Electromigration in lithium-titanium ferrite ceramics sintered in radiation-thermal mode
| Parent link: | Eurasian Physical Technical Journal Vol. 18, No. 2.— 2021.— [P. 18-22] |
|---|---|
| Autor Corporativo: | Национальный исследовательский Томский политехнический университет Инженерная школа неразрушающего контроля и безопасности Отделение контроля и диагностики |
| Otros Autores: | Surzhikov A. P. Anatoly Petrovich, Malyshev A. V. Andrei Vladimirovich, Lysenko E. N. Elena Nikolaevna, Sheveleva E. A. Elena Aleksandrovna, Stary O. Oldrich, Gyngazov A. S. Aleksandr Sergeevich |
| Sumario: | Title screen The study investigates electro-migration in Li–Ti ferrite ceramic samples sintered in radiation-thermal mode. To reveal radiation effects, similar measurements are performed for samples sintered in thermal mode. The effect of the state of grain boundaries and the presence of a low-melting additive on electrical properties of sintered ferrites is studied. It is found that structural rearrangement during radiation-thermal sintering occurs in early sintering stages, including the heating period. Study demonstrates that such behavior associated with radiation-induced intensification of the liquid phase spreading over the array of powder grains. In addition, it was shown that structural transformation may be caused by stimulation of intergranular slippage. |
| Lenguaje: | inglés |
| Publicado: |
2021
|
| Materias: | |
| Acceso en línea: | https://doi.org/10.31489/2021No2/18-22 |
| Formato: | Electrónico Capítulo de libro |
| KOHA link: | https://koha.lib.tpu.ru/cgi-bin/koha/opac-detail.pl?biblionumber=666049 |
Ejemplares similares
The influence of ZrO2 additive on sintering and microstructure of lithium and lithium-titanium-zinc ferrites
Publicado: (2018)
Publicado: (2018)
Dilatometric analysis of sintering lithium-titanium-zinc ferrite with ZrO2 additive
Publicado: (2021)
Publicado: (2021)
Structural and electromagnetic properties of 3D printed and electron beam sintered lithium ferrite ceramic
Publicado: (2024)
Publicado: (2024)
Temperature dependences of the initial permeability of lithium-titanium ferrites produced by solid-state sintering in thermal and radiation-thermal modes
Publicado: (2022)
Publicado: (2022)
Effect of Normalizing Heating of Ferrite Compacts on Compaction during Radiation-Thermal Sintering
Publicado: (2021)
Publicado: (2021)
Effect of sintering regimes on the microstructure and magnetic properties of LiTiZn ferrite ceramics
Publicado: (2018)
Publicado: (2018)
Relationship between magnetic properties and microstructure of ferrites during sintering in radiation and radiation-thermal conditions
Publicado: (2021)
Publicado: (2021)
Effect of Sm2O3 additive on the microstructure, magnetic and electrical properties of LiTiZn ferrite ceramics
por: Malyshev A. V. Andrei Vladimirovich
Publicado: (2024)
por: Malyshev A. V. Andrei Vladimirovich
Publicado: (2024)
Phase transformations in ferrites during radiation-thermal sintering
Publicado: (2020)
Publicado: (2020)
Structural and magnetic properties of lithium-substituted ferrite ceramics sintered by continuous electron beam heating
Publicado: (2020)
Publicado: (2020)
Effect of compressive mechanical stress on the magnetic properties of LiTiZn ferrite ceramics
por: Malyshev A. V. Andrei Vladimirovich
Publicado: (2020)
por: Malyshev A. V. Andrei Vladimirovich
Publicado: (2020)
XRD Analysis of Ferrite Ceramics with Different Heat Treatment
Publicado: (2019)
Publicado: (2019)
Microstructure and electromagnetic properties of LiFe5O8 ferrite ceramics prepared from wet- and dry-milled powders
Publicado: (2021)
Publicado: (2021)
Formation of Microstructure of Lithium-Titanium Ferrite during its Synthesis in a 2.4 MeV Electron Beam
Publicado: (2020)
Publicado: (2020)
Technological Aspects of Lithium-Titanium Ferrite Synthesis by Electron-Beam Heating
Publicado: (2023)
Publicado: (2023)
Formation of magnetic properties of ferrites during radiation-thermal sintering
Publicado: (2020)
Publicado: (2020)
Microstructure Formation of LiTiZn Ferrite Ceramics during Radiation-Thermal Sintering
Publicado: (2019)
Publicado: (2019)
Investigation of kinetics of lithium ferrite formation under electron beam treatment
por: Lysenko E. N. Elena Nikolaevna
Publicado: (2020)
