The Influence of Initial Heat Treatment of Low-Carbon Steel Fe-Mo-Nb-V-C on Peculiarities of Ultrafine-Grained Structure in High-Pressure Torsion
| Parent link: | AIP Conference Proceedings Vol. 1683 : Advanced Materials with Hierarchical Structure for New Technologies and Reliable Structures.— 2015.— [020133, 5 p.] |
|---|---|
| مؤلف مشترك: | Национальный исследовательский Томский политехнический университет (ТПУ) Физико-технический институт (ФТИ) Кафедра общей физики (ОФ) |
| مؤلفون آخرون: | Maier G. Galina, Koshovkina V. S. Vera Sergeevna, Astafurova E. Elena, Melnikov E. Eugene, Naydenkin E. Eugene, Smirnov A. Alexander, Bataev V. Vladimir, Odessky P. Pavel, Dobatkin S. Sergey |
| الملخص: | Title screen The effect of initial heat treatment on peculiarities of ultrafine-grained structure and on homogeneity of strength properties (microhardness) through the specimens was studied in low-carbon steel Fe-Mo-Nb-V-C processed by high-pressure torsion. Three initial states, i.e. (I) normalized, (II) quenched and (III) quenched and tempered, with different morphologies and grain sizes were used. A noticeable effect of the initial state on characteristics of ultrafine-grained structure processed by high-pressure torsion was observed: decrease in the initial grain size causes more effective grain refinement and formation of higher value of microhardness in the middle part of disk radii (d[av]=1 nm and 700 HV for normilized state, d[av]=98 nm and 770 HV for quenched state and d[av]=100 nm and 600 HV for initial quenched and tempered state). Режим доступа: по договору с организацией-держателем ресурса |
| منشور في: |
2015
|
| الموضوعات: | |
| الوصول للمادة أونلاين: | http://dx.doi.org/10.1063/1.4932823 |
| التنسيق: | الكتروني فصل الكتاب |
| KOHA link: | https://koha.lib.tpu.ru/cgi-bin/koha/opac-detail.pl?biblionumber=644968 |
مواد مشابهة
The influence of heat treatment on homogeneity of strength properties and structural peculiarities of low-carbon steel Fe-Mo-Nb-V-C processed by high-pressure torsion
منشور في: (2014)
منشور في: (2014)
Влияние интенсивной пластической деформации на структурно-фазовое состояние стали со структурой отпущенного мартенсита
منشور في: (2017)
منشور في: (2017)
Microhardness Homogeneity and Microstructure of High-Nitrogen Austenitic Steel Processed by High-Pressure Torsion
منشور في: (2017)
منشور في: (2017)
Effect of Deformation and Heat Treatment on the Structure, the Mechanical Properties, and the Fracture Characteristics of an Ultrafine-Grained Zr-1Nb Alloy
منشور في: (2017)
منشور في: (2017)
Влияние отжигов на особенности зеренно-субзеренной структуры в стали 06МБФ, сформированной методом кручения на наковальнях Бриджмена
منشور في: (2015)
منشور في: (2015)
Dynamics of Friction Processes on Stainless Steel AISI 201 with Coarse and Ultrafine-Grained Structure
منشور في: (2018)
منشور في: (2018)
Regularities in Accumulation and Dissipation of Energy under Tension in Ti and Zr-1Nb Alloysin Coarse-Grained and Ultrafine-Grained States
منشور في: (2019)
منشور في: (2019)
Dynamic of Friction on Ultrafine-Grained Cu-Zn Brass
منشور في: (2018)
منشور في: (2018)
Effect of nonequilibrium hydrogen release in the ultrafine-grained Zr-1Nb alloy under the electron beam exposure
منشور في: (2016)
منشور في: (2016)
Dynamic Behavior of Friction Ultrafine-Grained AA5052
منشور في: (2018)
منشور في: (2018)
The Annealing Effect on Scratch Testing Behavior of Ultrafine-Grained Brass
منشور في: (2018)
منشور في: (2018)
Study on the Spatial Structure of Ultrafine-Grained Light Alloys by Microtomography
منشور في: (2015)
منشور في: (2015)
Количественная характеристика ультрамелкозернистой структуры стали 12ГБА с помощью сканирующей туннельной микроскопии
منشور في: (2016)
منشور في: (2016)
Hydrogen-induced failure of TiNi based alloy with coarse-grained and ultrafine-grained structure
منشور في: (2016)
منشور في: (2016)
Dynamics of Friction Processes on Al-Zn-Mg-Cu Alloy with Coarse-Grained or Ultrafine-Grained Structure
منشور في: (2018)
منشور في: (2018)
Temperature Dependence of Inelastic Strain Recovery in TiNi-Based Alloys under Torsion
منشور في: (2015)
منشور في: (2015)
Effect of temperature and pulsed electron beam irradiation on the grain boundary ensemble of the ultrafine-grained molybdenum
منشور في: (2016)
منشور في: (2016)
The Influence of Ultrafine-Grained State of Zr - 1 wt.% Nb and Ti - 45 wt.% Nb Alloys on their Thermophysical Properties and Energy Dissipation and Accumulation during Deformation
