Evaluating the Quality of Reinforced Concrete Electric Railway Poles by Thermal Nondestructive Testing

Evaluating the Quality of Reinforced Concrete Electric Railway Poles by Thermal Nondestructive Testing

Xehetasun bibliografikoak
Parent link:	Applied Sciences Vol. 8, iss. 2.— 2018.— [222,13 p.]
Egile korporatiboa:	Национальный исследовательский Томский политехнический университет Инженерная школа неразрушающего контроля и безопасности Центр промышленной томографии Научно-производственная лаборатория "Тепловой контроль", Национальный исследовательский Томский политехнический университет Школа базовой инженерной подготовки Отделение иностранных языков
Beste egile batzuk:	Sannikov D. V. Dmitry Valerievich, Kolevatov A. S. Aleksandr Sergeevich, Vavilov V. P. Vladimir Platonovich, Kuimova M. V. Marina Valerievna
Gaia:	Title screen Thermal nondestructive testing can be used to inspect reinforced concrete supports that are widely used in various industries. Corrosion damage is a typical defect found in these supports. Corrosion usually starts as a separation between the concrete and the steel rebar. Damage is exacerbated by pressure that is caused by the formation of corrosion products. The most logical method for using IR to detect corrosion or a disbond would be to heat up the rebar by resistive or inductive heating. In both cases, monitoring the dynamic temperature distributions on the pole allows for the evaluation of reinforcement quality. The thermal properties of steel, concrete, air, and corrosion products differ greatly. The magnitude of temperature anomalies and their behavior over time depend on the presence of corrosion products, air gaps, and the quality of contact between rebar and concrete.
Hizkuntza:	ingelesa
Argitaratua:	2018
Gaiak:	электронный ресурс труды учёных ТПУ тепловые испытания нагрев численное моделирование
Sarrera elektronikoa:	http://earchive.tpu.ru/handle/11683/64941 https://doi.org/10.3390/app8020222
Formatua:	Baliabide elektronikoa Liburu kapitulua
KOHA link:	https://koha.lib.tpu.ru/cgi-bin/koha/opac-detail.pl?biblionumber=659672

Antzeko izenburuak

Evaluating damage to reinforced concrete during mechanical compression and bending tests
Argitaratua: (2017)

The influence of climatic tests on the parameters of the electric signal glass fiber reinforced concrete
nork: Korzenok I. N.
Argitaratua: (2015)

Evaluation of Operational Properties of Composite Reinforcement Used in Concrete Structures
nork: Rodevich V. V.
Argitaratua: (2014)

Evaluation of freeze-thaw damage to reinforced concrete based on the parameters of electric response to mechanical impact
nork: Fursa T. V. Tatyana Viktorovna
Argitaratua: (2017)

Nondestructive Testing
nork: McGonnagle W. Warren J.
Argitaratua: (New York, McGRAW-Hill book company inc., 1961)

Modelling, detecting and evaluating water ingress in aviation honeycomb panels
Argitaratua: (2017)

Introduction to Nondestructive Testing
nork: Mix P. E. Paul E.
Argitaratua: (New Jersey, Wiley-Interscience, 2005)

Infrared Thermography and Thermal Nondestructive Testing
nork: Vavilov V. P. Vladimir Platonovich
Argitaratua: (Cham, Springer, 2020)

Influence of concrete-reinforcement bond quality on the process of fracture due to uniaxial compression. Fracture detection
Argitaratua: (2018)

Developing an Integrated Technique to Evaluate Crack Formation in Reinforced Concrete under Uniaxial Compression
Argitaratua: (2017)

Electrical Disintegration of Reinforced Concrete: Experiment and Simulation
Argitaratua: (2025)

An apparatus for the active thermal testing of corrosion in steel cylindrical containers and test results
Argitaratua: (2013)

Diagnostics of Fibre-Reinforced Concrete by the Nondestructive Method Based on Mechanoelectric Transformations Phenomenon
nork: Petrov M. V. Maksim Vyacheslavovich
Argitaratua: (2019)

Nondestructive Testing for Defects and Damage to Structures in Reinforced Concrete Foundations Using Standard G.652 Optical Fibers
Argitaratua: (2020)

Active Thermal Testing of Delaminations in Heat-Shielding Structures
nork: Chulkov A. O. Arseniy Olegovich
Argitaratua: (2019)

