Experimental research and numerical simulation of gel fuel ignition by a hot particle; Fuel; Vol. 291
| Parent link: | Fuel Vol. 291.— 2021.— [120172, 16 p.] |
|---|---|
| Corporate Authors: | Национальный исследовательский Томский политехнический университет Инженерная школа энергетики Научно-образовательный центр И. Н. Бутакова (НОЦ И. Н. Бутакова), Национальный исследовательский Томский политехнический университет Исследовательская школа физики высокоэнергетических процессов |
| Other Authors: | Glushkov D. O. Dmitry Olegovich, Kosintsev A. G. Andrey Georgievich, Kuznetsov G. V. Geny Vladimirovich, Vysokomorny (Vysokomorniy) V. S. Vladimir Sergeevich |
| Summary: | Title screen The research investigates interdependent physical and chemical processes, occurring when a typical gel fuel is ignited by a hot particle. In the conducted experiments, high-speed video recording made it possible to establish the consistent patterns and characteristics of the ignition of gel fuel, based on an organic polymer thickener, by a disc-shaped steel particle 5 mm in radius and height. The fuel ignition delay times are 0.5–2.5 s when the initial temperature of the steel particle is varied from 1230 to 1500 K. A mathematical model of the investigated process was developed using experimental data obtained. It describes the interdependent processes of conductive heating and melting of gel fuel, melt evaporation, cooldown of the particle and its gradual immersion in the near-surface layer of the fuel, formation of a combustible gas–vapor mixture around the local heating source and its ignition under the conditions of diffusion-convective heat and mass transfer. The numerical simulation results are in good agreement with the experimental data. The developed mathematical model can be used in practice to predict the characteristics of gel fuel ignition by hot particles, when a group of factors in the particle – fuel – air system is varied in wide ranges. Режим доступа: по договору с организацией-держателем ресурса |
| Language: | English |
| Published: |
2021
|
| Subjects: | |
| Online Access: | https://doi.org/10.1016/j.fuel.2021.120172 |
| Format: | Electronic Book Chapter |
| KOHA link: | https://koha.lib.tpu.ru/cgi-bin/koha/opac-detail.pl?biblionumber=663666 |
Similar Items
Critical Conditions for the Ignition of a Gel Fuel under Different Heating Schemes; Energies; Vol. 14, iss. 21
by: Gaydukova O. S. Olga Sergeevna
Published: (2021)
by: Gaydukova O. S. Olga Sergeevna
Published: (2021)
Numerical simulation of solid-phase ignition of metallized condensed matter by a particle heated to a high temperature; Russian Journal of Physical Chemistry B; Vol. 5, iss. 6
by: Glushkov D. O. Dmitry Olegovich
Published: (2011)
by: Glushkov D. O. Dmitry Olegovich
Published: (2011)
The effect of ceramic surface structure modification method on the ignition and combustion behavior of non-metallized and metallized gel fuel particles exposed to conductive heating; Fuel; Vol. 330
Published: (2022)
Published: (2022)
Numerical simulation of gel fuel gas-phase ignition by a local source of limited heat content; Acta Astronautica; Vol. 163
Published: (2019)
Published: (2019)
Influence of heating intensity and size of gel fuel droplets on ignition characteristics; International Journal of Heat and Mass Transfer; Vol. 156
by: Glushkov D. O. Dmitry Olegovich
Published: (2020)
by: Glushkov D. O. Dmitry Olegovich
Published: (2020)
Ignition and combustion behavior of gel fuel particles with metal and non-metal additives; Acta Astronautica; Vol. 202
Published: (2023)
Published: (2023)
Numerical simulation of ignition of a typical gel fuel particle, based on organic polymer thickener, in a high-temperature air medium; Acta Astronautica; Vol. 178
Published: (2021)
Published: (2021)
Characteristics of micro-explosive dispersion of gel fuel particles ignited in a high-temperature air medium; Fuel; Vol. 313
