Dynamics of water droplet impact on a textured heated and tilted surface; International Communications in Heat and Mass Transfer; Vol. 159, pt. C

Dynamics of water droplet impact on a textured heated and tilted surface; International Communications in Heat and Mass Transfer; Vol. 159, pt. C

Bibliografiset tiedot
Parent link:	International Communications in Heat and Mass Transfer.— .— Amsterdam: Elsevier Science Publishing Company Inc. Vol. 159, pt. C.— 2024.— Article number 108189, 15 p.
Yhteisötekijä:	National Research Tomsk Polytechnic University (570)
Muut tekijät:	Voytkova K. A. Kseniya Arturovna, Syrodoy S. V. Semen Vladimirovich, Kostoreva Zh. A. Zhanna Andreevna, Poznakharev A. S. Andrey Sergeevich, Tamashevich Maksim M., Kuznetsov G. V. Geny Vladimirovich, Gutareva N. Yu. Nadezhda Yurievna
Yhteenveto:	Title screen The study reports the experimental results of dynamics of water droplet impact on smooth and rough tilted substrates made of stainless steel with different temperature of the surfaces. The influence of the direction of the texture and the temperature of the surface on the characteristics of droplet impact and sliding was studied. The tilt angle of the substrate was varied over a wide range. The Weber number was 100. It was established that the temperature of the surface did not influence the droplet/surface interaction modes. However, at the tilt angle of the substrate more than 20°, the surface temperature began to have an effect on the characteristics of the droplet sliding. The distance a water droplet travelled on the surface from the moment of contact with the substrate to the moment it came to a complete stop (droplet pinning) increased. The greatest influence of the temperature and tilt angle of the surface was observed when the droplet slid over the substrate in the direction not along but across the scratches. In this case, the distance a water droplet travelled on the surface increased significantly Текстовый файл AM_Agreement
Kieli:	englanti
Julkaistu:	2024
Aiheet:	Wetting Spreading Sessile droplet Pinning Sliding angle Contact angle Tilted surface электронный ресурс труды учёных ТПУ
Linkit:	https://doi.org/10.1016/j.icheatmasstransfer.2024.108189
Aineistotyyppi:	Elektroninen Kirjan osa
KOHA link:	https://koha.lib.tpu.ru/cgi-bin/koha/opac-detail.pl?biblionumber=676889

Samankaltaisia teoksia

Numerical contact line behavior prediction for droplet-wall impact by the modified Hoffman-function-based dynamic contact angle model; International Communications in Heat and Mass Transfer; Vol. 160
Julkaistu: (2025)

Evaporation of binary droplets on heated superamphiphobic surfaces; International Journal of Heat and Mass Transfer; Vol. 240
Julkaistu: (2025)

Dynamic characteristics of water spreading over laser-textured aluminum alloy surfaces; Colloids and Surfaces A: Physicochemical and Engineering Aspects; Vol. 603
Julkaistu: (2020)

Prediction of water droplet behavior on aluminum alloy surfaces modified by nanosecond laser pulses; Surface and Coatings Technology; Vol. 399
Julkaistu: (2020)

Droplet Spreading and Wettability of Abrasive Processed Aluminum Alloy Surfaces; Metals and Materials International; Vol. 26, №1
Julkaistu: (2019)

Droplet state and mechanism of contact line movement on laser-textured aluminum alloy surfaces; Journal of Colloid and Interface Science; Vol. 553
Julkaistu: (2019)

Experimental and numerical studies of evaporation of a sessile water drop on a heated conductive substrate; Interfacial Phenomena and Heat Transfer; Vol. 6, iss. 4
Julkaistu: (2018)

The influence of the drop formation rate at spreading over a microstructured surface on the contact angle; Thermophysics and Aeromechanics; Vol. 25, iss. 2
Julkaistu: (2018)

Unification of the textures formed on aluminum after laser treatment; Applied Surface Science; Vol. 469
Julkaistu: (2019)

Evaporation of colloidal droplets from aluminum–magnesium alloy surfaces after laser-texturing and mechanical processing; Colloids and Surfaces A: Physicochemical and Engineering Aspects; Vol. 628
Julkaistu: (2021)

Heat flux density in the region of droplet contact line on a horizontal surface of a thin heated foil; Thermophysics and Aeromechanics; Vol. 24, iss. 5
Julkaistu: (2017)

Wetting, droplet evaporation and corrosion behavior of various composite and textured materials; Ceramics International; Vol. 50, iss. 11
Julkaistu: (2024)

Hydrophobic–Hydrophilic Properties and Characterization of PIM-1 Films Treated by Elemental Fluorine in Liquid Perfluorodecalin; Polymers; Vol. 14, iss. 23
Julkaistu: (2022)

The influence of microgrooves on the dynamics of drop spreading on textured surfaces; Thermal Science and Engineering Progress; Vol. 56
Julkaistu: (2024)

Evaporation modes of LiBr, CaCl2, LiCl, NaCl aqueous salt solution droplets on aluminum surface; International Journal of Heat and Mass Transfer; Vol. 126, pt. A
Julkaistu: (2018)

Conjugate heat and mass transfer in a binary sessile droplet on a hydrophobic plate: Effects of plate temperature and component composition; International Journal of Heat and Mass Transfer; Vol. 232
Julkaistu: (2024)

Maximum spreading-based method for determining the pre-rebounding sliding length of a water droplet after impact on an inclined superhydrophobic textured surface; International Journal of Multiphase Flow; Vol. 189
Julkaistu: (2025)

