Изменение термохимических параметров нано- и микропорошков железа после облучения потоком ускоренных электронов
| Parent link: | Вестник Томского государственного университета. Химия/ Национальный исследовательский Томский государственный университет (ТГУ).— , 2015- № 1 (3).— 2016.— [С. 79-89] |
|---|---|
| Corporate Authors: | , |
| Other Authors: | , , , |
| Summary: | Заглавие с экрана Исследовано влияние низкоэнергетического электронного пучка с энергией 360 кэВ на изменение параметров химической активности микро- и нанопорошков железа при нагревании в воздухе. С помощью метода дифференциального термического анализа установлено, что после воздействия электронного пучка происходило повышение температуры начала окисления порошков железа на ~30°С. Таким образом, воздействие электронного пучка с энергией 360 кэВ на порошки железа приводит к повышению их термической устойчивости к окислению в воздухе, но не влияет на другие параметры их химической активности. Вероятно, действие потока ускоренных электронов приводит к десорбции и удалению связанной воды с поверхности частиц железа, что понижает концентрацию основного окислителя железа - подвижных протонов. Changing of material properties can be observed after converting metals from massive to dispersed aggregation. Some new properties are revealed for nanosized powders, an energy storage. The value of total stored energy connected with the surface energy of nanoparticles as well as the energy stored in the particles structure. The powders of iron are widely used for powder metallurgy, for 3D printing and as a component of pyrotechnic mixtures. The development and propagation of resource-efficient and energy-efficient technologies requires the creation of powder materials, which are resistant to oxidation in air. One of proposal decision for described issues is a high-energy irradiation of powder materials. High energy irradiation by electron beams causes significant changes in physicochemical properties of metal nanopowders. The high-energy electron beam (4 MeV) was used in while the powder heating was not being under control. The heating of the powder by irradiation changed the heat effect presumably. The changes of properties can be explained by accumulation of positive charge inside the metal particle insulated by oxidehydroxide coating and relaxation of charges when heated. The purpose of the current research is a studying of influence of regularities of electron beam (360 keV) irradiation on to thermochemical properties of iron micro and nanopowders when heated in the air. It was determined that the electron beam irradiation (360 keV) of micro- and nanopowders provides the initial oxidation temperature increasing at 30 degrees for both of powders. For the same time the oxidation rate changes a little (~1%) during the heating of powders up to 1000°C. This way the modification of iron micro- and nanopowders by electron beam irradiation provides increasing of their thermal oxidation resistance (the initial oxidation temperature increasing) without any degradation of chemical activity parameters. Режим доступа: по договору с организацией-держателем ресурса |
| Published: |
2016
|
| Series: | Физико-химические закономерности процессов, структура и свойства соединений |
| Subjects: | |
| Online Access: | http://journals.tsu.ru/chemistry/&journal_page=archive&id=1411&article_id=30184 http://elibrary.ru/item.asp?id=26673886 |
| Format: | Electronic Book Chapter |
| KOHA link: | https://koha.lib.tpu.ru/cgi-bin/koha/opac-detail.pl?biblionumber=651168 |