Forming Completely Penetrated Welded T-joints when Pulsed Arc Welding; IOP Conference Series: Materials Science and Engineering; Vol. 125 : Materials Treatment: Current Problems and Solutions

Forming Completely Penetrated Welded T-joints when Pulsed Arc Welding

Podrobná bibliografie
Parent link:IOP Conference Series: Materials Science and Engineering
Vol. 125 : Materials Treatment: Current Problems and Solutions.— 2016.— [012003, 7 p.]
Hlavní autor: Krampit N. Yu. Nataliya Yurievna
Korporativní autor: Национальный исследовательский Томский политехнический университет (ТПУ) Юргинский технологический институт (филиал) (ЮТИ) Кафедра сварочного производства (КСП)
Další autoři: Krampit M. A. Maksim Andreevich, Sapozhkov A. S.
Shrnutí:Title screen
The paper is focused on revealing the influence of welding parameters on weld formation when pulsed arc welding. As an experimental sample a T-joint over 10 mm was selected. Welding was carried out in flat position, which required no edge preparation but provided mono-directional guaranteed root penetration. The following parameters of welding were subjected to investigation: gap in the joint, wire feed rate and incline angles of the torch along and across the weld axis. Technological recommendations have been made with respect to pulsed arc welding; the cost price of product manufacturing can be reduced on their basis due to reduction of labor input required by machining, lowering consumption of welding materials and electric power.
Режим доступа: по договору с организацией-держателем ресурса
Jazyk:angličtina
Vydáno: 2016
Témata:
электронный ресурс
труды учёных ТПУ
импульсно-дуговая сварка
сварка
сварные швы
сварочные материалы
затраты труда
электроэнергия
On-line přístup:http://dx.doi.org/10.1088/1757-899X/125/1/012003
http://earchive.tpu.ru/handle/11683/33918
Médium: Elektronický zdroj Kapitola
KOHA link:https://koha.lib.tpu.ru/cgi-bin/koha/opac-detail.pl?biblionumber=648106

Podobné jednotky

Podobné jednotky