Published: (2022)
Published: (2022)
Gel fuels based on oil-filled cryogels: Corrosion of tank material and spontaneous ignition; Chemical Engineering Journal; Vol. 421, pt. 2
Published: (2021)
Published: (2021)
Ignition of bio-water-coal fuel drops; Energy; Vol. 203
Published: (2020)
Published: (2020)
Ignition mechanism and characteristics of gel fuels based on oil-free and oil-filled cryogels with fine coal particles; Powder Technology; Vol. 360
Published: (2020)
Published: (2020)
Mathematical Model of the Ignition of a Gel Fuel Particle in a High-Temperature Air Medium; Russian Journal of Physical Chemistry B; Vol. 17, iss. 1
by: Glushkov D. O. Dmitry Olegovich
Published: (2023)
by: Glushkov D. O. Dmitry Olegovich
Published: (2023)
Alternative Fuels for Compression Ignition Engines
Published: (2018)
Published: (2018)
Influence of gellant and drag-reducing agent on the ignition characteristics of typical liquid hydrocarbon fuels; Acta Astronautica; Vol. 177
Published: (2020)
Published: (2020)
Physical and Statistical Models for Steam Generator Clogging Diagnosis
by: Girard, Sylvain
Published: (2014)
by: Girard, Sylvain
Published: (2014)
The gel fuel ignition at local conductive heating; International Journal of Heat and Mass Transfer; Vol. 127, pt. C
by: Glushkov D. O. Dmitry Olegovich
Published: (2018)
by: Glushkov D. O. Dmitry Olegovich
Published: (2018)
Numerical research of heat and mass transfer during low-temperature ignition of a coal particle; Thermal Science; Vol. 19, iss. 1
by: Glushkov D. O. Dmitry Olegovich
Published: (2015)
by: Glushkov D. O. Dmitry Olegovich
Published: (2015)
Characteristics and conditions for ignition of bio-coal mixtures based on coal and forest combustible material; Journal of the Energy Institute; Vol. 93, iss. 5
Published: (2020)
Published: (2020)
Mathematical Simulation of Heat and Mass Transfer During Forest Fuel Pyrolysis Caused by High Temperature from Crown Forest Fire; International Review on Modelling and Simulations (IREMOS); Vol. 13, № 4
by: Baranovskiy N. V. Nikolay Viktorovich
Published: (2020)
by: Baranovskiy N. V. Nikolay Viktorovich
Published: (2020)
Influence of platelet content on the fabrication of colloidal gels for robocasting: Experimental analysis and numerical simulation; Journal of the European Ceramic Society; Vol. 40, iss. 3
Published: (2020)
Published: (2020)
Performance improvement of magnesium-based hydrogen storage tanks by using carbon nanotubes addition and finned heat exchanger: Numerical simulation and experimental verification; International Journal of Hydrogen Energy; Vol. 92
Published: (2024)
Published: (2024)
Ignition of the wood biomass particles under conditions of near-surface fragmentation of the fuel layer; Fuel; Vol. 252
Published: (2019)
Published: (2019)
Alternative Fuels in Ship Power Plants Application of Alternative Fuels /
by: Yang, Xinglin, et al.
Published: (2021)
by: Yang, Xinglin, et al.
Published: (2021)
Influence of filtration heat transfer on parameters and conditions for ignition of coal-water fuel particles; Thermophysics and Aeromechanics; Vol. 26, iss. 5
by: Syrodoy S. V. Semen Vladimirovich
Published: (2020)
by: Syrodoy S. V. Semen Vladimirovich
Published: (2020)
Fuel Cell Fundamentals and Applications
by: Li, Yinshi
Published: (2025)
by: Li, Yinshi
Published: (2025)
Mathematical modeling of energy effective ignition of gel-like fuel at local heating; Mechanical Engineering, Automation and Control Systems (MEACS)
by: Glushkov D. O. Dmitry Olegovich
Published: (2014)
by: Glushkov D. O. Dmitry Olegovich
Published: (2014)
Solid Oxide Fuels Cells: Facts and Figures Past Present and Future Perspectives for SOFC Technologies /
Published: (2013)
Published: (2013)
Fundamentals of Thermal Radiation for Energy Utilization in Fuel Combustion
by: Shan, Shiquan, et al.
