High-Strength Bioresorbable Fe-Ag Nanocomposite Scaffolds: Processing and Properties
| Parent link: | AIP Conference Proceedings Vol. 1683 : Advanced Materials with Hierarchical Structure for New Technologies and Reliable Structures.— 2015.— [020244, 7 p.] |
|---|---|
| Corporate Author: | Национальный исследовательский Томский политехнический университет (ТПУ) Институт физики высоких технологий (ИФВТ) Кафедра физики высоких технологий в машиностроении (ФВТМ) |
| Other Authors: | Sharipova A. Aliya, Psakhie S. G. Sergey Grigorievich, Swain S. K. Sanjaya, Gutmanas E. Y. Elazar, Gotman I. Irena |
| Summary: | Title screen High strength ductile iron-silver nanocomposite scaffolds were fabricated employing high energy attrition milling of micron-submicron powders, followed by cold sintering/high pressure consolidation. Particulate leaching method with soluble Na[2]SO[4] and K[2]CO[3] salts as porogens was used to create scaffolds with 50, 55, 60 and 73% volume fraction of pores. Part of specimens was annealed at 600, 800 and 900°С. Specimens were characterized employing X-ray diffraction, scanning electron microscopy (SEM) with electron probe microanalysis (EDS) and high resolution SEM. Mechanical properties were measured in compression and permeability was measured in permeameter based on Darcy's law. Scaffolds with 50% and 55% porosity exhibited high compressive strength (18-22 MPa), compressive strength of 8-12 MPa was observed for scaffolds with 73% porosity. Treatments at 800 and 900°С result in increase of strength and ductility with some coarsening of microstructure. Best combination of compressive strength (15 MPa) and permeability (0.6{-6} cm{2}) is close to the range of trabecular bone. Режим доступа: по договору с организацией-держателем ресурса |
| Published: |
2015
|
| Subjects: | |
| Online Access: | http://dx.doi.org/10.1063/1.4932934 |
| Format: | Electronic Book Chapter |
| KOHA link: | https://koha.lib.tpu.ru/cgi-bin/koha/opac-detail.pl?biblionumber=645033 |
Similar Items
Effect of a Novel Load-Bearing Trabecular Nitinol Scaffold on Rabbit Radius Bone Regeneration
Published: (2015)
Published: (2015)
Synthesis of Ti[3]SiC[2]-based composites by spark plasma sintering of preceramic papers
Published: (2019)
Published: (2019)
Obtaining molybdenum-copper composite for effective thermal control in electronic systems
by: Sivkov A. A. Aleksandr Anatolyevich
Published: (2017)
by: Sivkov A. A. Aleksandr Anatolyevich
Published: (2017)
The Effect of Deposition Parameters on Microstructure and Mechanical Properties of Ti-Al-Ta-N coatings
Published: (2018)
Published: (2018)
Formation and Properties of Biocoatings Based on Wollastonite and Calcium Phosphates
Published: (2015)
Published: (2015)
Получение нового TI-35Nb-7Zr-5Ta сплава методом электронно-лучевого плавления для медицинского применения
by: Мишукова О. И. Оксана Игоревна
Published: (2019)
by: Мишукова О. И. Оксана Игоревна
Published: (2019)
Bioresorbable Ca-Phosphate-Polymer/Metal and Fe-Ag Nanocomposites for Macro-Porous Scaffolds with Tunable Degradation and Drug Release
Published: (2016)
Published: (2016)
High-temperature oxidation resistance of Ti-implanted E110 alloy
Published: (2019)
Published: (2019)
Influence of dispersion state of initial AlN powder on the hydrolysis process in air environment
Published: (2016)
Published: (2016)
The Effect of Laser Treatment of WC-Co Coatings on Their Failure under Thermal Cycling
Published: (2016)
Published: (2016)
Искровое плазменное спекание ламинированных композитов из фольг Ta и прекерамических бумаг на основе MAX-фазы Ti3Al(Si)C2
by: Ляхова А. А.
Published: (2024)
by: Ляхова А. А.
Published: (2024)
Fracture Toughness and Oxidation Resistance of Ti-Al-N Coatings on Stainless Steel Substrates
Published: (2016)
Published: (2016)
Микроскопические методы исследования материалов
by: Кларк Э. Р.
Published: (Москва, Техносфера, 2007)
by: Кларк Э. Р.
Published: (Москва, Техносфера, 2007)
Effect of Fe Base Alloy Content in Ti-C-Fe Base Alloy Powder Mixtures on the SHS Products Structure
Published: (2016)
Published: (2016)
Drug Loaded Biodegradable Load-Bearing Nanocomposites for Damaged Bone Repair
Published: (2017)
Published: (2017)
Investigation of ceramics based on Cu-Sn powder obtained by plasma dynamic method
Published: (2017)
Published: (2017)
Изучение процесса окисления на поверхности Pt3Ti (510) методом сканирующей туннельной микроскопии
by: Курзина И. А.
Published: (2005)
by: Курзина И. А.
