Structural State of a Weld Formed in Aluminum Alloy by Friction Stir Welding and Treated by Ultrasound
| Источник: | Russian Physics Journal.— , 1965- Vol. 59, iss. 7.— 2016.— [P. 971-977] |
|---|---|
| Автор-организация: | Национальный исследовательский Томский политехнический университет |
| Другие авторы: | Klimenov V. A. Vasily Aleksandrovich, Abzaev Yu. A. Yury Afanasjevich, Potekaev A. I. Aleksandr Ivanovich, Vlasov V. A. Viktor Alekseevich, Klopotov A. A. Anatoly Anatoljevic, Zaitsev K. V. Konstantin Viktorovich, Chumaevsky A. V. Andrey Vladimirovich, Porobova S. A. Svetlana Aleksandrovna, Grinkevich L. S. Larisa Sergeevna, Tazin I. D. Ivan Dmitrievich, Tazin D. I. Dmitry Ivanovich |
| Примечания: | Title screen The experimental data on structural state of an aluminum alloy, AlMg6, in the weld zone formed by friction stir welding are analyzed in order to evaluate the effect of its subsequent ultrasonic treatment. It is found that the crystal lattice transits into a low-stability state as a result of combined heat-induced and severe shear deformation. This transition is accompanied by considerable structural-phase changes that are manifested as an increased lattice parameter of the solid solution. This increase is caused by both high values of internal stresses and increased concentration of Mg atoms in the solid solution due to essential dissolution of the ?-Al2Mg3 particles with the content of manganese higher than that in the matrix. This is accompanied by high-intensity diffusion and relaxation processes due to the low-stability state of crystal lattice (inhomogeneous stresses) in the weld zone. Режим доступа: по договору с организацией-держателем ресурса |
| Опубликовано: |
2016
|
| Предметы: | |
| Online-ссылка: | https://doi.org/10.1007/s11182-016-0862-0 |
| Формат: | Электронный ресурс Статья |
| Запись в KOHA: | https://koha.lib.tpu.ru/cgi-bin/koha/opac-detail.pl?biblionumber=656314 |
Схожие документы
Joining of Aluminum Alloys with Friction Stir Welding Method
по: Semenchuk V. M.
Опубликовано: (2015)
по: Semenchuk V. M.
Опубликовано: (2015)
The effect of friction stir welding tool wear on the weld quality of aluminum alloy AMg5M
по: Tarasov S. Yu. Sergei Yulievich
Опубликовано: (2014)
по: Tarasov S. Yu. Sergei Yulievich
Опубликовано: (2014)
Ultrasonic-assisted friction stir welding on 7075 aluminum alloy
Опубликовано: (2015)
Опубликовано: (2015)
Mass Transfer at Atomic Scale in MD Simulation of Friction Stir Welding
Опубликовано: (2016)
Опубликовано: (2016)
Radioscopy of remnant joint line in a friction stir welded seam
Опубликовано: (2015)
Опубликовано: (2015)
Microstructure of Fixed Butt Joints Formed by Friction Stir Welding on 2024T3 Aluminum Alloy
Опубликовано: (2016)
Опубликовано: (2016)
Modeling of the Mechanical Behavior of Aluminum Alloys with Friction Stir Welds
по: Balokhonov R. R. Ruslan Revovich
Опубликовано: (2015)
по: Balokhonov R. R. Ruslan Revovich
Опубликовано: (2015)
Ultrasonic-Assisted Friction Stir Welding on V95AT1 (7075) Aluminum Alloy
Опубликовано: (2015)
Опубликовано: (2015)
Influence of Tool Shape on Lattice Rearrangement under Loading Conditions Reproducing Friction Stir Welding
по: Konovalenko I. S. Ivan Sergeevich
Опубликовано: (2015)
по: Konovalenko I. S. Ivan Sergeevich
Опубликовано: (2015)
Diffusion-controlled wear of steel friction stir welding tools used on aluminum alloys
Опубликовано: (2015)
Опубликовано: (2015)
Features of the microstructure development under conditions, reproducing the process of friction stir welding. Molecular-dynamics study
Опубликовано: (2014)
Опубликовано: (2014)
Microstructure features of aluminum alloys welded joint obtained by friction stir welding
Опубликовано: (2014)
Опубликовано: (2014)
The microstructure of aluminum-magnesium alloy friction stir weld
Опубликовано: (2014)
Опубликовано: (2014)
Diffusion-Controlled Wear of Steel Friction Stir Welding Tools Used on Aluminum Alloys
Опубликовано: (2015)
Опубликовано: (2015)
Adhesion transfer in sliding a steel ball against an aluminum alloy
Опубликовано: (2017)
Опубликовано: (2017)
Structure and Properties of Fixed Joints Formed by Ultrasonic-Assisted Friction-Stir Welding
Опубликовано: (2015)
Опубликовано: (2015)
Structure Formation of 5083 Alloy during Friction Stir Welding
Опубликовано: (2017)
Опубликовано: (2017)
Theoretical study of the influence of technological friction stir welding parameters on weld structure
Опубликовано: (2015)
Опубликовано: (2015)
Specifics of Welded Joint Destruction Obtained by Friction Stir Welding at Strain
Опубликовано: (2015)
Опубликовано: (2015)
Microstructure of AA2024T3 fixed joints formed by friction stir welding
Опубликовано: (2015)
Опубликовано: (2015)
Towards the Problem of Forming Full Strength Welded Joints on Aluminum Alloy Sheets. Part I: AA2024
Опубликовано: (2016)
Опубликовано: (2016)
Effect of Friction Stir Welding Parameters on Defect Formation
Опубликовано: (2015)
Опубликовано: (2015)
The effect of friction stir welding parameters on defect formation
Опубликовано: (2015)
Опубликовано: (2015)
Friction welding
по: Nikiforov D. S.