Electromagnetic Nondestructive Method of Testing the Runway Quality
nork: Fursa T. V. Tatyana Viktorovna
Argitaratua: (2003)

Thermal (infrared) tomography: Terminology, principal procedures, and application to nondestructive testing of composite materials
Argitaratua: (2010)

Detecting degradation in reinforced concrete subjected to uniaxial compression, using the parameters of electric response to mechanical impact
Argitaratua: (2018)

Исследование процессов нагрева и охлаждения электродвигателей средней мощности. 03.3.1. Исследование двигателей при нагружении по периодическому и случайному закону Промежуточный отчет о НИР
Argitaratua: (Томск, 1972)

Noise-limited thermal/infrared nondestructive testing
nork: Vavilov V. P. Vladimir Platonovich
Argitaratua: (2014)

Simulation of pre-breakdown phase of electrical discharge in reinforced concrete
nork: Kuznetsova N. S. Nataliya Sergeevna
Argitaratua: (2017)

Simulation of pre-breakdown phase of electrical discharge in reinforced concrete
nork: Kuznetsova N. S. Nataliya Sergeevna
Argitaratua: (2016)

Destruction of Reinforced Concrete by Electric Impulse Discharges: Experiment and Simulation
Argitaratua: (2017)

Thermal Nondestructive Testing of Thermal-Barrier Coatings of Turbine Buckets
Argitaratua: (2005)

Development of direct electric curing method for reinforced concrete products to improve their quality and reduce energy intensity
nork: Batyuk M. I.
Argitaratua: (2018)

Evaluating damage of reinforced concrete structures subjected to bending using the parameters of electric response to mechanical impact
Argitaratua: (2019)

An Automated Algorithm for Constructing Maps of Defects in Active Thermal Testing
nork: Chulkov A. O. Arseniy Olegovich
Argitaratua: (2019)

Developing a Nondestructive Method for Revealing Defective Areas in Reinforced Concrete Under Bending Conditions
nork: Fursa T. V. Tatjyana Viktorovna
Argitaratua: (2019)

Numerical Modeling of the Effect of Thawing of Soil in the Area of Placing Tanks for Storage Fuel of Thermal Power Plants and Boiler
nork: Polovnikov V. Yu. Vyacheslav Yurievich
Argitaratua: (2016)

A proposal of a new material for greenhouses on the basis of numerical, optical, thermal and mechanical approaches
Argitaratua: (2017)

Diagnostics of Damages in Reinforced Concrete by the Parameters of Electric Response to Mechanical Impact
Argitaratua: (2019)

Методы тепловых исследований электроэнергетических машин учебное пособие
nork: Малиновский С. С. Сергей Сергеевич
Argitaratua: (Ленинград, Изд-во ЛПИ, 1988)

A LED-based thermal detector of hidden corrosion flaws
nork: Chulkov A. O. Arseniy Olegovich
Argitaratua: (2016)

Scope for using infrared systems in thermal nondestructive testing
nork: Vavilov V. P. Vladimir Platonovich
Argitaratua: (1984)

Thermal nondestructive testing of materials and products: a review
nork: Vavilov V. P. Vladimir Platonovich
Argitaratua: (2017)

Influence of Microwaves on the Thermal Conditions of a "Polymer–Semiconductor–Composite" System
nork: Kuznetsov G. V. Geny Vladimirovich
Argitaratua: (2015)

A Method for Evaluating Failure in Reinforced Concrete under Bending Based on the Response of Electrical Parameters to an Impact Action
nork: Fursa T. V. Tatyana Viktorovna
Argitaratua: (2018)

Особенности термического разложения композиционной биомассы при микроволновом нагреве автореферат диссертации на соискание ученой степени кандидата технических наук спец. 2.4.6
nork: Швец А. С. Анатолий Сергеевич
Argitaratua: (Томск, 2024)

Исследование нагрева и охлаждения асинхронных двигателей средней мощности в стационарных и нестационарных режимах нагрева 03.3.1. Исследование нагрева асинхронных двигателей с высотой оси вращения 112-132 мм работающих в ПКР Отчет о НИР Тема: № 78/72
Argitaratua: (Томск, 1973)

Numerical modeling of heat transfer in the fuel oil storage tank at thermal power plant
nork: Kuznetsova S. A.
Argitaratua: (2015)