Microstructure, mechanical properties and machining performance of hot-pressed Al[2]O[3]-ZrO[2]-TiC composites; IOP Conference Series: Materials Science and Engineering; Vol. 116 : Advanced Materials and New Technologies in Modern Materials Science

Microstructure, mechanical properties and machining performance of hot-pressed Al[2]O[3]-ZrO[2]-TiC composites; IOP Conference Series: Materials Science and Engineering; Vol. 116 : Advanced Materials and New Technologies in Modern Materials Science

Bibliografiske detaljer
Parent link:IOP Conference Series: Materials Science and Engineering
Vol. 116 : Advanced Materials and New Technologies in Modern Materials Science.— 2016.— [012002, 5 p.]
Corporate Authors: Национальный исследовательский Томский политехнический университет (ТПУ) Институт физики высоких технологий (ИФВТ) Кафедра материаловедения в машиностроении (ММС), Национальный исследовательский Томский политехнический университет (ТПУ) Институт физики высоких технологий (ИФВТ) Кафедра материаловедения и технологии металлов (МТМ)
Andre forfattere: Grigoriev M. V. Mikhail Vladimirovich, Kotelnikov N., Buyakova S. P. Svetlana Petrovna, Kulkov S. N. Sergey Nikolaevich
Summary:Title screen
The effect of adding nanocrystalline ZrO[2] and submicron TiC to ultrafine Al[2]O[3] on mechanical properties and the microstructure of the composites developed by hot pressing was investigated. It was shown that by means of hot pressing in an argon atmosphere at a sintering temperature of 1500 °С one can obtain the composites Al[2]O[3] - ZrO[2] - TiC with a fine structure and minimal porosity. It has been shown that in material a multi-scale hierarchical structure is formed, which possesses high physical and mechanical properties: the hardness and fracture toughness was 21.5 GPa and 5.2 MPa*m{1/2} respectively, the modulus of elasticity was 500 GPa and bending strength was 390 MPa. Tests on composites' cutting properties were carried out on interrupted cutting of hardened steel. All samples had wear of the cutting edge in the form of chips of the grain rear working surface of the tool, but the cutting tool which was made by Al[2]O[3] - 10% ZrO[2] - 10% TiC had a minimum width of wear.
Режим доступа: по договору с организацией-держателем ресурса
Sprog:engelsk
Udgivet: 2016
Fag:
электронный ресурс
труды учёных ТПУ
микроструктуры
механические свойства
механическая обработка
производительность
горячее прессование
композиты
композиционные материалы
Online adgang:http://dx.doi.org/10.1088/1757-899X/116/1/012002
http://earchive.tpu.ru/handle/11683/18934
Format: Electronisk Book Chapter
KOHA link:https://koha.lib.tpu.ru/cgi-bin/koha/opac-detail.pl?biblionumber=647093

Lignende værker

Lignende værker