Mitigation of the effect of variations in the electrical conductivity of the material via two-frequency eddy current testing of the thickness of the electrically conductive wall under significantly varying influence parameters; Вестник Карагандинского университета. Серия Физика; № 1 (109)
| Parent link: | Вестник Карагандинского университета. Серия Физика.— .— Караганда: КарГУ № 1 (109).— 2023.— С. 71-79 |
|---|---|
| Autore principale: | |
| Altri autori: | |
| Riassunto: | The paper analyzes feasibility of the two-frequency eddy current method for measuring the thickness of an electrically conductive wall under significantly varying test and influence parameters of the test object — the lift-off between the eddy current probe and the test object surface, and the electrical conductivity of the material. An analytical solution was used to determine the dependence of the two-frequency signal of the surface eddy current probe on the influence parameters of the test object. The informative parameters used to simultaneously mitigate the effect of the two influence parameters were the amplitude of the added high-frequency voltage to determine the lift-off, the phase of the added low-frequency voltage to determine the wall thickness, and the phase of the added high-frequency voltage to suppress variations in the electrical conductivity of the material. The calculated dependences of the informative parameters on the test and influence parameters were analyzed. The use of nonlinear functions of the inverse transformation of the informative parameter into the test parameter was shown to efficiently mitigate the effect of variations in the lift-off on measurement results. A method to suppress variations in the electrical conductivity of the test object material is proposed. It implies the correction
of the phase of the added low-frequency voltage by the correction value calculated from the parameters of the lift-off and wall thickness, and high-frequency phase variation caused by varying the electrical conductivity of the material Исследована применимость двухчастотного метода вихретокового контроля толщины электропроводящей стенки в условиях значительных изменений как контролируемого, так и влияющих параметров объекта контроля — зазора между вихретоковым преобразователем и поверхностью объекта контроля и удельной электрической проводимости материала. Для определения зависимости двухчастотного сигнала накладного вихретокового преобразователя от влияющих параметров объекта контроля использовано аналитическое решение. Для одновременной отстройки от двух влияющих параметров объекта контроля предложено использовать в качестве информативных параметров амплитуду вносимого напряжения высокой частоты для определения зазора, фазу вносимого напряжения низкой частоты для определения толщины стенки и фазу вносимого напряжения высокой частоты для отстройки от изменения удельной электрической проводимости материала. Проанализированы полученные расчетным путем зависимости значений информативных параметров от контролируемого и влияющих параметров. Отмечена эффективность использования для отстройки от влияния на результаты контроля изменений зазора нелинейных функций обратного преобразования значений информативных параметров в значение контролируемого параметра. Предложен метод отстройки от изменения удельной электрической проводимости металла объекта контроля, основанный на коррекции фазы вносимого напряжения низкой частоты на величину поправки, определяемой значениями зазора, толщины стенки и изменением фазы высокой частоты, обусловленным изменением удельной электрической проводимости материала Текстовый файл |
| Lingua: | inglese |
| Pubblicazione: |
2023
|
| Soggetti: | |
| Accesso online: | https://doi.org/10.31489/2023ph1/71-79 |
| Natura: | MixedMaterials Elettronico Capitolo di libro |
| KOHA link: | https://koha.lib.tpu.ru/cgi-bin/koha/opac-detail.pl?biblionumber=681448 |
MARC
| LEADER | 00000naa0a2200000 4500 | ||
|---|---|---|---|
| 001 | 681448 | ||
| 005 | 20251224132702.0 | ||
| 090 | |a 681448 | ||
| 100 | |a 20250828d2023 k||y0rusy50 ba | ||
| 101 | 0 | |a eng |c rus | |
| 102 | |a KZ | ||
| 135 | |a drcn ---uucaa | ||
| 181 | 0 | |a i |b e | |
| 182 | 0 | |a b | |
| 183 | 0 | |a cr |2 RDAcarrier | |
| 200 | 1 | |a Mitigation of the effect of variations in the electrical conductivity of the material via two-frequency eddy current testing of the thickness of the electrically conductive wall under significantly varying influence parameters |d Отстройка от влияния изменений электропроводности материала при реализации двухчастотного вихретокового метода контроля толщины электропроводящей стенки в условиях значительных изменений влияющих параметров |f A. E. Goldshteyn, Kh. Kh. Abakumov |z rus | |
