Reactive co-sputter deposition of nanostructured cermet anodes for solid oxide fuel cells
| Parent link: | Japanese Journal of Applied Physics (JJAP) Vol. 57, iss. 1S.— 2018.— [6 p.] |
|---|---|
| Autor Corporativo: | Национальный исследовательский Томский политехнический университет Исследовательская школа физики высокоэнергетических процессов |
| Outros Autores: | Ionov I. V. Igor Vyacheslavovich, Soloviev A. A. Andrey Aleksandrovich, Shipilova A. V. Anna Viktorovna, Lebedinsky A. M. Aleksey Mikhaylovich, Smolyanskiy (Smolyansky, Smolyanskii) E. A. Egor Aleksandrovich, Lauk A. L. Aleksandr Lukyanovich, Semenov V. A. Vyacheslav Arkadjevich |
| Resumo: | Title screen The impact of a nanostructured NiO/yttria-stabilized zirconia (NiO/YSZ) and NiO/gadolinia-doped ceria (NiO/GDC) anode functional layers on low- and intermediate-temperature solid oxide fuel cell (SOFC) performance is investigated. NiO/YSZ and NiO/GDC thin films were reactively sputter-deposited by pulsed direct current magnetron sputtering from the Ni, Zr–Y, and Ce–Gd targets onto commercial NiO/YSZ substrates. Anode-supported SOFCs based on magnetron sputtered YSZ and GDC electrolytes (~4 µm) with and without the nanostructured anode layers are fabricated. A direct comparison of the YSZ- and GDC-based SOFCs in temperature range of 600–800 and 400–600 °C is made. The performance of cells with the nanostructured anode layers significantly increases as compared to that of the cell without it, especially at lower temperatures. Increase of cells performance was achieved by reduction of the total area-specific resistance by 26–30%. |
| Publicado em: |
2018
|
| Assuntos: | |
| Acesso em linha: | http://earchive.tpu.ru/handle/11683/57711 https://doi.org/10.7567/JJAP.57.01AF07 |
| Formato: | Recurso Eletrônico Capítulo de Livro |
| KOHA link: | https://koha.lib.tpu.ru/cgi-bin/koha/opac-detail.pl?biblionumber=659111 |
Registros relacionados
Application of magnetron sputtering for NiO/YSz anode layer of solid oxide fuel cell formation
por: Tcybenko A. O. Alena Olegovna
Publicado em: (2013)
por: Tcybenko A. O. Alena Olegovna
Publicado em: (2013)
Effect of magnetron sputtered anode functional layer on the anode-supported solid oxide fuel cell performance
Publicado em: (2019)
Publicado em: (2019)
Scale‐up of Solid Oxide Fuel Cells with Magnetron Sputtered Electrolyte
Publicado em: (2017)
Publicado em: (2017)
Magnetron sputtered LSC thin films for solid oxide fuel cell application
Publicado em: (2018)
Publicado em: (2018)
The creation of anode-electrolyte solid oxide fuel cell structureon the carrier metal base
por: Terentyev D. N. Dmitry Nikolaevich
Publicado em: (2012)
por: Terentyev D. N. Dmitry Nikolaevich
Publicado em: (2012)
Formation of NiO/YSZ anode layer on the surface of solid oxide fuel cell carrier metal base
por: Borduleva A. O. Alena Olegovna
Publicado em: (2014)
por: Borduleva A. O. Alena Olegovna
Publicado em: (2014)
Formation of NiO/YSZ functional anode layers of solid oxide fuel cells by magnetron sputtering
Publicado em: (2017)
Publicado em: (2017)
Anode-supported solid oxide fuel cells with multilayer LSC/CGO/LSC cathode
Publicado em: (2021)
Publicado em: (2021)
Magnetron-sputtered La0.6Sr0.4Co0.2Fe0.8O3 nanocomposite interlayer for solid oxide fuel cell
Publicado em: (2017)
Publicado em: (2017)
The study of titanium oxynitride coatings solubility deposited by reactive magnetron sputtering
por: Leonova L. A. Liliya Aleksandrovna
Publicado em: (2016)
por: Leonova L. A. Liliya Aleksandrovna
Publicado em: (2016)
Performance Characteristics of Solid Oxide Fuel Cells with YSZ/CGO Electrolyte
Publicado em: (2017)
Publicado em: (2017)
Characterzations of nitrogen-doped titanium dioxide films prepared by reactive magnetron sputtering deposition
por: Pichugin V. F. Vladimir Fyodorovich
Publicado em: (2016)
por: Pichugin V. F. Vladimir Fyodorovich
Publicado em: (2016)
The Reactive Deposition of TiO[x] Thin Films
por: Sidelev D. V. Dmitry Vladimirovich
Publicado em: (2014)
por: Sidelev D. V. Dmitry Vladimirovich
Publicado em: (2014)
Deposition of the low resistive ITO-films by means of reactive magnetron sputtering of the In/Sn target on the cold substrate
Publicado em: (2016)
Publicado em: (2016)
Thin Ni-YSZ films fabricated by magnetron co-sputtering used as anodes for solid oxide fuel cells
Publicado em: (2012)
Publicado em: (2012)
Effect of sintering temperature on the performance of composite La0.6Sr0.4Co0.2Fe0.8O3-Ce0.9Gd0.1O2 cathode for solid oxide fuel cells
Publicado em: (2018)
Publicado em: (2018)
