Influence of Crystal Defects on the Reflectivity of the Aluminum; Applied Mechanics and Materials; Vol. 756 : Mechanical Engineering, Automation and Control Systems (MEACS2014)

Influence of Crystal Defects on the Reflectivity of the Aluminum; Applied Mechanics and Materials; Vol. 756 : Mechanical Engineering, Automation and Control Systems (MEACS2014)

Bibliografske podrobnosti
Parent link:	Applied Mechanics and Materials: Scientific Journal Vol. 756 : Mechanical Engineering, Automation and Control Systems (MEACS2014).— 2015.— [P. 164-168]
Glavni avtor:	Umnov S. P. Sergey Pavlovich
Korporativna značnica:	Томский политехнический университет
Drugi avtorji:	Asainov O. Kh. Oleg Khaydarovich, Lemachko A. N.
Izvleček:	Title screen The effect of ion-assisted deposition of the Al films on their UV reflectance is investigated in this paper. The films' reflectance is measured by a spectrophotometer. The obtained films are examined by using transmission electron microscopy (TEM), X-ray diffraction analysis (XRD), and atomic force microscopy (AFM). The TEM and AFM measurements allow the determination of the size of crystallites in a film and its microstructure. The XRD analysis reveals that the films deposited with argon ion-beam assist are characterized by much higher microstress levels compared to the films deposited without ion assist. The comparison of the Al films’ reflectance measurements indicate that the films with a higher microstress level (hence, higher defect concentration) are characterized by the enhanced reflectance in the UV region. The conducted investigation shows that the defects of the Al films’ crystalline structure affect its optical properties. Режим доступа: по договору с организацией-держателем ресурса
Jezik:	angleščina
Izdano:	2015
Serija:	Material Engineering and Technologies
Teme:	электронный ресурс труды учёных ТПУ дефекты кристаллические решетки магнетронное распыление коэффициенты отражения
Online dostop:	http://dx.doi.org/10.4028/www.scientific.net/AMM.756.164
Format:	Elektronski Book Chapter
KOHA link:	https://koha.lib.tpu.ru/cgi-bin/koha/opac-detail.pl?biblionumber=641302

Podobne knjige/članki

Radiation-induced deposition of transparent conductive tin oxide coatings; IOP Conference Series: Materials Science and Engineering; Vol. 124 : Mechanical Engineering, Automation and Control Systems (MEACS2015)
od: Umnov S. P. Sergey Pavlovich
Izdano: (2016)

Study of Seismic Waves Cross-Phase Spectrum Information Properties on the Ground of a Bedded Geological Structure; Mechanical Engineering, Automation and Control Systems (MEACS)
od: Nguyen X. H. Xuan Hung
Izdano: (2015)

Modification of optical and electrical properties of SnO[2] under the influence of argon ion beam; Journal of Physics: Conference Series; Vol. 830 : Energy Fluxes and Radiation Effects 2016
od: Umnov S. P. Sergey Pavlovich
Izdano: (2017)

Change Spectrum Characteristics Modification of Films Deposited by Magnetron Sputtering with the Assistance of Argon Ions Beam; IOP Conference Series: Materials Science and Engineering; Vol. 81 : Radiation-Thermal Effects and Processes in Inorganic Materials
od: Umnov S. P. Sergey Pavlovich
Izdano: (2015)

Influence of Power Supply Energy Characteristics upon the Stability of MMA Process; Applied Mechanics and Materials; Vol. 756 : Mechanical Engineering, Automation and Control Systems (MEACS2014)
od: Ilyashchenko D. P. Dmitry Pavlovich
Izdano: (2015)

Investigation of physical and mechanical properties of biocompatible coatings based on silver-hydroxyapatite deposited by radio-frequency magnetron sputtering; Перспективы развития фундаментальных наук
od: Syromotina D. S.
Izdano: (2013)

Structure and Properties of Multicomponent Bronze Depending on the Crystallization Conditions; Applied Mechanics and Materials; Vol. 756 : Mechanical Engineering, Automation and Control Systems (MEACS2014)
od: Korchmit A. V. Anton Viktorovich
Izdano: (2015)

Mechanical Behavior of the Titania Nanotubes and Hydroxyapatite Coating Prepared On the Surface of Titanium; 11th International Forum on Strategic Technology (IFOST 2016); Pt. 1
Izdano: (2016)

Formation of Cr-Zr gradient layer by magnetron sputtering and ion mixing; MATEC Web of Conferences; Vol. 298 : International Conference on Modern Trends in Manufacturing Technologies and Equipment: Mechanical Engineering and Materials Science (ICMTMTE 2019)
Izdano: (2019)

Influence of proton irradiation on structure and mechanical properties of nanoscale multilayer metallic Zr/Nb coating; Перспективы развития фундаментальных наук; Т. 1 : Физика
od: Krotkevich D. Dmitry
Izdano: (2018)

