RF Magnetron Sputtering of Substituted Hydroxyapatite for Deposition of Biocoatings; Materials; Vol. 15, iss. 19

RF Magnetron Sputtering of Substituted Hydroxyapatite for Deposition of Biocoatings; Materials; Vol. 15, iss. 19

Bibliografske podrobnosti
Parent link:	Materials.— .— Basel: MDPI AG Vol. 15, iss. 19.— 2022.— Article number 6828, 25 p.
Drugi avtorji:	Prosolov K. A. Konstantin Alexandrovich, Lastovka V. V. Vladimir Viktorovich, Khimich M. A. Margarita Andreevna, Chebodaeva V. V. Valentina Vadimovna, Khlusov I. A. Igor Albertovich, Sharkeev Yu. P. Yury Petrovich
Izvleček:	Title screen Functionalization of titanium (Ti)-based alloy implant surfaces by deposition of calcium phosphates (CaP) has been widely recognized. Substituted hydroxyapatites (HA) allow the coating properties to be tailored based on the use of different Ca substitutes. The formation of antibacterial CaP coatings with the incorporation of Zn or Cu by an RF magnetron sputtering is proposed. The influence of RF magnetron targets elemental composition and structure in the case of Zn-HA and Cu-HA, and the influence of substrate’s grain size, the substrate’s temperature during the deposition, and post-deposition heat treatment (HT) on the resulting coatings are represented. Sintering the targets at 1150 °C resulted in a noticeable structural change with an increase in cell volume and lattice parameters for substituted HA. The deposition rate of Cu-HA and Zn-HA was notably higher compared to stochiometric HA (10.5 and 10) nm/min vs. 9 ± 0.5 nm/min, respectively. At the substrate temperature below 100 °C, all deposited coatings were found to be amorphous with an atomic short-range order corresponding to the {300} plane of crystalline HA. All deposited coatings were found to be hyper-stochiometric with Ca/P ratios varying from 1.9 to 2.5. An increase in the substrate temperature to 200 °C resulted in the formation of equiaxed grain structure on both coarse-grained (CG) and nanostructured (NS) Ti. The use of NS Ti notably increased the scratch resistance of the deposited coatings from18 ± 1 N to 22 ± 2 N. Influence of HT in air or Ar atmosphere is also discussed. Thus, the deposition of Zn- or Cu-containing CaP is a complex process that could be fine-tuned using the obtained research results Текстовый файл
Jezik:	angleščina
Izdano:	2022
Teme:	электронный ресурс труды учёных ТПУ antibacterial effect biocompatibility calcium phosphate ion substitution physical vapor deposition thin films
Online dostop:	https://doi.org/10.3390/ma15196828
Format:	Elektronski Book Chapter
KOHA link:	https://koha.lib.tpu.ru/cgi-bin/koha/opac-detail.pl?biblionumber=682133

Podobne knjige/članki

Comparison Study on the Properties of the CaP Coatings Formed by RF-magnetron Sputtering of the Mg- and Sr-substituted [beta]-tricalcium Phosphate and Hydroxyapatite; Energy Fluxes and Radiation Effects (EFRE-2020 online)
Izdano: (2020)

Influence of oblique angle deposition on Cu-substituted hydroxyapatite nano-roughness and morphology; Surface and Coatings Technology; Vol. 394
Izdano: (2020)

Glancing Angle Deposition of Zn-Doped Calcium Phosphate Coatings by RF Magnetron Sputtering; Coatings; Vol. 9, iss. 4
Izdano: (2019)

Thin bioactive Zn-substituted hydroxyapatite coating deposited on Ti substrate by radiofrequency sputtering; High Temperature Material Processes: An International Quarterly of High-Technology Plasma Processes; Vol. 21, iss. 3
Izdano: (2018)

Influence of the substrate bias on the stoichiometry and structure of RF-magnetron sputter-deposited silver-containing calcium phosphate coatings; Materialwissenschaft und Werkstofftechnik; Vol. 44, iss. 2-3
Izdano: (2013)

Antibacterial Calcium Phosphate Coatings for Biomedical Applications Fabricated via Micro-Arc Oxidation; Biomimetics; Vol. 8, iss. 5
Izdano: (2023)

Functionalization of titania nanotubes with electrophoretically deposited silver and calcium phosphate nanoparticles: Structure, composition and antibacterial assay; Materials Science and Engineering: C; Vol. 97
Izdano: (2019)

RF magnetron-sputtered coatings deposited from biphasic calcium phosphate targets for biomedical implant applications; Bioactive Materials; Vol. 2, iss. 3
Izdano: (2017)

Influence of Cu Substitution on the Properties of Hydroxyapatite Targets and Deposited Coatings; Coatings; Vol. 13, iss. 11
Izdano: (2023)

Thin Bioactive Zn Substituted Hydroxyapatite Coating Deposited on Ultrafine-Grained Titanium Substrate: Structure Analysis; Frontiers in Materials; Vol. 5
Izdano: (2018)

Influence of the high-power ion-beam irradiation of a hydroxyapatite target on the properties of formed calcium phosphate coatings; Journal of Surface Investigation. X-ray, Synchrotron and Neutron Techniques; Vol. 7, iss. 5
od: Bleykher (Bleicher) G. A. Galina Alekseevna
Izdano: (2013)

Radio frequency magnetron sputtering of Sr- and Mg-substituted ?-tricalcium phosphate: Analysis of the physicochemical properties and deposition rate of coatings; Applied Surface Science; Vol. 509
Izdano: (2020)

Antibacterial and biocompatible Zn and Cu containing CaP magnetron coatings for MgCa alloy functionalization; Journal of Materials Research and Technology; Vol. 25
Izdano: (2023)

