Strength of Cutting Tool in Titanium Alloy Machining
| Parent link: | Key Engineering Materials: Scientific Journal Vol. 685 : High Technology: Research and Applications 2015 (HTRA 2015).— 2016.— [P. 427-431] |
|---|---|
| Main Author: | |
| Corporate Author: | |
| Other Authors: | |
| Summary: | Title screen In this paper, contact conditions between cutting tool and work material, strength of cutting tool are analyzed. Experimental and theoretical studies of contact load distribution on the artificial flank wear-land that appears on the cutter in a free orthogonal turning disk of titanium alloy (Ti-6Al-2Mo-2Cr) are described. Calculations of internal stresses by the method of finite elements show that for the sharp cutter the main stresses into cutting wedge near to the cutting edge are compression stresses, very large (10 000 MPa) and exceed ultimate compression stress for cemented carbide. Decreasing of main stress with appearance of wear on the flank explains ability working of cutter even at large wear on the flank. Increasing of cutter’s break off probability with appearance of large wear on the flank is explained by increasing of zone where the internal stresses are large enough (more or equal 3 000 MPa) and increasing of defects probability into this zone, which serves as source of cracks. Режим доступа: по договору с организацией-держателем ресурса |
| Published: |
2016
|
| Series: | Mechanical Engineering Technology |
| Subjects: | |
| Online Access: | http://dx.doi.org/10.4028/www.scientific.net/KEM.685.427 |
| Format: | Electronic Book Chapter |
| KOHA link: | https://koha.lib.tpu.ru/cgi-bin/koha/opac-detail.pl?biblionumber=646454 |