Fabrication of NO-containing calcium phosphate coatings via direct introduction of argon-nitrogen-mixtures applied in reactive RF-magnetron sputtering; Journal of Physics: Conference Series; Vol. 1954 : Films and Coatings (ICFC 2021)

Fabrication of NO-containing calcium phosphate coatings via direct introduction of argon-nitrogen-mixtures applied in reactive RF-magnetron sputtering; Journal of Physics: Conference Series; Vol. 1954 : Films and Coatings (ICFC 2021)

التفاصيل البيبلوغرافية
Parent link:	Journal of Physics: Conference Series Vol. 1954 : Films and Coatings (ICFC 2021).— 2021.— [012007, 4 p.]
مؤلف مشترك:	Национальный исследовательский Томский политехнический университет Инженерная школа ядерных технологий Научно-образовательный центр Б. П. Вейнберга
مؤلفون آخرون:	Fedotkin A. Yu. Aleksandr Yurjevich, Marjin (Maryin) P. V. Pavel Vladimirovich, Miklashevich L. A. Lenid Andreevich, Tverdokhlebov S. I. Sergei Ivanovich
الملخص:	Title screen Nitric oxide plays a crucial role in the human body, due to its regulatory effect on vascular tone, cell adhesion, vascular permeability, etc. The introduction of nitric oxide into calcium phosphate coatings can increase the bioactivity significantly. This article proves the possibility of deposition of nitric oxide-containing calcium phosphate coatings on titanium substrates. Therefore, various argon-nitrogen working gas mixtures were used in reactive radiofrequency magnetron sputtering of hydroxyapatite. The amount of nitric oxide increases with the concentration of nitrogen in the working gas mixture. Coatings characterized by a higher deposition rate of nitric oxide are showing also a higher roughness of the surface. Due to the adjustment of these deposition parameters, the morphology of the coating surfaces can be regulated.
اللغة:	الإنجليزية
منشور في:	2021
الموضوعات:	электронный ресурс труды учёных ТПУ кальций-фосфатные покрытия смеси аргон азот ВЧ-магнетронное распыление биосовместимость металлические имплантаты легирующие примеси физико-химические свойства благородные газы
الوصول للمادة أونلاين:	https://doi.org/10.1088/1742-6596/1954/1/012008
التنسيق:	الكتروني فصل الكتاب
KOHA link:	https://koha.lib.tpu.ru/cgi-bin/koha/opac-detail.pl?biblionumber=665370

مواد مشابهة

Properties of CaP coatings produced by reactive RF-magnetron sputtering in a mixture of nitrogen and noble gases; Journal of Physics: Conference Series; Vol. 1954 : Films and Coatings (ICFC 2021)
حسب: Fedotkin A. Yu. Aleksandr Yurjevich
منشور في: (2021)

Calcium-phosphate coating on AZ91d magnesium alloy prepared via RF magnetron sputtering; Перспективы развития фундаментальных наук
حسب: Мухаметкалиев Т. М. Тимур Мухамедрашидович
منشور في: (2015)

Pulsed electron beam propagation in argon and nitrogen gas mixture; Physics of Plasmas; Vol. 22
منشور في: (2015)

Thin calcium-phosphate coatings produced by RF Magnetron sputtering and prospects for their use in biomedical engineering; Biomedical Engineering; Vol. 42, iss. 3
منشور في: (2008)

The preparation of calcium phosphate coatings on titanium and nickel-titanium by rf-magnetron-sputtered deposition: Composition, structure and micromechanical properties; Surface and Coatings Technology; Vol. 202, iss. 16
منشور في: (2008)

Thin hydroxyapatite coating on AZ91D magnesium alloy fabricated via RF-magnetron sputtering; Физико-технические проблемы в науке, промышленности и медицине
حسب: Melnikov E. S. Evgenii Sergeevich
منشور في: (2015)

Обнаружение фотопроводимости в сверхтонких металлических пленках в видимой инфракрасной областях спектра; Журнал экспериментальной и теоретической физики; Т. 123, вып. 5
منشور في: (2003)

Electrical Potential and Topography of the Surface of a Calcium-Phosphate Coating Deposited with RF-Magnetron Discharge; Journal of Surface Investigation. X-ray, Synchrotron and Neutron Techniques; Vol. 14, iss. 1
منشور في: (2020)

Phase and elemental composition of silicon-containing hydroxyapatite-based coatings fabricated by RF-magnetron sputtering for medical implants; Inorganic Materials: Applied Research; Vol. 4, iss. 3
منشور في: (2013)

Investigation of the morphology and elemental composition of the silicon-containing calcium phosphate coating treated by intensive pulsed electron beam; The 9th International Forum on on Strategic Techology (IFOST-2014), September 21-23, 2014, Cox's Bazar, Bangladesh
منشور في: (2014)

Glancing Angle Deposition of Zn-Doped Calcium Phosphate Coatings by RF Magnetron Sputtering; Coatings; Vol. 9, iss. 4
منشور في: (2019)

Modification of surface pyrolytic graphite by nitrogen and argon plasma on air; Energy Fluxes and Radiation Effects (EFRE-2016)
منشور في: (2016)

Modification of surface Ti-fiber by air, nitrogen and argon plasma on air; Energy Fluxes and Radiation Effects (EFRE-2016)
منشور في: (2016)

Antibacterial potential of Zn- and Cu-substituted hydroxyapatite-based coatings deposited by RF-magnetron sputtering; Journal of Physics: Conference Series; Vol. 1393 : Gas Discharge Plasmas and Their Applications (GDP 2019)
منشور في: (2019)

