Well extension in fractured and broken rocks by wire-line tool (SSK-59); IOP Conference Series: Earth and Environmental Science; Vol. 24 : Scientific and Technical Challenges in the Well Drilling Progress, 24–27 November 2014, Tomsk, Russia

Bibliografische gegevens
Parent link:IOP Conference Series: Earth and Environmental Science
Vol. 24 : Scientific and Technical Challenges in the Well Drilling Progress, 24–27 November 2014, Tomsk, Russia.— 2015.— [012006, 5 p.]
Hoofdauteur: Brylin V. I. Vladimir Ivanovich
Coauteurs: Национальный исследовательский Томский политехнический университет (ТПУ) Институт природных ресурсов (ИПР) Кафедра бурения скважин (БС), Национальный исследовательский Томский политехнический университет (ТПУ) Институт природных ресурсов (ИПР) Кафедра иностранных языков (ИЯПР)
Andere auteurs: Ulyanova O. S. Oksana Sergeevna
Samenvatting:Title screen
Conditions of increasing the drilling rate per run, which influence wire-line tool application efficiency, are analyzed. Decreasing of drilling rate is usually caused by alarm initiation which indicates core blocking. Producing of longitudinal and lateral vibrations during drilling process and initiation of fluid upward flow inside the inner core pipe, significantly increases the drilling rate. For initiating an upward flow inside the inner core pipe it is suggested to install the bottom hole pump inside the wireline inner core barrel to be applied as a mechanical motor of downhole vibrator which starts to operate only in a case of core blocking. It was found out that the bottom hole pump provided the necessary speed of upward flow (0.3 - 0.5 m/s) at the rotation speed of more than 150 rpm. Field test was carried out to drill siltstone and sandstone formations of 9 -10 drilling category and their alternation with the formation dip angle of more than 70° (rough and disintegrated rocks). The upward flow inside the inner core pipe SSK-59 allowed increasing the drilling rate by 10% as well as to increase core recovery ratio. Besides, it was noted that a large amount of the cuttings (sized 8 - 10 mm) were accumulating inside the inner core pipe during downhole pump application, that in its turn, proved the initiation of upward flow inside the inner core pipe.
Режим доступа: по договору с организацией-держателем ресурса
Taal:Engels
Gepubliceerd in: 2015
Onderwerpen:
Online toegang:http://dx.doi.org/10.1088/1755-1315/24/1/012006
Formaat: Elektronisch Hoofdstuk
KOHA link:https://koha.lib.tpu.ru/cgi-bin/koha/opac-detail.pl?biblionumber=639661