Influence of metallic additives on manganese ferrites sintering; IOP Conference Series: Materials Science and Engineering; Vol. 289 : Modern Technologies for Non-Destructive Testing

Influence of metallic additives on manganese ferrites sintering; IOP Conference Series: Materials Science and Engineering; Vol. 289 : Modern Technologies for Non-Destructive Testing

Detalles Bibliográficos
Parent link:	IOP Conference Series: Materials Science and Engineering Vol. 289 : Modern Technologies for Non-Destructive Testing.— 2018.— [012016, 4 p.]
Autor Principal:	Shevelev S. A. Sergey Anatolievich
Corporate Authors:	Национальный исследовательский Томский политехнический университет Инженерная школа энергетики Научно-образовательный центр И. Н. Бутакова (НОЦ И. Н. Бутакова), Национальный исследовательский Томский политехнический университет Исследовательская школа физики высокоэнергетических процессов
Outros autores:	Luchnikov P. A., Yarullina A. R. Anna Rafaelevna
Summary:	Title screen Influence of cuprum nanopowder additive received by electric explosion on the process of manganese ferrites MgFe2O4 consolidating at thermal sintering was researched by dilatometry method. Cuprum nanopowder at a rate of 5 mass % was added into the original commercial-grade powder of manganese ferrite MgFe2O4. Powder mixture was numerously blended with screening for better blending before pressing. Powder compacts were formed by cold one-axle static pressing. It was proved that introduction of cuprum additive caused shrinkage increase at final heating stage. There was abnormal compact enlarging at sintering in the air at isothermal stage; the specified process was not observed in vacuum. This difference can be explained by changes in conditions of gaseous discharge from volume of pores.
Idioma:	inglés
Publicado:	2018
Subjects:	электронный ресурс труды учёных ТПУ металлические добавки спекание ферриты марганец нанопорошки прессование газовые разряды керамические материалы
Acceso en liña:	http://dx.doi.org/10.1088/1757-899X/289/1/012016 http://earchive.tpu.ru/handle/11683/47013
Formato:	Electrónico Capítulo de libro
KOHA link:	https://koha.lib.tpu.ru/cgi-bin/koha/opac-detail.pl?biblionumber=657673

Títulos similares

The influence of ZrO2 additive on sintering and microstructure of lithium and lithium-titanium-zinc ferrites; Ceramics International; Vol. 45, iss. 2, pt. B
Publicado: (2018)

Изучение марганец-замещенных ферритов лантана-стронция в качестве электродных материалов топливных элементов; Химия и химическая технология в XXI веке
por: Антипинская Е. А.
Publicado: (2018)

Марганецсодержащие ферриты. Синтез и физико-химические свойства: [сборник статей]
Publicado: (Москва, Наука, 1986)

The study of initial permeability temperature dependences for LiTiZn ferrite ceramics; IOP Conference Series: Materials Science and Engineering; Vol. 289 : Modern Technologies for Non-Destructive Testing
por: Petrova A. B. Anna Borisovna
Publicado: (2018)

Dilatometric analysis of sintering lithium-titanium-zinc ferrite with ZrO2 additive; Journal of Thermal Analysis and Calorimetry; Vol. XXX, iss. X
Publicado: (2021)

Microstructure Formation of LiTiZn Ferrite Ceramics during Radiation-Thermal Sintering; Materials Science Forum; Vol. 970 : Modern Problems in Materials Processing, Manufacturing, Testing and Quality Assurance II
Publicado: (2019)

Radial-piston pump for drive of test machines; IOP Conference Series: Materials Science and Engineering; Vol. 289 : Modern Technologies for Non-Destructive Testing
Publicado: (2018)

Fair-Rite. Soft Ferrittes: Ferrite Products for The Electronics Industry
Publicado: (Wallkill, 1995)

Investigation of oxidation processes in non-stoichiometric lithium-titanium ferrites using TG analysis; Journal of Thermal Analysis and Calorimetry; Vol. 102, iss. 3
Publicado: (2010)

Manganese Content Control in Weld Metal During MAG Welding; IOP Conference Series: Materials Science and Engineering; Vol. 142 : Innovative Technologies in Engineering
por: Chinakhov D. A. Dmitriy Anatol'evich
Publicado: (2016)

[Вып.] 4: сборник работ, выполненных под руководством академика АН ГССР Р. И. Агладзе; Электрохимия марганца
Publicado: (1969)

Determination of the oxygen diffusion characteristics in Li-Ti ferrite by isotopic method; Modern Technique and Technologies (MTT' 2002)
por: Lysenko E. N. Elena Nikolaevna
Publicado: (2002)

Feasibility of using T-shaped feedback in teraohmmeters; IOP Conference Series: Materials Science and Engineering; Vol. 289 : Modern Technologies for Non-Destructive Testing
por: Yermoshin N. I.
Publicado: (2018)

Modeling of liquid flow in surface discontinuities; IOP Conference Series: Materials Science and Engineering; Vol. 289 : Modern Technologies for Non-Destructive Testing
por: Lobanova I. S. Irina Sergeevna
Publicado: (2018)

Phenomenological model of mechanoelectric transformations in rocks; IOP Conference Series: Materials Science and Engineering; Vol. 289 : Modern Technologies for Non-Destructive Testing
por: Fedotov P. I. Pavel Ivanovich
Publicado: (2018)

