The possibility of increasing the efficiency of CuBr lasers in the regime of double pump pulses; Technical Physics Letters; Vol. 41, iss. 8
| Parent link: | Technical Physics Letters: Scientific Journal.— , 1975- Vol. 41, iss. 8.— 2015.— [P. 759-761] |
|---|---|
| Hlavní autor: | Fedorov A. I. Anatoly Ignatjevich |
| Korporativní autor: | Национальный исследовательский Томский политехнический университет (ТПУ) Институт неразрушающего контроля (ИНК) Кафедра промышленной и медицинской электроники (ПМЭ) |
| Další autoři: | Shiyanov D. V. Dmitry Valeryevich |
| Shrnutí: | Title screen The results of studies of CuBr lasers operating in the regime of double pump pulses with a lasing pulse repetition rate of 50 Hz are presented. The potential to raise the laser efficiency by optimizing the parameters of the excitation pulse and matching it to the impedance of plasma of the active medium formed by the dissociation pump pulse is evaluated. It is demonstrated that the laser efficiency may be increased by several times if the excitation pulse parameters are optimized and the coordinated regime of introduction of the excitation pulse energy into the active medium plasma is used. A maximum laser efficiency of 1.2% with respect to the excitation pulse energy with an energy of 0.2 mJ, an average power of 10 mW, and a half-amplitude duration of lasing pulses of 30 ns is obtained at a time delay of 50 µs. The maximum average radiation power is 18.5 mW with an energy of 0.37 mJ and a laser efficiency of 0.7% for a specific energy of the dissociation (excitation) pulse of 26 (1.8) mJ/cm3. Режим доступа: по договору с организацией-держателем ресурса |
| Jazyk: | angličtina |
| Vydáno: |
2015
|
| Témata: | |
| On-line přístup: | http://dx.doi.org/10.1134/S1063785015080076 |
| Médium: | Elektronický zdroj Kapitola |
| KOHA link: | https://koha.lib.tpu.ru/cgi-bin/koha/opac-detail.pl?biblionumber=645706 |
Podobné jednotky
Possibilities of increasing the efficiency of a double-pulsed excitation CuBr-laser; Atomic and molecular pulsed lasers
Autor: Fedorov A. I. Anatoly Ignatjevich
Vydáno: (2015)
Autor: Fedorov A. I. Anatoly Ignatjevich
Vydáno: (2015)
A CuBr laser with high efficiency in the double-pumping-pulse mode; Technical Physics Letters; Vol. 43, iss. 3
Autor: Fedorov A. I. Anatoly Ignatjevich
Vydáno: (2017)
Autor: Fedorov A. I. Anatoly Ignatjevich
Vydáno: (2017)
Low frequency CuBr-laser; Atomic and molecular pulsed lasers
Autor: Fedorov A. I. Anatoly Ignatjevich
Vydáno: (2015)
Autor: Fedorov A. I. Anatoly Ignatjevich
Vydáno: (2015)
Modeling of Capacitive Discharge Pumping of CuBr Laser Active Element; Atomic and Molecular Pulsed Lasers
Vydáno: (2011)
Vydáno: (2011)
The influence of the gas mixture content and pumping conditions on CuBr-laser performance; Atomic and Molecular Pulsed Lasers
Vydáno: (2005)
Vydáno: (2005)
CuBr lasing control for data transmission system; Atomic and Molecular Pulsed Lasers
Autor: Fedorov K. V.
Vydáno: (2011)
Autor: Fedorov K. V.