por: Lysenko E. N. Elena Nikolaevna
Publicado: (2020)
Study of the initial magnetic permeability of LiTiZnMn ferrites obtained by liquid-phase sintering under radiation-thermal and thermal conditions
por: Surzhikov A. P. Anatoly Petrovich
Publicado: (2022)
por: Surzhikov A. P. Anatoly Petrovich
Publicado: (2022)
In situ synthesis of a binary Ti–10at% Nb alloy by electron beam melting using a mixture of elemental niobium and titanium powders
Publicado: (2020)
Publicado: (2020)
Positron annihilation spectroscopy of vacancy-type defects hierarchy in submicrocrystalline nickel during annealing
Publicado: (2014)
Publicado: (2014)
Technological scheme for lithium-substituted ferrite production under complex high-energy impact
Publicado: (2020)
Publicado: (2020)
Electrical and magnetic properties of ZrO2-doped lithium-titanium-zinc ferrite ceramics
Publicado: (2019)
Publicado: (2019)
Thermal analysis of sintering Li–Ti–Zn ferrite from mechanically activated powders
Publicado: (2023)
Publicado: (2023)
Effect of Heat Input on the Microstructure and Phase Composition of Additively Manufactured Ti–6Al–4V Alloy
por: Kamelina K. D. Kristina Dmitrievna
Publicado: (2024)
por: Kamelina K. D. Kristina Dmitrievna
Publicado: (2024)
Structure Evolution and Distributions of Grain-Boundary Misorientainons in Submicrocrystalline Molybdenum Irradiated with a Pulsed Electron Beam
Publicado: (2018)
Publicado: (2018)
Влияние исходного состояния низкоуглеродистых сталей на структуру и механические свойства, формируемые при равноканальном угловом прессовании
Publicado: (2014)
Publicado: (2014)
Analysis of the applicability of physical models to describe densification of lithium ferrite compacts during sintering in the field of intense electron beam
Publicado: (2020)
Publicado: (2020)
Thermal Analysis of Processes at the Solid-Phase Synthesis of Lithium-Titanium Ferrite
por: Nikolaev E. V. Evgeny Vladimirovich
Publicado: (2021)
por: Nikolaev E. V. Evgeny Vladimirovich
Publicado: (2021)
Effect of ZrO2 Additive on the Morphology of Lithium Ferrite
por: Nikolaeva S. A. Svetlana Andreevna
Publicado: (2019)
por: Nikolaeva S. A. Svetlana Andreevna
Publicado: (2019)
Kinetic analysis of lithium–titanium ferrite formation from mechanically milled reagents
Publicado: (2020)
Publicado: (2020)
Anomalies of dielectric properties in a lithium-titanium ferrite ceramic
por: Malyshev A. V. Andrei Vladimirovich
Publicado: (2012)
por: Malyshev A. V. Andrei Vladimirovich
Publicado: (2012)
Interaction of lithium-titanium ceramics with air during sintering
Publicado: (2007)
Publicado: (2007)
Structural and Electromagnetic Properties of Lithium Ferrite Manufactured by Extrusion Printing
Publicado: (2024)
Publicado: (2024)
Influence of solid-phase ferritization method on phase composition of lithium-zinc ferrites with various concentration of zinc
Publicado: (2012)
Publicado: (2012)
Effect of additives on sintering of zirconia ceramics
por: Gyngazov (Ghyngazov) S. A. Sergey Anatolievich
Publicado: (2018)
por: Gyngazov (Ghyngazov) S. A. Sergey Anatolievich
Publicado: (2018)
Thermomagnetometric analysis of lithium ferrites
por: Astafyev A. L. Alexander Leonidovich
Publicado: (2019)
por: Astafyev A. L. Alexander Leonidovich
Publicado: (2019)
Solid-state synthesis of lithium-zinc ferrites by a high-energy electron beam heating
Publicado: (2012)
Publicado: (2012)
Three-Component Composite Based on Ultra-High Molecular Weight Polyethylene for Additive Manufacturing
Publicado: (2020)
Publicado: (2020)
The Influence of Modification on Crystal Lattice Stability of Austenite in Stainless Steel
Publicado: (2018)
Publicado: (2018)
Ejemplares similares
-
The influence of ZrO2 additive on sintering and microstructure of lithium and lithium-titanium-zinc ferrites
Publicado: (2018) -
Dilatometric analysis of sintering lithium-titanium-zinc ferrite with ZrO2 additive
Publicado: (2021) -
Structural and electromagnetic properties of 3D printed and electron beam sintered lithium ferrite ceramic
Publicado: (2024) -
Temperature dependences of the initial permeability of lithium-titanium ferrites produced by solid-state sintering in thermal and radiation-thermal modes
Publicado: (2022) -
Effect of Normalizing Heating of Ferrite Compacts on Compaction during Radiation-Thermal Sintering
Publicado: (2021)