Antibacterial Calcium Phosphate Coatings for Biomedical Applications Fabricated via Micro-Arc Oxidation; Biomimetics; Vol. 8, iss. 5
منشور في: (2023)

Physical-Mechanical Characteristics of RF Magnetron Sputter-Deposited Coatings Based on Silver-Doped Hydroxyapatite; Russian Physics Journal; Vol. 56, iss. 10
منشور في: (2014)

A review of plasma-assisted methods for calcium phosphate-based coatings fabrication; Surface and Coatings Technology; Vol. 206, iss. 8-9
حسب: Surmenev R. A. Roman Anatolievich
منشور في: (2012)

Effect of argon and nitrogen mixing ratios on the properties of the coatings deposited via reactive magnetron sputtering of a hydroxyapatite target; Applied Surface Science; Vol. 726
منشور في: (2026)

The release of nickel from nickel-titanium (NiTi) is strongly reduced by a sub-micrometer thin layer of calcium phosphate deposited by rf-magnetron sputtering; Journal of Materials Science: Materials in Medicine; Vol. 21, iss. 4
منشور في: (2010)

Properties of tantalum powders in argon and helium atmospheres; Химия и химическая технология в XXI веке
حسب: Baryshnikov A. A. Arseny Alexandrovich
منشور في: (2020)

The influence of the deposition parameters on the properties of an rf-magnetron-deposited nanostructured calcium phosphate coating and a possible growth mechanism; Surface and Coatings Technology; Vol. 205, iss. 12
منشور في: (2011)

Formation of bioactive coatings by radio frequency magnetron sputtering using various calcium phosphate targets and working gases; Journal of Physics: Conference Series; Vol. 1281 : 14th InternationalConference on Films and Coatings (ICFC14)
حسب: Fedotkin A. Yu. Aleksandr Yurjevich
منشور في: (2019)

Mechanical Behavior of the Titania Nanotubes and Hydroxyapatite Coating Prepared On the Surface of Titanium; 11th International Forum on Strategic Technology (IFOST 2016); Pt. 1
منشور في: (2016)

RF-magnetron sputter deposited hydroxyapatite-based composite & multilayer coatings: A systematic review from mechanical, corrosion, and biological points of view; Ceramics International; Vol. 47, iss. 3
منشور في: (2021)

RF magnetron-sputtered coatings deposited from biphasic calcium phosphate targets for biomedical implant applications; Bioactive Materials; Vol. 2, iss. 3
منشور في: (2017)

Effect of pulsed electron beam treatment on the physico-mechanical properties of hydroxyapatite-coated titanium; Ceramics International; Vol. 42, iss. 1, pt. B
منشور في: (2016)

Investigation of physical and mechanical properties of biocompatible coatings based on silver-hydroxyapatite deposited by radio-frequency magnetron sputtering; Перспективы развития фундаментальных наук
حسب: Syromotina D. S.
منشور في: (2013)

Modification of the cylindrical products outer surface influenced by radial beam of argon ions at automatic mode; Journal of Physics: Conference Series; Vol. 652 : Gas Discharge Plasmas and Their Applications (GDP 2015)
منشور في: (2015)

Determination of magnetron plasma parameters by optical emission spectroscopy and argon collisional-radiative model; Energy Fluxes and Radiation Effects (EFRE-2016)
منشور في: (2016)

The effect of Si content on structure and mechanical features of silicon-containing calcium phosphorus-based films deposited by rf-magnetron sputtering on titanium substrate treated by pulsed electron beam; The 9th International Forum on Strategic Techology (IFOST-2014), September 21-23, 2014, Cox's Bazar, Bangladesh
منشور في: (2014)

Physical principles of radio-frequency magnetron sputter deposition of calcium-phosphate-based coating with tailored properties; Surface and Coatings Technology; Vol. 413
منشور في: (2021)

Wettability of Thin Silicate-Containing Hydroxyapatite Films Formed by RF-Magnetron Sputtering; Russian Physics Journal; Vol. 56, iss. 10
منشور في: (2014)

Modification of titanium surface via Ag-, Sr- and Si-containing micro-arc calcium phosphate coating; Bioactive Materials; Vol. 4
منشور في: (2019)

The structure of biocoats based on TiO2 doped with nitrogen study; IOP Conference Series: Materials Science and Engineering; Vol. 347 : New Materials
حسب: Boytsova E. L. Elena Lvovna
منشور في: (2018)

Influence of the substrate bias on the stoichiometry and structure of RF-magnetron sputter-deposited silver-containing calcium phosphate coatings; Materialwissenschaft und Werkstofftechnik; Vol. 44, iss. 2-3
منشور في: (2013)

Erratum to: Wettability of Thin Silicate-Containing Hydroxyapatite Films formed by RF-Magnetron Sputtering; Russian Physics Journal; Vol. 56, iss. 11
منشور في: (2014)

Hybrid Calcium Phosphate Coatings for Titanium Implants; Journal of Physics: Conference Series; Vol. 789 : Low temperature Plasma in the Processes of Functional Coating Preparation
منشور في: (2017)

Металлургические ВЧ-плазмотроны. Электро- и газодинамика
حسب: Рыкалин Н. Н. Николай Николаевич
منشور في: (Москва, Наука, 1987)

Determination of the Electron Density and Electron Temperature in A Magnetron Discharge Plasma Using Optical Spectroscopy and the Collisional-Radiative Model of Argon; Russian Physics Journal; Vol. 60, iss. 5
منشور في: (2017)

Magnetron Deposition of Cr Coatings with RF-ICP Assistance; Coatings; Vol. 12, iss. 10
منشور في: (2022)