Влияние температуры и времени на угол смачивания стеклом монокристалла кремния; Перспективы развития фундаментальных наук; Т. 2 : Химия
Tekijä: Комаров Д. В.
Julkaistu: (2024)

Effects of wall temperature and temperature-dependent viscosity on maximum spreading of water-in-oil emulsion droplet; International Journal of Heat and Mass Transfer; Vol. 185
Julkaistu: (2022)

Conditions for and Characteristics of the Dispersion of Gel Fuel Droplets during Ignition; Applied Sciences; Vol. 13, iss. 2
Julkaistu: (2023)

Dynamic and kinematic characteristics of unsteady motion of a water-in-oil emulsion droplet in collision with a solid heated wall under conditions of convective heat transfer; International Communications in Heat and Mass Transfer; Vol. 137
Julkaistu: (2022)

Interaction between liquid droplets and membrane surfaces; Separation and Purification Technology; Vol. 354, pt. 7
Julkaistu: (2024)

Расчет нагрузочной способности полуобкатной плоскоконической передачи приводов запорной арматуры; Известия Томского политехнического университета [Известия ТПУ]. Инжиниринг георесурсов; Т. 328, № 3
Tekijä: Сызранцев В. Н. Владимир Николаевич
Julkaistu: (2017)

Preparation, Structure, and Properties of Track-Etched Membranes Based on Polylactic Acid; Membranes and Membrane Technologies; Vol. 3, iss. 5
Julkaistu: (2021)

Прецессирующая передача для приводов запорной арматуры нефтегазопроводов и редукторных вставок насосов для добычи тяжелых нефтей; Известия Томского политехнического университета [Известия ТПУ]. Инжиниринг георесурсов; Т. 328, № 2
Tekijä: Сызранцев В. Н. Владимир Николаевич
Julkaistu: (2017)

Расчет устойчивости склонов на участках строительства объектов спортивно-туристического комплекса «Горный воздух» (гора Большевик, г. Южно-Сахалинск); Известия Томского политехнического университета [Известия ТПУ]. Инжиниринг георесурсов; Т. 330, № 4
Tekijä: Ильин В. В. Владимир Вениаминович
Julkaistu: (2019)

Dynamics of electrical conduction field of the sliding current collector; Applied Mechanics and Materials; Vol. 698
Tekijä: Deeva V. S. Vera Stepanovna
Julkaistu: (2015)

Антропогенный фактор в усилении оползневой деятельности в Сахалинской области на примере схода оползня и разрушения инфраструктуры резервуара чистой воды в п. Синегорск; Известия Томского политехнического университета [Известия ТПУ]. Инжиниринг георесурсов; Т. 333, № 7
Julkaistu: (2022)

A simple model of heating and evaporation of droplets on a superhydrophobic surface; International Journal of Heat and Mass Transfer; Vol. 201
Julkaistu: (2023)

Модифицирующий эффект продуктов переработки отходов нефтехимии в процессах смачивания и стабилизации твердофазных частиц; Известия Томского политехнического университета [Известия ТПУ]. Инжиниринг георесурсов; Т. 332, № 12
Tekijä: Дюрягина А. Н. Антонина Николаевна
Julkaistu: (2021)

Совершенствование процесса обработки призабойной зоны скважин путем применения раствора отработанной серной кислоты; Известия Томского политехнического университета [Известия ТПУ]. Инжиниринг георесурсов; Т. 335, № 1
Tekijä: Хабибуллин М. Я. Марат Яхиевич
Julkaistu: (2024)

Heat and Mass Transfer Processes and Evaporation of a Liquid Droplet on a Structured Surface; Energies; Vol. 16, iss. 22
Tekijä: Antonov D. V. Dmitry Vladimirovich
Julkaistu: (2023)

Об изнашивании металлических материалов, нагруженных трением скольжения и электрическим током высокой плотности; Письма о материалах; Т. 4, № 3 (15)
Tekijä: Алеутдинова М. И. Марина Ивановна
Julkaistu: (2014)

Droplet evaporation on a structured surface: The role of near wall vortexes in heat and mass transfer; International Journal of Heat and Mass Transfer; Vol. 148
Julkaistu: (2019)

Wetting of Cu-SiC Composite Material Modified by Nanosecond Laser Radiation and Liquid Spreading over It; Applied Sciences; Vol. 13, iss. 9
Julkaistu: (2023)

Effect of attack angles on droplet impact on textured metal surfaces: Droplet morphisms, surface tilt angles, droplet deformation; Experimental Thermal and Fluid Science; Vol. 150
Tekijä: Voytkova K. A. Kseniya Arturovna
Julkaistu: (2024)

Reconstruction algorithm of spherical image obtained at operating wide-angle optics; Bulletin of the Tomsk Polytechnic University; Vol. 310, № 2
Tekijä: Shakirov I. V.
Julkaistu: (2007)

Heat transfer and fluid flow around starfish-inspired cylinder by immersed boundary-simplified thermal lattice Boltzmann method; Engineering Analysis with Boundary Elements; Vol. 146
Tekijä: Yuan Ma
Julkaistu: (2023)

Energy of Surface Layer Deterioration of Copper-Based Materials under Dry Sliding with High Electric Current Density; AIP Conference Proceedings; Vol. 1783 : Advanced Materials with Hierarchical Structure for New Technologies and Reliable Structures 2016
Julkaistu: (2016)

Influence of joint geometric parameters on operation of cageless roller bearings; Bulletin of the Tomsk Polytechnic University; Vol. 310, № 3
Tekijä: Zhuravlev А. N.
Julkaistu: (2007)