Особенности формирования сварного шва при имитации электронно-лучевой сварки толстостенных образцов ВТ6, полученных электронно-лучевой аддитивной
| Parent link: | Перспективы развития фундаментальных наук=Prospects of Fundamental Sciences Development: сборник научных трудов XХII Международной конференции студентов, аспирантов и молодых ученых, г. Томск, 22-25 апреля 2025/ Национальный исследовательский Томский политехнический университет ; под ред. И. А. Курзиной [и др.].— .— Томск: Изд-во ТПУ Т. 1 : Физика.— 2025.— С. 293-295 |
|---|---|
| Main Author: | |
| Other Authors: | , |
| Summary: | Заглавие с экрана This paper presents a comparative analysis of the geometry of weld zones of wrought and electron beam additive manufactured (EBAM) VT6 titanium alloy thick-walled samples. Bead-on-plate electron beam welding (EBW) was carried out by single-pass movement of the electron beam across the VT6 samples. The results of metallographic studies have demonstrated that the penetration of the EBAM VT6 samples during EBW was higher than that of the wrought VT6 samples under the same EBW conditions. The influence of the trajectory scans of the electron beam on the appearance of defects in the seams, consisted fine martensitic α/α` needles inside prior β columnar grains has been shown Текстовый файл |
| Language: | Russian |
| Published: |
2025
|
| Subjects: | |
| Online Access: | http://earchive.tpu.ru/handle/11683/132870 |
| Format: | Electronic Book Chapter |
| KOHA link: | https://koha.lib.tpu.ru/cgi-bin/koha/opac-detail.pl?biblionumber=682468 |