منشور في: (2021)
منشور في: (2021)
Meso- and Microstructural Features of Steel 12GBA Produced by Different Methods of Thermomechanical Treatment
منشور في: (2015)
منشور في: (2015)
Effect of Hydrogen on the Deformation Development in the Titanium Alloy with a Hierarchical Ultrafine-Grained Structure in the Temperature Range of 293-973 K
منشور في: (2019)
منشور في: (2019)
Research on the processes of deformation and failure in coarse- and ultrafine-grain states of Zr1–Nb alloys by digital image correlation and infrared thermography
منشور في: (2020)
منشور في: (2020)
Comparative Analysis of Inelastic Strain Recovery and Plastic Deformation in a Ti[49.1]Ni[50.9] (at %) Alloy under Torsion and Bending
منشور في: (2015)
منشور في: (2015)
Microstructure Stability and Mechanical Properties of Ultrafine-Grained Zirconium Alloy under Prolonged Thermal Exposure
منشور في: (2016)
منشور في: (2016)
The effect of annealing within a thermal stability intervalon peculiar properties of structure formed in steelFe-Mo-V-Nb-0.08С by high-pressure torsion
منشور في: (2015)
منشور في: (2015)
Lattice Curvature and Mesoscopic Strain-Induced Defects as the Basis of Plastic Deformation in Ultrafine-Grained Metals
حسب: Panin V. E. Viktor Evgenyevich
منشور في: (2018)
حسب: Panin V. E. Viktor Evgenyevich
منشور في: (2018)
Regular Features of Stage Formation in the Stress-strain Curves and Microstructure in the Zone of Fracture of Coarse-Grained and Ultrafine-Grained Titanium and Zirconium Alloys
منشور في: (2019)
منشور في: (2019)
Thin Bioactive Zn Substituted Hydroxyapatite Coating Deposited on Ultrafine-Grained Titanium Substrate: Structure Analysis
منشور في: (2018)
منشور في: (2018)
Measurement of ultrasonic velocity for strain evaluation of tensile stressed low carbon steel specimens
حسب: Shah R. T.
منشور في: ()
حسب: Shah R. T.
منشور في: ()
Effect of the structural and phase state on the deformation behavior and mechanical properties of the ultrafine-grained titanium alloy (Ti-Al-V-Мо) at temperatures in the range of 293-973 K
منشور في: (2021)
منشور في: (2021)
Electric arc surfacing on low carbon steel: structure and properties
منشور في: (2016)
منشور في: (2016)
Развитие деформационных процессов в субмикрокристаллическом сплаве ZR-1NB, легированном водородом
منشور في: (2015)
منشور في: (2015)
Electric Arc Surfacing on Low Carbon Steel: Structure and Properties
منشور في: (2016)
منشور في: (2016)
Микроструктура, механические свойства и термостабильность биоинертных сплавов Ti-45 мас. % Nb и Zr-1 МАС. % Nb в ультрамелкозернистом состоянии
منشور في: (2019)
منشور في: (2019)
Использование эффекта Видемана в машиностроении
حسب: Коверкин Ю. Б.
منشور في: (2003)
حسب: Коверкин Ю. Б.
منشور في: (2003)
Структура и термическая стабильность сплава Zr-1Nb в ультрамелкозернистом состоянии
حسب: Дубровская А. С.
منشور في: (2016)
حسب: Дубровская А. С.
منشور في: (2016)
Microstructure and mechanical properties of Ti40Nb alloy after severe plastic deformation
منشور في: (2014)
منشور في: (2014)
The Effect of Hydrogen on the Parameters of Plastic Deformation Localization in Low Carbon Steel
منشور في: (2014)
منشور في: (2014)
Структура и термическая стабильность сплава Zr-1Nb в ультрамелкозернистом состоянии
حسب: Дубровская А. С.
منشور في: (2016)
حسب: Дубровская А. С.
منشور في: (2016)
Влияние деформационного и термического воздействия на структуру, механические свойства и разрушение ультрамелкозернистого сплава Zr-1Nb
منشور في: (2016)
منشور في: (2016)
The nature of elastoplastic transition in low-carbon steel samples with and without welds
حسب: Danilova L. V.
منشور في: (2018)
حسب: Danilova L. V.
منشور في: (2018)
مواد مشابهة
-
The influence of heat treatment on homogeneity of strength properties and structural peculiarities of low-carbon steel Fe-Mo-Nb-V-C processed by high-pressure torsion
منشور في: (2014) -
Влияние интенсивной пластической деформации на структурно-фазовое состояние стали со структурой отпущенного мартенсита
منشور في: (2017) -
Microhardness Homogeneity and Microstructure of High-Nitrogen Austenitic Steel Processed by High-Pressure Torsion
منشور في: (2017) -
Effect of Deformation and Heat Treatment on the Structure, the Mechanical Properties, and the Fracture Characteristics of an Ultrafine-Grained Zr-1Nb Alloy
منشور في: (2017) -
Влияние отжигов на особенности зеренно-субзеренной структуры в стали 06МБФ, сформированной методом кручения на наковальнях Бриджмена
منشور في: (2015)