Model of Heterogeneous Material Dissolution in Simulated Biological Fluid
| Parent link: | AIP Conference Proceedings Vol. 1683 : Advanced Materials with Hierarchical Structure for New Technologies and Reliable Structures.— 2015.— [020019, 7 p.] |
|---|---|
| Autor Principal: | Knyazeva A. G. Anna Georgievna |
| Autor Corporativo: | Национальный исследовательский Томский политехнический университет (ТПУ) Институт физики высоких технологий (ИФВТ) Кафедра физики высоких технологий в машиностроении (ФВТМ) |
| Outros autores: | Gutmanas E. Y. |
| Summary: | Title screen In orthopedic research, increasing attention is being paid to bioresorbable/biodegradable implants as analternative to permanent metallic bone healing devices. Biodegradable metal based implants possessing high strength andductility potentially can be used in load bearing sites. Biodegradable Mg and Fe are ductile and Fe possess high strength,but Mg degrades too fast and Fe degrades too slow, Ag is a noble metal and should cause galvanic corrosion of the moreactive metallic iron – thus, corrosion of Fe can be increased. Nanostructuring should results in higher strength and canresult in higher rate of dissolution/degradation from grain boundaries. In this work, a simple dissolution model ofheterogeneous three phase nanocomposite material is considered – two phases being metal Fe and Ag and the third –nanopores. Analytical solution for the model is presented. Calculations demonstrate that the changes in the relativeamount of each phase depend on mass exchange and diffusion coefficients. Theoretical results agree with preliminaryexperimental results. Режим доступа: по договору с организацией-держателем ресурса |
| Publicado: |
2015
|
| Subjects: | |
| Acceso en liña: | http://dx.doi.org/10.1063/1.4936014 |
| Formato: | Electrónico Capítulo de libro |
| KOHA link: | https://koha.lib.tpu.ru/cgi-bin/koha/opac-detail.pl?biblionumber=645965 |
Títulos similares
Influence of hydroxyapatite filling degree on mechanical properties of 3D-printed poly(l-lactic acid)-based implantable material1
Publicado: (2018)
Publicado: (2018)
La synthèse de l'hydroxyapatite
por: Malysheva V. A.
Publicado: (2014)
por: Malysheva V. A.
Publicado: (2014)
Hybrid coatings based on polymeric materials modified by PVD technique for orthopedic implants
por: Malchikhina A. I. Alena Igorevna
Publicado: (2012)
por: Malchikhina A. I. Alena Igorevna
Publicado: (2012)
Vorteile und Nachteile der Anwendung von Metall -und Keramikimplantate in der Medizin
por: Proskyrin A. A.
Publicado: (2014)
por: Proskyrin A. A.
Publicado: (2014)
Investigation of a biodegradable polymer and a graphene-based material composite for in vivo applications
Publicado: (2022)
Publicado: (2022)
Bioactive Calcium Phosphate Coatings on Metallic Implants
Publicado: (2017)
Publicado: (2017)
Антенны на основе композитов графена и полимеров для мониторинга живых тканей
Publicado: (2021)
Publicado: (2021)
Стеклокристаллические материалы медицинского назначения
por: Шумкова В. В.
Publicado: (2002)
por: Шумкова В. В.
Publicado: (2002)
Паротермическое металлооксидное покрытие на титановых ортопедических имплантатах для остеосинтеза, микромодифицированное серебром
por: Родионов И. В.
Publicado: (2012)
por: Родионов И. В.
Publicado: (2012)
Development of Numerical Models of Interfaces for Multiscale Simulation of Heterogeneous Materials
Publicado: (2015)
Publicado: (2015)
Биоматериалы: обзор рынка
por: Дорожкин С. В.
Publicado: (2002)
por: Дорожкин С. В.
Publicado: (2002)
Применение циркония для имплантантов в травмотологии и ортопедии
por: Шерепо К. М.
Publicado: (2004)
por: Шерепо К. М.
Publicado: (2004)
Создание биоактивного покрытия на основе синтетического гидроксиапатита для титана медицинского назначения
por: Малышева В. А.
Publicado: (2014)
por: Малышева В. А.
Publicado: (2014)
Properties and degradation of rGO/PLA laser-induced composites toward implantable electronics
Publicado: (2023)
Publicado: (2023)
Simulation of temperature behaviour of heterogeneous materials by hybrid fem-secam model
Publicado: (2008)
Publicado: (2008)
Corrosion Resistance and Cytocompatibility of Magnesium-Calcium Alloys Modified with Zinc- or Gallium-Doped Calcium Phosphate Coatings
Publicado: (2022)
Publicado: (2022)
Dissolution testing for prolonged-release solid dosage form containing drug substances degrading in test media. Application to polymeric delivery systems of paracetamol
por: Rakina A. A. Apollinariya Aleksandrovna
Publicado: (2019)
por: Rakina A. A. Apollinariya Aleksandrovna
Publicado: (2019)
Способы функционализации металлических имплантатов с использованием наночастиц серебра
por: Шаронова А. А. Анна Александровна
Publicado: (2017)
por: Шаронова А. А. Анна Александровна
Publicado: (2017)
Возможности улучшения функциональных свойств титановых имплантатов
por: Петровская Т. С. Татьяна Семёновна
Publicado: (2013)
por: Петровская Т. С. Татьяна Семёновна
Publicado: (2013)
Синтез сополимеров молочной кислоты с капролактамом и бетулином в условиях микроволнового облучения
Publicado: (2016)
Publicado: (2016)
Исследование микроструктуры кальцийфосфатных покрытий, модифицированных ионами цинка и меди
por: Казакбаева А. А.