Photometric manganese analysis in air aerosols; Химия и химическая технология в XXI веке; Т. 2
por: Mardieva Z. A.
Publicado: (2011)

Influence of Al2O3 addition on microstructure, defects level and magnetic properties of LiTiZn ferrite ceramics; Ceramics International; Vol. 44, iss. 17
por: Malyshev A. V. Andrei Vladimirovich
Publicado: (2018)

Effect of sintering regimes on the microstructure and magnetic properties of LiTiZn ferrite ceramics; Ceramics International; Vol. 45, iss. 2, pt. B
Publicado: (2018)

Non-Destructive Testing of Welds
por: Raj B. Baldev
Publicado: (New Delhi, Narosa Publishing House, 2000)

Integrated microelectromechanical gyroscope under shock loads; IOP Conference Series: Materials Science and Engineering; Vol. 289 : Modern Technologies for Non-Destructive Testing
por: Nesterenko T. G. Tamara Georgievna
Publicado: (2018)

Electromigration in lithium-titanium ferrite ceramics sintered in radiation-thermal mode; Eurasian Physical Technical Journal; Vol. 18, No. 2
Publicado: (2021)

XRD Analysis of Ferrite Ceramics with Different Heat Treatment; Materials Science Forum; Vol. 970 : Modern Problems in Materials Processing, Manufacturing, Testing and Quality Assurance II
Publicado: (2019)

The selection criteria elements of X-ray optics system; IOP Conference Series: Materials Science and Engineering; Vol. 289 : Modern Technologies for Non-Destructive Testing
Publicado: (2018)

Dependence of Manganese Content in the Weld Metal on the Velocity of Active Shielding Gas Flow; IOP Conference Series: Materials Science and Engineering; Vol. 253 : Innovations in Fuel and Energy Complex and Mechanical Engineering (FEC-2017)
Publicado: (2017)

Ways of Carbonate Manganese Ores Concentration; Химия и химическая технология в XXI веке; Т. 2
por: Ivanova A. A.
Publicado: (2011)

X-Ray and Thermogravimetric Analyzes of Mechanically Activated Nickel Ferrites; Materials Science Forum; Vol. 970 : Modern Problems in Materials Processing, Manufacturing, Testing and Quality Assurance II
Publicado: (2019)

Electrical properties of lithium ferrite with addition of ZrO[2]; IOP Conference Series: Materials Science and Engineering; Vol. 110 : Radiation-Thermal Effects and Processes in Inorganic Materials (RTEP2015)
por: Lamonova S. A. Svetlana Andreevna
Publicado: (2016)

Relaxivity of Paramagnetic Complexes of Manganese and Gadolinium; Pharmaceutical Chemistry Journal; Vol. 53, No. 7
Publicado: (2019)

Effect of ZrO2 Additive on the Morphology of Lithium Ferrite; Electron Devices and Materials (EDM), Annual Siberian Russian Workshop; Micro/Nanotechnologies and Electron Devices (EDM)
por: Nikolaeva S. A. Svetlana Andreevna
Publicado: (2019)

Effect of Normalizing Heating of Ferrite Compacts on Compaction during Radiation-Thermal Sintering; Eurasian Physical Technical Journal; Vol. 18, No. 3
Publicado: (2021)

The in-process control of PVC sheath of a double core cable; IOP Conference Series: Materials Science and Engineering; Vol. 289 : Modern Technologies for Non-Destructive Testing
por: Galeeva N. S.
Publicado: (2018)

Dilatometric and kinetic analysis of sintering Li–Zn ferrite ceramics from milled reagents; Journal of Thermal Analysis and Calorimetry; Vol. 142, iss. 5
Publicado: (2020)

Anomalies of dielectric properties in a lithium-titanium ferrite ceramic; IFOST 2012; Vol. 1
por: Malyshev A. V. Andrei Vladimirovich
Publicado: (2012)

Formation of magnetic properties of ferrites during radiation-thermal sintering; Eurasian Physical Technical Journal; Vol. 17, No. 2 (34)
Publicado: (2020)

Influence of mechanical milling conditions on the dispersity of lithium ferrite; IOP Conference Series: Materials Science and Engineering; Vol. 93: Modern Technique and Technologies (MTT'2015)
por: Lamonova S. A. Svetlana Andreevna
Publicado: (2015)

Detection of insulation defects in the wire through measuring changes in its capacitance; IOP Conference Series: Materials Science and Engineering; Vol. 289 : Modern Technologies for Non-Destructive Testing
por: Vavilova G. V. Galina Vasilievna
Publicado: (2018)

Manganese Catalysts to Obtain Olefins from C[1]-C[4] Alkanes; Procedia Chemistry; Vol. 15 : Chemistry and Chemical Engineering in XXI century (CCE 2015)
Publicado: (2015)

Легирование конструкционной стали марганцем
por: Цуканов В. А.
Publicado: (Москва, Машгиз, 1959)

Voltammetric Determination of Manganese on Organo – Modified Electrodes; Procedia Chemistry; Vol. 10 : Chemistry and Chemical Engineering in XXI century
Publicado: (2014)

Relationship between magnetic properties and microstructure of ferrites during sintering in radiation and radiation-thermal conditions; Eurasian Physical Technical Journal; Vol. 18, No. 1
Publicado: (2021)