Zn- or Cu-containing CaP-Based Coatings Formed by Micro-Arc Oxidation on Titanium and Ti-40Nb Alloy: Part II-Wettability and Biological Performance; Materials; Vol. 13, iss. 19
Izdano: (2020)

The structure of an rf-magnetron sputter-deposited silicate-containinghydroxyapatite-based coating investigated by high-resolution techniques; Surface and Coatings Technology; Vol. 218
Izdano: (2013)

Integration of Graphene into Calcium Phosphate Coating for Implant Electronics; ACS Applied Materials and Interfaces; Vol. 17, iss. 9
Izdano: (2025)

Nitrogen-Doped Titanium Dioxide Thin Films Formation on the Surface of PLLA Electrospun Microfibers Scaffold by Reactive Magnetron Sputtering Method; Plasma Chemistry and Plasma Processing; Vol. 39, iss. 2
Izdano: (2019)

A review of plasma-assisted methods for calcium phosphate-based coatings fabrication; Surface and Coatings Technology; Vol. 206, iss. 8-9
od: Surmenev R. A. Roman Anatolievich
Izdano: (2012)

Correlation between structural and mechanical properties of RF magnetron sputter deposited hydroxyapatite coating; Materials Characterization; Vol. 142
Izdano: (2018)

Effect of argon and nitrogen mixing ratios on the properties of the coatings deposited via reactive magnetron sputtering of a hydroxyapatite target; Applied Surface Science; Vol. 726
Izdano: (2026)

Zn-, Cu- or Ag-incorporated micro-arc coatings on titanium alloys: Properties and behavior in synthetic biological media; Surface and Coatings Technology; Vol. 369
Izdano: (2019)

The formation of calcium phosphate coatings by pulse laser deposition on the surface of polymeric ferroelectric; Applied Surface Science; Vol. 349
Izdano: (2015)

Physico-mechanical properties of Ti-Zr coatings fabricated via ion-assisted arc-plasma deposition; Vacuum; Vol. 149
Izdano: (2018)

Calcium phosphate coating deposition by radio frequency magnetron sputtering in the various inert gases: The pilot study; Materials Chemistry and Physics; Vol. 235
Izdano: (2019)

Fabrication, ultra-structure characterization and in vitro studies of RF magnetron sputter deposited nano-hydroxyapatite thin films for biomedical applications; Applied Surface Science; Vol. 317
Izdano: (2014)

Biological Effect of the Surface Modification of the Fibrous Poly(L-lactic acid) Scaffolds by Radio Frequency Magnetron Sputtering of Different Calcium-Phosphate Targets; BioNanoScience; Vol. 7, iss. 1
Izdano: (2017)

Porous CaP Coatings Formed by Combination of Plasma Electrolytic Oxidation and RF-Magnetron Sputtering; Coatings; Vol. 10, iss. 11
Izdano: (2020)

Thin calcium-phosphate coatings produced by RF Magnetron sputtering and prospects for their use in biomedical engineering; Biomedical Engineering; Vol. 42, iss. 3
Izdano: (2008)

The preparation of calcium phosphate coatings on titanium and nickel-titanium by rf-magnetron-sputtered deposition: Composition, structure and micromechanical properties; Surface and Coatings Technology; Vol. 202, iss. 16
Izdano: (2008)

Polyether Ether Ketone Coated with Ultra-Thin Films of Titanium Oxide and Zirconium Oxide Fabricated by DC Magnetron Sputtering for Biomedical Application; Materials; Vol. 15, iss. 22
Izdano: (2022)

Combined HF+MW CVD Approach for the Growth of Polycrystalline Diamond Films with Reduced Bow; Coatings; Vol. 13, iss. 2
Izdano: (2023)

Antibacterial Activity and Cytocompatibility of Electrospun PLGA Scaffolds Surface-Modified by Pulsed DC Magnetron Co-Sputtering of Copper and Titanium; Pharmaceutics; Vol. 15, iss. 3
Izdano: (2023)

Tailoring the Surface Morphology and the Crystallinity State of Cu- and Zn-Substituted Hydroxyapatites on Ti and Mg-Based Alloys; Materials; Vol. 13, iss. 19
Izdano: (2020)

Physical principles of radio-frequency magnetron sputter deposition of calcium-phosphate-based coating with tailored properties; Surface and Coatings Technology; Vol. 413
Izdano: (2021)

An Apparatus for Studying Phosphor Luminescence upon Excitation by Atomic–Molecular Beams; Instruments and Experimental Techniques; Vol. 63, iss. 2
Izdano: (2020)

Thermal stability of a-C:H:SiOx thin films in hydrogen atmosphere; Thin Solid Films; Vol. 690
Izdano: (2019)

Reactive magnetron deposition of YAG:Ce phosphor coatings in the metallic mode; Optical Materials; Vol. 156
Izdano: (2024)

Magnetron Deposition of Oxide Films in the Metallic Mode Enhanced by Radio-Frequency Inductively Coupled Plasma Source; Journal of Surface Investigation. X-ray, Synchrotron and Neutron Techniques; Vol. 17, iss. 5
od: Sidelev D. V. Dmitry Vladimirovich
Izdano: (2023)

High-rate magnetron deposition of CuOx films in the metallic mode enhanced by radiofrequency inductively coupled plasma source; Vacuum; Vol. 207
od: Sidelev D. V. Dmitry Vladimirovich
Izdano: (2023)

Surface Treatments and Residual Stress: Assessing the Implications for Biocompatibility in Titanium Implants; Russian Physics Journal; Vol. 66, iss. 1
od: Prosolov K. A. Konstantin Aleksandrovich
Izdano: (2023)