Evaporation of an R114/R21 falling liquid film: Experimental studies and modelling; International Communications in Heat and Mass Transfer; Vol. 151

Bibliografiset tiedot
Parent link:International Communications in Heat and Mass Transfer.— .— Amsterdam: Elsevier Science Publishing Company Inc.
Vol. 151.— 2024.— Article number 107211, 11 p.
Yhteisötekijä: Томский политехнический университет
Muut tekijät: Antonov D. V. Dmitry Vladimirovich, Volodin O. A. Oleg Aleksandrovich, Pecherkin N. I. Nikolay Ivanovich, Pavlenko A. N. Aleksandr Nikolaevich, Sazhin S. S. Sergey Stepanovich
Yhteenveto:Changes in the molar fraction of the volatile component R114 during the evaporation of an R114/R21 refrigerant mixture film falling over a vertical heated cylinder are investigated both experimentally and numerically. Experiments were performed for inlet molar fractions of the volatile component in the range 4 to 16%. When heat was added to the flowing film from the wall, a decrease in the molar fraction of the volatile component in the mixture was observed. The results of experiments are analysed using the one-dimensional (1D) model of multicomponent liquid film heating/evaporation. In that model, the liquid film is assumed to be flat which allows us to use the 1D forms of the heat transfer and component diffusion equations. The analytical solutions to these equations are used at each timestep of the analysis. The analytical solutions to these equations at the end of the previous timestep are used as the initial conditions for the following timestep with adjusted values of the input parameters. This model is shown to be applicable to the analysis of flows at Reynolds numbers (based on the film thickness) less than about 78
Текстовый файл
Kieli:englanti
Julkaistu: 2024
Aiheet:
Linkit:https://doi.org/10.1016/j.icheatmasstransfer.2023.107211
Aineistotyyppi: Elektroninen Kirjan osa
KOHA link:https://koha.lib.tpu.ru/cgi-bin/koha/opac-detail.pl?biblionumber=672709

MARC

LEADER 00000naa0a2200000 4500
001 672709
005 20260727141845.0
014 |2 sici 
090 |a 672709 
100 |a 20240523d2023 k||y0rusy50 ca 
101 1 |a eng  |c rus 
102 |a NL 
135 |a drcn ---uucaa 
181 0 |a a   |b  e  
182 0 |a b 
183 0 |a cr  |2 RDAcarrier 
200 1 |a Evaporation of an R114/R21 falling liquid film: Experimental studies and modelling  |f D. V. Antonov, O. A. Volodin, N. I. Pecherkin [et al.]  |d Испарение пленки падающей жидкости R114 / R21: экспериментальные исследования и моделирование  |z rus 
203 |a Текст  |b визуальный  |c электронный 
283 |a online_resource  |2 RDAcarrier 
320 |a References: p. 10-11 (41 tit.) 
330 |a Changes in the molar fraction of the volatile component R114 during the evaporation of an R114/R21 refrigerant mixture film falling over a vertical heated cylinder are investigated both experimentally and numerically. Experiments were performed for inlet molar fractions of the volatile component in the range 4 to 16%. When heat was added to the flowing film from the wall, a decrease in the molar fraction of the volatile component in the mixture was observed. The results of experiments are analysed using the one-dimensional (1D) model of multicomponent liquid film heating/evaporation. In that model, the liquid film is assumed to be flat which allows us to use the 1D forms of the heat transfer and component diffusion equations. The analytical solutions to these equations are used at each timestep of the analysis. The analytical solutions to these equations at the end of the previous timestep are used as the initial conditions for the following timestep with adjusted values of the input parameters. This model is shown to be applicable to the analysis of flows at Reynolds numbers (based on the film thickness) less than about 78 
336 |a Текстовый файл 
461 1 |c Amsterdam  |n Elsevier Science Publishing Company Inc.  |t International Communications in Heat and Mass Transfer 
463 1 |d 2024  |t Vol. 151  |v Article number 107211, 11 p. 
610 1 |a liquid film 
610 1 |a R114/R21 mixture 
610 1 |a component diffusion 
610 1 |a evaporation 
610 1 |a mathematical model 
610 1 |a труды учёных ТПУ 
610 1 |a электронный ресурс 
701 1 |a Antonov  |b D. V.  |c specialist in the field of heat and power engineering  |c Associate Professor, Research Engineer at Tomsk Polytechnic University, Candidate of Physical and Mathematical Sciences  |f 1996-  |g Dmitry Vladimirovich  |9 22322 
701 1 |a Volodin  |b O. A.  |g Oleg Aleksandrovich 
701 1 |a Pecherkin  |b N. I.  |g Nikolay Ivanovich 
701 1 |a Pavlenko  |b A. N.  |g Aleksandr Nikolaevich 
701 1 |a Sazhin  |b S. S.  |c geophysicist  |c Leading researcher at Tomsk Polytechnic University, PhD in Physics and Mathematics  |f 1949-  |g Sergey Stepanovich  |9 88718 
712 0 2 |a Томский политехнический университет  |c 1991-  |9 26305 
801 0 |a RU  |b 63413507  |c 20240523 
850 |a 63413507 
856 4 |u  https://doi.org/10.1016/j.icheatmasstransfer.2023.107211  |z  https://doi.org/10.1016/j.icheatmasstransfer.2023.107211 
942 |c CR