| 203 | |a Текст |c электронный |b визуальный | ||
| 283 | |a online_resource |2 RDAcarrier | ||
| 320 | |a References: 9 tit | ||
| 330 | |a The paper analyzes feasibility of the two-frequency eddy current method for measuring the thickness of an electrically conductive wall under significantly varying test and influence parameters of the test object — the lift-off between the eddy current probe and the test object surface, and the electrical conductivity of the material. An analytical solution was used to determine the dependence of the two-frequency signal of the surface eddy current probe on the influence parameters of the test object. The informative parameters used to simultaneously mitigate the effect of the two influence parameters were the amplitude of the added high-frequency voltage to determine the lift-off, the phase of the added low-frequency voltage to determine the wall thickness, and the phase of the added high-frequency voltage to suppress variations in the electrical conductivity of the material. The calculated dependences of the informative parameters on the test and influence parameters were analyzed. The use of nonlinear functions of the inverse transformation of the informative parameter into the test parameter was shown to efficiently mitigate the effect of variations in the lift-off on measurement results. A method to suppress variations in the electrical conductivity of the test object material is proposed. It implies the correction of the phase of the added low-frequency voltage by the correction value calculated from the parameters of the lift-off and wall thickness, and high-frequency phase variation caused by varying the electrical conductivity of the material | ||
| 330 | |a Исследована применимость двухчастотного метода вихретокового контроля толщины электропроводящей стенки в условиях значительных изменений как контролируемого, так и влияющих параметров объекта контроля — зазора между вихретоковым преобразователем и поверхностью объекта контроля и удельной электрической проводимости материала. Для определения зависимости двухчастотного сигнала накладного вихретокового преобразователя от влияющих параметров объекта контроля использовано аналитическое решение. Для одновременной отстройки от двух влияющих параметров объекта контроля предложено использовать в качестве информативных параметров амплитуду вносимого напряжения высокой частоты для определения зазора, фазу вносимого напряжения низкой частоты для определения толщины стенки и фазу вносимого напряжения высокой частоты для отстройки от изменения удельной электрической проводимости материала. Проанализированы полученные расчетным путем зависимости значений информативных параметров от контролируемого и влияющих параметров. Отмечена эффективность использования для отстройки от влияния на результаты контроля изменений зазора нелинейных функций обратного преобразования значений информативных параметров в значение контролируемого параметра. Предложен метод отстройки от изменения удельной электрической проводимости металла объекта контроля, основанный на коррекции фазы вносимого напряжения низкой частоты на величину поправки, определяемой значениями зазора, толщины стенки и изменением фазы высокой частоты, обусловленным изменением удельной электрической проводимости материала | ||
| 336 | |a Текстовый файл | ||
| 461 | 1 | |t Вестник Карагандинского университета. Серия Физика |c Караганда |n КарГУ | |
| 463 | 1 | |t № 1 (109) |v С. 71-79 |d 2023 | |
| 610 | 1 | |a thickness measurement | |
| 610 | 1 | |a surface eddy current probe | |
| 610 | 1 | |a signal hodographs | |
| 610 | 1 | |a stray parameters | |
| 610 | 1 | |a suppression in eddy current testing | |
| 610 | 1 | |a труды учёных ТПУ | |
| 610 | 1 | |a электронный ресурс | |
| 700 | 1 | |a Goldstein (Goldshtein) |b A. E. |c Specialist in the field of non-destructive testing |c Professor of Tomsk Polytechnic University, Doctor of technical sciences |f 1954- |g Aleksandr Efremovich |9 16296 | |
| 701 | 1 | |a Abakumov |b Kh. |g Khamit |f 1996- |c specialist in the field of instrument engineering |c Assistant of assistant of the department Tomsk Polytechnic University |y Tomsk |9 88967 | |
| 801 | 0 | |a RU |b 63413507 |c 20250828 | |
| 856 | 4 | |u https://doi.org/10.31489/2023ph1/71-79 |z https://doi.org/10.31489/2023ph1/71-79 | |
| 942 | |c CF | ||