Vydáno: (2011)
High frequency nanosecond pulse generator for CuBr-laser pumping; Micro/Nanotechnologies and Electron Devices (EDM)
Vydáno: (2014)
Vydáno: (2014)
Capacitive Discharge Excited CuBr Laser; Atomic and Molecular Pulsed Lasers
Vydáno: (2011)
Vydáno: (2011)
Simulation of High Pulse Repetition Rate CuBr Laser; Atomic and Molecular Pulsed Lasers
Vydáno: (2011)
Vydáno: (2011)
The solid state power supply of CuBr laser; Atomic and Molecular Pulsed Lasers
Vydáno: (2011)
Vydáno: (2011)
Comparison of CuBr-laser frequency operation modes; Proceedings of SPIE; Vol. 9810 : Atomic and Molecular Pulsed Lasers XII
Autor: Fedorov V. F. Valery Fedorovich
Vydáno: (2015)
Autor: Fedorov V. F. Valery Fedorovich
Vydáno: (2015)
Effect of methane additives on CuBr-Ne - laser performance; Atomic and Molecular Pulsed Lasers
Vydáno: (2009)
Vydáno: (2009)
Recovery of copper bromide in plasma of CuBr-laser in the interpulse period; Atomic and Molecular Pulsed Lasers
Vydáno: (2009)
Vydáno: (2009)
Active optical systems on basis of CuBr lasers with high pulse repetition rates; Atomic and Molecular Pulsed Lasers
Vydáno: (2009)
Vydáno: (2009)
Temperature condition of CuBr-Ne-HBr-laser copper bromide containers; Atomic and Molecular Pulsed Lasers
Autor: Evtushenko G. S. Gennady Sergeevich
Vydáno: (2005)
Autor: Evtushenko G. S. Gennady Sergeevich
Vydáno: (2005)
Simulation of a CuBr–Ne–HBr laser with high pump pulse repetition frequencies; Russian Physics Journal; Vol. 55, iss. 9
Vydáno: (2013)
Vydáno: (2013)
Over-the-horizon link based on high-frequency pulsed CuBr laser; Control and Communications (SIBCON)
Vydáno: (2015)
Vydáno: (2015)
About CuBr laser pulse duration in an unstable discharge; Micro/Nanotechnologies and Electron Devices (EDM)
Autor: Gubarev F. A. Fedor Aleksandrovich
Vydáno: (2015)
Autor: Gubarev F. A. Fedor Aleksandrovich
Vydáno: (2015)
Simulation of a CuBr laser; Laser Physics; Vol. 18, iss. 12
Autor: Boichenko A. M.
Vydáno: (2008)
Autor: Boichenko A. M.
Vydáno: (2008)
Influence of HBr-additives on Cu and CuBr vapor laser performances; Korus 2004; Vol. 2
Vydáno: (2004)
Vydáno: (2004)
Capacitive-Discharge-Pumped CuBr Laser With 12 W Average Output Power; IEEE Journal of Quantum Electronics; Vol. 49, iss. 1
Vydáno: (2013)
Vydáno: (2013)
Temperature operating mode of the CuBr+Ne+H2(HBr)-laser at change of pumping; Bulletin of the Tomsk Polytechnic University; Vol. 309, № 4
Autor: Shiyanov D. V. Dmitry Valeryevich
Vydáno: (2006)
Autor: Shiyanov D. V. Dmitry Valeryevich
Vydáno: (2006)
Capacitive-discharge pumped CuBr laser with 12 W average output power; IEEE Journal of Quantum Electronics; Vol. PP, iss. 99
Vydáno: (2012)
Vydáno: (2012)
Cell thermostat of CuBr-laser working substance; Modern technique and technologies MTT' 2012
Autor: Dashinimaeva E. Z.
Vydáno: (2012)
Autor: Dashinimaeva E. Z.
Vydáno: (2012)
Seald-off CuBr laser with HBr additives; Modern Techniques and Technoloqies MTT 2004
Autor: Shiyanov D. V. Dmitry Valeryevich
Vydáno: (2004)
Autor: Shiyanov D. V. Dmitry Valeryevich
Vydáno: (2004)
High-voltage CuBr laser power supply based on transistor switch; Electronics and Nanotechnology
Autor: Torgaev S. N. Stanislav Nikolaevich
Vydáno: (2011)
Autor: Torgaev S. N. Stanislav Nikolaevich
Vydáno: (2011)
Simulation of a CuBr laser in the presence and in the absence of hydrogen impurity; Laser Physics; Vol. 18, iss. 4
Autor: Boichenko A. M.
Vydáno: (2008)
Autor: Boichenko A. M.
