Формирование трибослоев на поверхности композита WC - сталь гадфильда после сухого трения по стали
| Parent link: | Перспективные материалы.— , 1995- № 12.— 2011.— [С. 449-454] |
|---|---|
| Autor principal: | |
| Otros Autores: | , , |
| Sumario: | Заглавие с экрана Показано, что при трении композита WC-сталь Гадфильда по стали в диапазоне скоростей скольжения до 37 м/с при давлении 2 МПа происходит изменение структуры приповерхностных областей. При этом при скоростях до 20 м/с состав поверхности трения не отличается от исходного композита, а после скоростей скольжения выше 20 м/с возникающие при трении трибослои обогащены железом и содержат в своем составе оксид Fe3WO4. При давлении 4 МПа в диапазоне скоростей скольжения 15-37 м/с, вследствие разогрева поверхности трения композита, происходит образование «козырьков», состоящих из деформированного композита и трибослоёв. It is shown that during the sliding wear of WC-Hadfield steel composite against steel carried out at sliding speeds up to 37 m/s and contact stress 2 MPa structural changes of subsurface layers of the hard metal occur. Sliding at the speeds below 20 m/s did not change the chemical composition on the worn surfaces as compared to that of the source samples. The sliding at speeds above 20 m/s generates tribolayers enriched both with iron and containing Fe3WO4 mixed oxide. The effect of sliding both at higher contact stress 4 MPa and in the range 15 to 37 m/s is intensive heating and therefore formation of a lip on a cylindrical sample. These lips consisted of severely deformed composite and tribolayers. Режим доступа: по договору с организацией-держателем ресурса |
| Lenguaje: | ruso |
| Publicado: |
2011
|
| Materias: | |
| Acceso en línea: | https://elibrary.ru/item.asp?id=17561573 |
| Formato: | Electrónico Capítulo de libro |
| KOHA link: | https://koha.lib.tpu.ru/cgi-bin/koha/opac-detail.pl?biblionumber=655093 |
| Sumario: | Заглавие с экрана Показано, что при трении композита WC-сталь Гадфильда по стали в диапазоне скоростей скольжения до 37 м/с при давлении 2 МПа происходит изменение структуры приповерхностных областей. При этом при скоростях до 20 м/с состав поверхности трения не отличается от исходного композита, а после скоростей скольжения выше 20 м/с возникающие при трении трибослои обогащены железом и содержат в своем составе оксид Fe3WO4. При давлении 4 МПа в диапазоне скоростей скольжения 15-37 м/с, вследствие разогрева поверхности трения композита, происходит образование «козырьков», состоящих из деформированного композита и трибослоёв. It is shown that during the sliding wear of WC-Hadfield steel composite against steel carried out at sliding speeds up to 37 m/s and contact stress 2 MPa structural changes of subsurface layers of the hard metal occur. Sliding at the speeds below 20 m/s did not change the chemical composition on the worn surfaces as compared to that of the source samples. The sliding at speeds above 20 m/s generates tribolayers enriched both with iron and containing Fe3WO4 mixed oxide. The effect of sliding both at higher contact stress 4 MPa and in the range 15 to 37 m/s is intensive heating and therefore formation of a lip on a cylindrical sample. These lips consisted of severely deformed composite and tribolayers. Режим доступа: по договору с организацией-держателем ресурса |
|---|