The properties of Cu films deposited by high rate magnetron sputtering from a liquid target
| Parent link: | Vacuum Vol. 169.— 2019.— [108914, 9 p.] |
|---|---|
| Corporate Author: | |
| Other Authors: | , , , , , |
| Summary: | Title screen The focus of the paper is Cu films obtained by magnetron sputtering a liquid target at an average power density not exceeding 45 W/cm2. The deposition rates reached 140 nm/s. In the film formation, the pulsed power supplies of two types have been used. The discharge has functioned in an Ar atmosphere and in self-sustained mode. Structural and electrically conductive properties of the films have been analyzed. A comparison was made with those deposited by sputtering a cooled target with similar power. It has revealed that the evaporation of the magnetron target plays a dominant role in the formation of the structural and conductive properties of Cu films. The Cu films deposited by sputtering evaporative liquid targets have a lower electrical resistance than the films of similar thickness obtained by sputtering cooled targets. The mode of self-sustained sputtering does not significantly affect the structural properties of the films as compared with sputtering in the Ar atmosphere, but the electrical resistivity is approximately 20% lower. Due to high deposition rate in the case with evaporative targets the heating of the substrate when producing films of equal thickness turns out to be less than when using a magnetron with a cooled target. Режим доступа: по договору с организацией-держателем ресурса |
| Published: |
2019
|
| Subjects: | |
| Online Access: | https://doi.org/10.1016/j.vacuum.2019.108914 |
| Format: | Electronic Book Chapter |
| KOHA link: | https://koha.lib.tpu.ru/cgi-bin/koha/opac-detail.pl?biblionumber=661062 |