Influence of roughness on polar and dispersed components of surface free energy and wettability properties of copper and steel surfaces; Surface and Coatings Technology; Vol. 422

Bibliografiset tiedot
Parent link:	Surface and Coatings Technology Vol. 422.— 2021.— [127518, 12 p.]
Yhteisötekijät:	Национальный исследовательский Томский политехнический университет Инженерная школа энергетики Научно-образовательный центр И. Н. Бутакова (НОЦ И. Н. Бутакова), Национальный исследовательский Томский политехнический университет Инженерная школа энергетики Отделение электроэнергетики и электротехники, Национальный исследовательский Томский политехнический университет Инженерная школа новых производственных технологий Отделение материаловедения
Muut tekijät:	Kuznetsov G. V. Geny Vladimirovich, Islamova A. G. Anastasiya Gomilievna, Orlova E. G. Evgeniya Georgievna, Ivashutenko A. S. Alexander Sergeevich, Shanenkov I. I. Ivan Igorevich, Zykov I. Yu. Iliya Yurievich, Feoktistov D. V. Dmitriy Vladimirovich
Yhteenveto:	Title screen The most urgent problems in meso-, micro- and nano-technological productions are controlling wetting of metals and alloys and liquid spreading over engineering surfaces after their hardware abrasive processing. Nowadays, there is a lack in theoretical basis and comprehensive experimental studies to predict the texture formation and change of the functional surface properties (including wetting) of metals and alloys after abrasive processing. In this study, based on the analysis of the three dimensional roughness parameters (amplitude, hybrid and feature) and elemental composition of the near-surface layer, the features of texture formation, changes in the surface free energy and wettability of copper and steel surfaces that are widely used in industry were established after their hardware abrasive processing. The use of abrasive material with an average grit size of up to 100 μm was found to significantly change the surface roughness. The abrasive processing significantly modifies the polar component in the surface free energy, while not influencing its dispersed component. The texture parameters allowing one to control both the growth and decrease of the polar component in the surface free energy were determined. It is shown that the abrasive processing directly influences the wettability properties and allows varying the contact angles in a sufficiently wide range of from 54.0° to 108.2° (for copper surfaces) and from 71.6° to 89.5° (for steel surfaces). Режим доступа: по договору с организацией-держателем ресурса
Kieli:	englanti
Julkaistu:	2021
Aiheet:	электронный ресурс труды учёных ТПУ hardware abrasive processing grit size roughness parameter wetting surface free energy абразивная обработка смачивание свободная энергия поверхности
Linkit:	https://doi.org/10.1016/j.surfcoat.2021.127518
Aineistotyyppi:	Elektroninen Kirjan osa
KOHA link:	https://koha.lib.tpu.ru/cgi-bin/koha/opac-detail.pl?biblionumber=667983