Опубликовано: ()
по: Nikiforov D. S.
Опубликовано: ()
Investigation of Influence of Friction Stir Welding Regimes on the Features of Mass Transfer and Temperature Distribution in Forming Welds
Опубликовано: (2015)
Опубликовано: (2015)
Ultrasonic-assisted aging in friction stir welding on Al-Cu-Li-Mg aluminum alloy
Опубликовано: (2017)
Опубликовано: (2017)
General regularities of the microstructure formation during friction stir welding and sliding friction
Опубликовано: (2015)
Опубликовано: (2015)
Tensile Strength on Friction Stir Processed AMg5 (5083) Aluminum Alloy
Опубликовано: (2016)
Опубликовано: (2016)
Thermography inspection of friction stir welding
Опубликовано: (2014)
Опубликовано: (2014)
Fracturing Behavior of Aluminum Alloys with Welded Joints
Опубликовано: (2015)
Опубликовано: (2015)
Ultrasonic impact treatment of the welded joint of aluminum-magnesium alloy produced by friction stir welding
Опубликовано: (2014)
Опубликовано: (2014)
Tensile strength on friction stir processed AMG5 (5083) aluminum alloy
Опубликовано: (2016)
Опубликовано: (2016)
Ultrasonic phase array and eddy current methods for diagnostics of flaws in friction stir welds
Опубликовано: (2014)
Опубликовано: (2014)
Radiographic detection of defects in friction stir welding on aluminum alloy AMg5M
по: Tarasov S. Yu. Sergei Yulievich
Опубликовано: (2014)
по: Tarasov S. Yu. Sergei Yulievich
Опубликовано: (2014)
A Theoretical Study of the Influence of Technological Friction Stir Welding Parameters on Weld Structures
Опубликовано: (2015)
Опубликовано: (2015)
Microstructure of AA 2024 Fixed Joints Formed by Friction Stir Welding
Опубликовано: (2015)
Опубликовано: (2015)
Towards the Problem of Forming Full Strength Welded Joints on Aluminum Alloy Sheets. Part II: AA7475
Опубликовано: (2016)
Опубликовано: (2016)
Structural Evolution of Multiple Friction Stir Processed AA2024
Опубликовано: (2017)
Опубликовано: (2017)
Infrared Thermography Inspection of Severe Friction on UFG Stainless Steel, Copper and Aluminum Alloy
по: Filippov A. V.
Опубликовано: (2019)
по: Filippov A. V.
Опубликовано: (2019)
Effect of ultrasound on interface morphology and strength of titanium and aluminum alloys joints produced by friction stir welding
Опубликовано: (2023)
Опубликовано: (2023)
Схожие документы
-
Joining of Aluminum Alloys with Friction Stir Welding Method
по: Semenchuk V. M.
Опубликовано: (2015) -
The effect of friction stir welding tool wear on the weld quality of aluminum alloy AMg5M
по: Tarasov S. Yu. Sergei Yulievich
Опубликовано: (2014) -
Ultrasonic-assisted friction stir welding on 7075 aluminum alloy
Опубликовано: (2015) -
Mass Transfer at Atomic Scale in MD Simulation of Friction Stir Welding
Опубликовано: (2016) -
Radioscopy of remnant joint line in a friction stir welded seam
Опубликовано: (2015)