal Layers after Proton Irradiation
יצא לאור: (2024)
יצא לאור: (2024)
Effect of Surface Electropulsing Assisted Ultrasonic Impact Treatment on the Microstructure, Phase Composition, and Microhardness of 3D Printed Ti-6Al-4V Alloy
מאת: Perevalova O. B. Olga Borisovna
יצא לאור: (2021)
מאת: Perevalova O. B. Olga Borisovna
יצא לאור: (2021)
Синтез Магнели-фаз в высокоскоростной струе электроразрядной плазмы
יצא לאור: (2024)
יצא לאור: (2024)
Change in the Phase Composition and Lattice Parameters of the Solid Solution Based on a-Ti in the Surface Layers of the Ti–6Al–4V Alloy Subjected to Electron-Beam Treatment
מאת: Perevalova O. B. Olga Borisovna
יצא לאור: (2020)
מאת: Perevalova O. B. Olga Borisovna
יצא לאור: (2020)
The Effect of Electron Beam Welding on the Microstructure and Microhardness of 3D-Printed Products from Titanium Alloy Ti-6Al-4V
יצא לאור: (2021)
יצא לאור: (2021)
Electric Arc Synthesis of Titanium Carbide Using Carbon Obtained by the Thermal Conversion of Food Industry Wastes
יצא לאור: (2024)
יצא לאור: (2024)
Effect of carbon shell on stabilization of single-phase lanthanum and praseodymium hexaaluminates prepared by a modified Pechini method
יצא לאור: (2020)
יצא לאור: (2020)
X-rays generated by relativistic electrons in a waveguide radiator mounted inside a betatron
יצא לאור: (2011)
יצא לאור: (2011)
Metallurgy of a Ti–Au alloy synthesized by controlled electric resistance fusion
יצא לאור: (2020)
יצא לאור: (2020)
Получение углеродных графитоподобных наноматериалов при переработке отходов на основе асфальтенов
יצא לאור: (2022)
יצא לאור: (2022)
Исследование формирования призабойной зоны скважин при вскрытии карбонатных коллекторов с учетом их минерального состава
מאת: Черных В. И. Василий Игоревич
יצא לאור: (2022)
מאת: Черных В. И. Василий Игоревич
יצא לאור: (2022)
Oxidation Properties of High-Entropy Boride (Ti0.2Zr0.2Nb0.2Hf0.2Ta0.2)B2 Synthesized by DC Arc Discharge Plasma
יצא לאור: (2025)
יצא לאור: (2025)
On-line monitoring technology for sulfur content in the oil
מאת: Ismaylov N. N.
יצא לאור: (2013)
מאת: Ismaylov N. N.
יצא לאור: (2013)
Synthesis of silicon carbide nanopowders in free flowing plasma jet with different energy levels
יצא לאור: (2016)
יצא לאור: (2016)
Experimental search of parametric X-ray radiation in a silicon crystal at a small angle near the velocity direction of relativistic electrons
יצא לאור: (2001)
יצא לאור: (2001)
Polyhedral Graphite Particles Ambient Air Direct Current Arc Plasma Synthesis Supported by Molybdenum Catalyst
יצא לאור: (2020)
יצא לאור: (2020)
The influence of lanthanum content in the Fe2O3-Li2O-La(OH)3 system on phase formation and properties of composite material
יצא לאור: (2025)
יצא לאור: (2025)
פריטים דומים
-
Electric arc synthesis of lanthanum hexaboride
מאת: Spodina A. V. Anastasiya Vyacheslavovna
יצא לאור: (2025) -
Vacuum-free arc synthesis and characterization of crystalline molybdenum borides as instrumental material
יצא לאור: (2025) -
Effect of Conditions of the Pulsed Plasma-chemical Synthesis on Physicochemical Properties of the CuxOy/TiO2 Nanocomposite
יצא לאור: (2022) -
Structural-Phase State and Morphology of a Composite Based on Magnesium Hydride and Magnesium Oxide Fabricated by Electric Arc Sputtering
יצא לאור: (2024) -
In vitro evaluation of Ag doped hydroxyapatite coatings in acellular media
יצא לאור: (2019)