Magnetron-Sputtered YSZ and CGO Electrolytes for SOFC
Publicado em: (2016)
Publicado em: (2016)
Surface modification of electrospun poly-(l-lactic) acid scaffolds by reactive magnetron sputtering
Publicado em: (2018)
Publicado em: (2018)
Continuous solid-phase synthesis of nanostructured lithium iron phosphate powders in air
por: Kerbel B. M. Boris Moiseevich
Publicado em: (2018)
por: Kerbel B. M. Boris Moiseevich
Publicado em: (2018)
Solid oxide fuel cell anode surface modification by magnetron sputtering of NiO/YSZ thin film
Publicado em: (2016)
Publicado em: (2016)
Solid oxide fuel cell anode surface modification by magnetron sputtering of NiO/YSZ thin film
Publicado em: (2017)
Publicado em: (2017)
Superconducting properties of nanostructured microhelices
Publicado em: (2017)
Publicado em: (2017)
Effect of Intermediate Ion Cleaning of the Titanium Target on the Structure of Bioresorbable PLLA Scaffolds under Coating Deposition by DC Reactive Magnetron Sputtering
Publicado em: (2020)
Publicado em: (2020)
Surface modification of PLLA scaffolds via reactive magnetron sputtering in mixtures of nitrogen with noble gases for higher cell adhesion and proliferation
Publicado em: (2022)
Publicado em: (2022)
Nitrogen-Doped Titanium Dioxide Thin Films Formation on the Surface of PLLA Electrospun Microfibers Scaffold by Reactive Magnetron Sputtering Method
Publicado em: (2019)
Publicado em: (2019)
Nanostructured Semiconductor oxides for the next generation of electronics and functional devices Properties and applications
por: Zhuiykov S. Serge
Publicado em: (Oxford, Woodhead Publishing Limited, 2014)
por: Zhuiykov S. Serge
Publicado em: (Oxford, Woodhead Publishing Limited, 2014)
Optimal concentration of nanostructured powder in protective gas
Publicado em: (2017)
Publicado em: (2017)
Hydrogen Sorption by Carbon Nanostructured Materials
Publicado em: (2017)
Publicado em: (2017)
Antimicrobial activity of nanostructured composites produced in Al/Zn nanoparticle oxidation in aqueous-alcoholic solutions
Publicado em: (2014)
Publicado em: (2014)
Sintering of NiO/YSZ Anode Layers for Metal-Supported Solid Oxide Fuel Cell
Publicado em: (2014)
Publicado em: (2014)
Gas Transport in Solid Oxide Fuel Cells
por: He, Weidong, et al.
Publicado em: (2014)
por: He, Weidong, et al.
Publicado em: (2014)
Deposition of a Thin-Film CGO Electrolyte for Solid Oxide Fuel Cells
Publicado em: (2016)
Publicado em: (2016)
Формирование пленок YSZ электролита на подложках NiO YSZ методом окунания в суспензии на водной основе
Publicado em: (2017)
Publicado em: (2017)
Сравнение характеристик твердооксидных топливных элементов с пленочными твердыми электролитами YSZ и CGO, формируемыми методом магнетронного распыления
Publicado em: (2016)
Publicado em: (2016)
Использование рентгеновской дифракции In Situ для исследования диффузии кислорода в оксидах с кислородной проводимостью
por: Винокуров З. С.
Publicado em: (2017)
por: Винокуров З. С.
Publicado em: (2017)
Электрохимический способ формирования защитных покрытий на сталях-интерконнекторах для твердооксидных топливных элементов
por: Солодянкин А. А.
Publicado em: (2018)
por: Солодянкин А. А.
Publicado em: (2018)
Разработка и изготовление высокотемпературных твердооксидных устройств с использованием нанотехнологий диссертация на соискание ученой степени доктора технических наук спец. 01.04.07
por: Липилин А. С. Александр Сергеевич
Publicado em: (Екатеринбург, [Б. и.], 2014)
por: Липилин А. С. Александр Сергеевич
Publicado em: (Екатеринбург, [Б. и.], 2014)
Features of obtaining an effective catalyst for synthesis of carbon nanostructured materials
Publicado em: (2020)
Publicado em: (2020)
Structure of Welded Joints Obtained by Contact Weld in Nanostructured Titanium
Publicado em: (2015)
Publicado em: (2015)
Синтез пористых NiAl-Ni3Al сплавов для несущей металлической основы твёрдооксидных топливных элементов
Publicado em: (2015)
Publicado em: (2015)
Registros relacionados
-
Application of magnetron sputtering for NiO/YSz anode layer of solid oxide fuel cell formation
por: Tcybenko A. O. Alena Olegovna
Publicado em: (2013) -
Effect of magnetron sputtered anode functional layer on the anode-supported solid oxide fuel cell performance
Publicado em: (2019) -
Scale‐up of Solid Oxide Fuel Cells with Magnetron Sputtered Electrolyte
Publicado em: (2017) -
Magnetron sputtered LSC thin films for solid oxide fuel cell application
Publicado em: (2018) -
The creation of anode-electrolyte solid oxide fuel cell structureon the carrier metal base
por: Terentyev D. N. Dmitry Nikolaevich
Publicado em: (2012)