Vydáno: (2008)
Nonresonant Optical Pumping of Sodium by a Dye and CuBr Laser; Electron Devices and Materials (EDM), Annual Siberian Russian Workshop; Micro/Nanotechnologies and Electron Devices
Autor: Petukhov T. D. Timofey Dmitrievich
Vydáno: (2019)
Autor: Petukhov T. D. Timofey Dmitrievich
Vydáno: (2019)
Optimization of the CuBr + Ne + HBr laser excitation source; Optical and Quantum Electronics; Vol. 57
Autor: Trigub M. V. Maksim Viktorovich
Vydáno: (2025)
Autor: Trigub M. V. Maksim Viktorovich
Vydáno: (2025)
High-speed process visualization using CuBr-laser; Micro/Nanotechnologies and Electron Devices (EDM)
Vydáno: (2012)
Vydáno: (2012)
CuBr laser for nanopowder production visualization; Atmospheric and Oceanic Optics; Vol. 29, iss. 4
Vydáno: (2016)
Vydáno: (2016)
High Pulse Repetition Frequency CuBr-laser; XIII International Symposium on Gas Flow and Chemical Lasers and High-Power Laser Conference,September 18, 2000, Florence, Italy
Vydáno: (2000)
Vydáno: (2000)
Study of scalability of capacitive excited CuBr lasers; Atmospheric and Oceanic Optics; Vol. 26, iss. 3
Vydáno: (2013)
Vydáno: (2013)
Studying of solid-state power supply unit of CuBr-laser; Micro/Nanotechnologies and Electron Devices (EDM)
Autor: Torgaev S. N. Stanislav Nikolaevich
Vydáno: (2011)
Autor: Torgaev S. N. Stanislav Nikolaevich
Vydáno: (2011)
Effect of hydrogen additives on characteristics of the CuBr laser; Physics of Wave Phenomena; Vol. 19, iss. 3
Autor: Boichenko A. M.
Vydáno: (2011)
Autor: Boichenko A. M.
Vydáno: (2011)
Полупроводниковый источник питания для CuBr-лазеров; Неразрушающий контроль
Autor: Бухаркин А. А. Андрей Андреевич
Vydáno: (2011)
Autor: Бухаркин А. А. Андрей Андреевич
Vydáno: (2011)
Operation of a Capacitive Pumped CuBr Laser in a Reduced Energy Deposition Mode; Electron Devices and Materials (EDM), Annual Siberian Russian Workshop; Micro/Nanotechnologies and Electron Devices (EDM)
Vydáno: (2020)
Vydáno: (2020)
Математическая модель CuBr-лазера; Вестник науки Сибири; № 4 (14)
Autor: Торгаев С. Н. Станислав Николаевич
Vydáno: (2014)
Autor: Торгаев С. Н. Станислав Николаевич
Vydáno: (2014)
Схема запуска для высокочастотного CuBr-лазера; Контроль. Диагностика; № 13
Vydáno: (2014)
Vydáno: (2014)
Gain characteristics of large volume CuBr laser active media; Optics Communications; Vol. 284, iss. 10-11
Vydáno: (2011)
Vydáno: (2011)
Podobné jednotky
-
Possibilities of increasing the efficiency of a double-pulsed excitation CuBr-laser; Atomic and molecular pulsed lasers
Autor: Fedorov A. I. Anatoly Ignatjevich
Vydáno: (2015) -
A CuBr laser with high efficiency in the double-pumping-pulse mode; Technical Physics Letters; Vol. 43, iss. 3
Autor: Fedorov A. I. Anatoly Ignatjevich
Vydáno: (2017) -
Low frequency CuBr-laser; Atomic and molecular pulsed lasers
Autor: Fedorov A. I. Anatoly Ignatjevich
Vydáno: (2015) -
Modeling of Capacitive Discharge Pumping of CuBr Laser Active Element; Atomic and Molecular Pulsed Lasers
Vydáno: (2011) -
The influence of the gas mixture content and pumping conditions on CuBr-laser performance; Atomic and Molecular Pulsed Lasers
Vydáno: (2005)