Published: (2023)
by: Shan, Shiquan, et al.
Published: (2023)
Experimental investigation of the gel fuel combustion process initial by the hot particle; International Conference on Combustion Physics and Chemistry
by: Nigay A. G. Aleksandr Gerasimovich
Published: (2018)
by: Nigay A. G. Aleksandr Gerasimovich
Published: (2018)
Control of Fuel Combustion in Boilers
by: Zaporozhets, Artur O.
Published: (2020)
by: Zaporozhets, Artur O.
Published: (2020)
Conduction, convection, and radiation in a closed cavity with a local radiant heater; Frontiers in Heat and Mass Transfer (FHMT); Vol. 10, iss. 26
by: Kuznetsov G. V. Geny Vladimirovich
Published: (2018)
by: Kuznetsov G. V. Geny Vladimirovich
Published: (2018)
Formation of Regulational Thermal Regimes in an Industrial Room with a Radiant Heating System and Air Exchange; Journal of Engineering Physics and Thermophysics; Vol. 96, iss. 7
Published: (2023)
Published: (2023)
Mathematical Simulation of the Heat and Mass Transfer in the Movement of Liquid Droplets in a Gas Medium Under the Conditions of their Intense Phase Transformations; Journal of Engineering Physics and Thermophysics; Vol. 93, iss. 5
by: Antonov D. V. Dmitry Vladimirovich
Published: (2020)
by: Antonov D. V. Dmitry Vladimirovich
Published: (2020)
A Mathematical Model of Industrial Waste-Derived Fuel Droplet Combustion in High-Temperature Air; Applied Sciences; Vol. 12, iss. 23
Published: (2022)
Published: (2022)
Волновое течение испаряющейся пленки жидкости; Известия Томского политехнического университета [Известия ТПУ]; Т. 324, № 4 : Техника и технологии в энергетике
by: Актершев С. П. Сергей Петрович
Published: (2014)
by: Актершев С. П. Сергей Петрович
Published: (2014)
Oxygen-Carrier-Aided Combustion Technology for Solid-Fuel Conversion in Fluidized Bed
by: Duan, Lunbo, et al.
Published: (2023)
by: Duan, Lunbo, et al.
Published: (2023)
Non-stationary spatial heat transfer in a heterogeneous claydite-concrete wall; Bulletin of the Tomsk Polytechnic University; Vol. 309, № 4
Published: (2006)
Published: (2006)
Anion Exchange Membrane Fuel Cells Principles, Materials and Systems /
Published: (2018)
Published: (2018)
Свободно-конвективный теплоперенос в отапливаемых с использованием газовых инфракрасных излучателей производственных помещениях; Известия вузов. Проблемы энергетики; № 1-2
Published: (2013)
Published: (2013)
Features of the Mechanism of Gas-phase Ignition of Wood Biomass Particles; Combustion Science and Technology; Vol. XX
Published: (2024)
Published: (2024)
Similar Items
-
Critical Conditions for the Ignition of a Gel Fuel under Different Heating Schemes; Energies; Vol. 14, iss. 21
by: Gaydukova O. S. Olga Sergeevna
Published: (2021) -
Numerical simulation of solid-phase ignition of metallized condensed matter by a particle heated to a high temperature; Russian Journal of Physical Chemistry B; Vol. 5, iss. 6
by: Glushkov D. O. Dmitry Olegovich
Published: (2011) -
The effect of ceramic surface structure modification method on the ignition and combustion behavior of non-metallized and metallized gel fuel particles exposed to conductive heating; Fuel; Vol. 330
Published: (2022) -
Numerical simulation of gel fuel gas-phase ignition by a local source of limited heat content; Acta Astronautica; Vol. 163
Published: (2019) -
Influence of heating intensity and size of gel fuel droplets on ignition characteristics; International Journal of Heat and Mass Transfer; Vol. 156
by: Glushkov D. O. Dmitry Olegovich
Published: (2020)