Published: (2005)
Effect of Ultradisperse TiO2, ZrO2, and Cryolite Powders on High-Chromium Cast Iron Hardening
Published: (2016)
Published: (2016)
Модифицирование поверхности полимерного сосудистого трансплантата путем осаждения TiSiN покрытий
by: Лаушкина А. А. Алина Алексеевна
Published: (2023)
by: Лаушкина А. А. Алина Алексеевна
Published: (2023)
Plasma dynamic synthesis of ultradispersed zinc oxide and sintering ceramics on its basis by SPS method
Published: (2017)
Published: (2017)
Mechanical Strength of Additive Manufactured Carbon Fiber Reinforced Polyetheretherketone
Published: (2016)
Published: (2016)
Preparation and structural stability of ordered nanocomposites: opal matrix - lead titanates
Published: (2016)
Published: (2016)
Методы сканирующей зондовой микроскопии при исследовании структуры и свойств органических материалов
by: Набиуллин И. Р.
Published: (Уфа, БГПУ имени М. Акмуллы, 2016)
by: Набиуллин И. Р.
Published: (Уфа, БГПУ имени М. Акмуллы, 2016)
The study on intermetallics formation during sintering of al with ZrW[2]O[8]
by: Shadrin V. S.
Published: (2016)
by: Shadrin V. S.
Published: (2016)
Correlation between surface properties and wettability of multi-scale structured biocompatible surfaces
Published: (2015)
Published: (2015)
Т. 2
Published: (2010)
Published: (2010)
Структура и свойства анодных пленок [Al2O3]
Published: (2004)
Published: (2004)
Peculiarities of structure and phase composition of V-Ti-Cr alloy obtained by sintering technique
Published: (2019)
Published: (2019)
Экспериментальные методы в исследовании конденсированного состояния (03.03.02) электронный курс
by: Панин А. В. Алексей Викторович
Published: (Томск, TPU Moodle, 2024)
by: Панин А. В. Алексей Викторович
Published: (Томск, TPU Moodle, 2024)
Основы сканирующей зондовой микроскопии учебное пособие для студентов старших курсов высших учебных заведений
by: Миронов В. Л. Виктор Леонидович
Published: (Нижний Новгород, ИФМ РАН, 2004)
by: Миронов В. Л. Виктор Леонидович
Published: (Нижний Новгород, ИФМ РАН, 2004)
Методы исследования структуры полупроводников и металлов учебное пособие
by: Бублик В. Т. Владимир Тимофеевич
Published: (Москва, Металлургия, 1978)
by: Бублик В. Т. Владимир Тимофеевич
Published: (Москва, Металлургия, 1978)
The Possibility of Boron Carbide Coating Formation by Using a Coaxial Magnetoplasma Accelerator
by: Sivkov A. A. Aleksandr Anatolyevich
Published: (2015)
by: Sivkov A. A. Aleksandr Anatolyevich
Published: (2015)
Analysis of Structure Destroyed Metal after Diffusion Heat Treatment
by: Apasov A. M. Aleksandr Mikhailovich
Published: (2016)
by: Apasov A. M. Aleksandr Mikhailovich
Published: (2016)
Phase Transformations in Nanostructured Coatings Based on Zr-Y-O and Produced by a Pulse Magnetron Sputtering Method
by: Fedorishcheva M. V. Marina Vladimirovna
Published: (2015)
by: Fedorishcheva M. V. Marina Vladimirovna
Published: (2015)
Specific features of Bazhenov suite sediments in south-eastern Nurolsk sedimentary basin (Tomsk Oblast)
Published: (2015)
Published: (2015)
Материаловедение: методы исследования структуры и состава материалов учебное пособие для академического бакалавриата
by: Суворов Э. В. Эрнест Витальевич
Published: (Москва, Юрайт, 2019)
by: Суворов Э. В. Эрнест Витальевич
Published: (Москва, Юрайт, 2019)
Scanning Electron Microscopy Study of Drilling Cuttings in Tomsk Oblast Sites
Published: (2019)
Published: (2019)
Исследование процесса окисления электровзрывного нанопорошка вольфрама в воздухе
by: Громов А. А. Александр Александрович
Published: (2003)
by: Громов А. А. Александр Александрович
Published: (2003)
Synthesis of Silicon Carbide in Hypervelocity Plasma Jet
Published: (2015)
Published: (2015)
Наноструктурированные строительные материалы учебник для вузов
by: Кодолов В. И.
Published: (Санкт-Петербург, Лань, 2024)
by: Кодолов В. И.
Published: (Санкт-Петербург, Лань, 2024)
Similar Items
-
Effect of a Novel Load-Bearing Trabecular Nitinol Scaffold on Rabbit Radius Bone Regeneration
Published: (2015) -
Synthesis of Ti[3]SiC[2]-based composites by spark plasma sintering of preceramic papers
Published: (2019) -
Obtaining molybdenum-copper composite for effective thermal control in electronic systems
by: Sivkov A. A. Aleksandr Anatolyevich
Published: (2017) -
The Effect of Deposition Parameters on Microstructure and Mechanical Properties of Ti-Al-Ta-N coatings
Published: (2018) -
Formation and Properties of Biocoatings Based on Wollastonite and Calcium Phosphates
Published: (2015)