Publicado: (2017)
por: Казакбаева А. А.
Publicado: (2017)
Влияние поверхностной текстуры титана ВТ1-0 на его коррозионную стойкость в биологических средах
por: Иванов И. В.
Publicado: (2017)
por: Иванов И. В.
Publicado: (2017)
Гибридные биоматериалы на основе полимолочной и полиакриловой кислот
por: Даниленко Н. В. Надежда Викторовна
Publicado: (2016)
por: Даниленко Н. В. Надежда Викторовна
Publicado: (2016)
Нанесение биоактивных покрытий на биорезорбируемые скаффолды из поликапролатона
por: Бочаров В. С. Вадим Сергеевич
Publicado: (2022)
por: Бочаров В. С. Вадим Сергеевич
Publicado: (2022)
The Fabrication of Bioresorbable Implants for Bone Defects Replacement Using Computer Tomogram and 3D Printing
Publicado: (2017)
Publicado: (2017)
Composite implants coated with biodegradable polymers prevent stimulating tumor progression
Publicado: (2016)
Publicado: (2016)
Automated system for extremity lengthening
por: Blynskiy F. Yu.
Publicado: (2012)
por: Blynskiy F. Yu.
Publicado: (2012)
Новые технологии создания и применения биокерамики в восстановительной медицине материалы IV Международной научно-практической конференции, 13-15 октября 2016 г.
Publicado: (Томск, Изд-во ТПУ, 2016)
Publicado: (Томск, Изд-во ТПУ, 2016)
Mathematical Simulation of Heat Transfer in Heterogenous Forest Fuel Layer Influenced by Heated Up to High Temperatures Steel Particle
por: Baranovskiy N. V. Nikolay Viktorovich
Publicado: (2014)
por: Baranovskiy N. V. Nikolay Viktorovich
Publicado: (2014)
Impact of defectiveness on the parameters of the acoustoelectric transformations in heterogeneous non-metallic materials
Publicado: (2015)
Publicado: (2015)
Изучение структуры и состава микродуговых лантан-кремний-содержащих кальцийфосфатных покрытий
por: Казанцева Е. А.
Publicado: (2017)
por: Казанцева Е. А.
Publicado: (2017)
Композиционные покрытия титановых имплантатов с функцией адресной доставки фармпрепаратов
Publicado: (2022)
Publicado: (2022)
Model of the Plate Oxygen Cutting Taking into Account the Kinetics of Heterogeneous Oxidation Reaction
por: Knyazeva A. G. Anna Georgievna
Publicado: (2014)
por: Knyazeva A. G. Anna Georgievna
Publicado: (2014)
Elastic Vortex Displacements as Precursors of Mechanical Stress Relaxation in Heterogeneous Materials
Publicado: (2016)
Publicado: (2016)
Modelling Degradation of Bioresorbable Polymeric Medical Devices
Publicado: (Amsterdam, Elsevier, 2015)
Publicado: (Amsterdam, Elsevier, 2015)
Effect of Low-Temperature Plasma Treatment and gamma Irradiation on the Surface Properties of Thin Films Based on Polylactic Acid
Publicado: (2021)
Publicado: (2021)
Керамические и стеклокерамические материалы для медицины учебное пособие
Publicado: (Томск, Изд-во ТПУ, 2011)
Publicado: (Томск, Изд-во ТПУ, 2011)
Биоматериалы и имплантаты для травматологии и ортопедии монография
Publicado: (Томск, Изд-во ТПУ, 2011)
Publicado: (Томск, Изд-во ТПУ, 2011)
Получение кальцийфосфатных биосовместимых покрытий методом магнетронного распыления и их свойства
Publicado: (2006)
Publicado: (2006)
Биоактивные имплантаты при лечении псевдоартрозов и дефектов длинных трубчатых костей монография
Publicado: (Томск, Изд-во ТПУ, 2021)
Publicado: (Томск, Изд-во ТПУ, 2021)
Títulos similares
-
Influence of hydroxyapatite filling degree on mechanical properties of 3D-printed poly(l-lactic acid)-based implantable material1
Publicado: (2018) -
La synthèse de l'hydroxyapatite
por: Malysheva V. A.
Publicado: (2014) -
Hybrid coatings based on polymeric materials modified by PVD technique for orthopedic implants
por: Malchikhina A. I. Alena Igorevna
Publicado: (2012) -
Vorteile und Nachteile der Anwendung von Metall -und Keramikimplantate in der Medizin
por: Proskyrin A. A.
Publicado: (2014) -
Investigation of a biodegradable polymer and a graphene-based material composite for in vivo applications
Publicado: (2022)