Theoretical and Experimental Study of Led Luminaire; Applied Mechanics and Materials; Vol. 756 : Mechanical Engineering, Automation and Control Systems (MEACS2014)
od: Gurin S. Yu. Sergey Yurievich
Izdano: (2015)

Influence of Phase Composition on Properties of Corundum-Zirconium Ceramic; Applied Mechanics and Materials; Vol. 756 : Mechanical Engineering, Automation and Control Systems (MEACS2014)
od: Ivashutenko A. S. Alexander Sergeevich
Izdano: (2015)

The Influence of Grain Form on Effective Diffusion Coefficient of Polycrystalline; Applied Mechanics and Materials; Vol. 756 : Mechanical Engineering, Automation and Control Systems (MEACS2014)
od: Chepak-Gizbrekht M. V. Mariya Vladimirovna
Izdano: (2015)

The effect of Si content on structure and mechanical features of silicon-containing calcium phosphorus-based films deposited by rf-magnetron sputtering on titanium substrate treated by pulsed electron beam; The 9th International Forum on Strategic Techology (IFOST-2014), September 21-23, 2014, Cox's Bazar, Bangladesh
Izdano: (2014)

Modeling of Mechanical Behavior of Ceramic Nanocomposites; Applied Mechanics and Materials; Vol. 756 : Mechanical Engineering, Automation and Control Systems (MEACS2014)
Izdano: (2015)

Benchmark for FFT Libraries; Applied Mechanics and Materials; Vol. 756 : Mechanical Engineering, Automation and Control Systems (MEACS2014)
Izdano: (2015)

Prospects for Further Rock Cutting Mechanisms Development; Applied Mechanics and Materials; Vol. 756 : Mechanical Engineering, Automation and Control Systems (MEACS2014)
od: Novoseltseva M. V. Maria Viktorovna
Izdano: (2015)

Dynamic Susceptibility of a System; Applied Mechanics and Materials; Vol. 756 : Mechanical Engineering, Automation and Control Systems (MEACS2014)
od: Gerget O. M. Olga Mikhailovna
Izdano: (2015)

Thermally Conductive Polymeric Materials and their Usage in LED-Devices; Applied Mechanics and Materials; Vol. 756 : Mechanical Engineering, Automation and Control Systems (MEACS2014)
od: Lebedev S. M. Sergey Mikhailovich
Izdano: (2015)

Production Tribological Behavior Feature of Metallic Nanoparticle Additives; Applied Mechanics and Materials; Vol. 756 : Mechanical Engineering, Automation and Control Systems (MEACS2014)
od: Belyaev S. A. Sergey Aleksandrovich
Izdano: (2015)

Effect of pulsed electron beam treatment on the physico-mechanical properties of hydroxyapatite-coated titanium; Ceramics International; Vol. 42, iss. 1, pt. B
Izdano: (2016)

Электрический потенциал тонкого биоактивного покрытия на основе цинк-замещенного гидроксиапатита, полученного на титане методом ВЧ магнетронного распыления; Современные технологии и материалы новых поколений
od: Просолов К. А. Константин Александрович
Izdano: (2017)

Reduction of Metal Consumption in View of Mining Cutting Tools Operation; Applied Mechanics and Materials; Vol. 756 : Mechanical Engineering, Automation and Control Systems (MEACS2014)
od: Prokopenko S. A. Sergey Arturovich
Izdano: (2015)

An Application of Spark Plasma Sintering for Compaction of Refractory Oxides and Nitrides; Applied Mechanics and Materials; Vol. 756 : Mechanical Engineering, Automation and Control Systems (MEACS2014)
od: Matrenin S. V. Sergey Veniaminovich
Izdano: (2015)

Research Methods of Milling Technology Elements; Applied Mechanics and Materials; Vol. 756 : Mechanical Engineering, Automation and Control Systems (MEACS2014)
od: Gavrilin A. N. Aleksei Nikolaevich
Izdano: (2015)

Attenuation of Acoustic Waves in Metal Barriers; Applied Mechanics and Materials; Vol. 756 : Mechanical Engineering, Automation and Control Systems (MEACS2014)
od: Baganina A. E.
Izdano: (2015)

Tessellation Methods for Modeling the Material Structure; Applied Mechanics and Materials; Vol. 756 : Mechanical Engineering, Automation and Control Systems (MEACS2014)
Izdano: (2015)

Utilization Prospects of Coalbed Methane in Kuzbass; Applied Mechanics and Materials; Vol. 756 : Mechanical Engineering, Automation and Control Systems (MEACS2014)
Izdano: (2015)

Determination of Cutting Forces in Oblique Cutting; Applied Mechanics and Materials; Vol. 756 : Mechanical Engineering, Automation and Control Systems (MEACS2014)
od: Filippov A. V. Andrey Vladimirovich
Izdano: (2015)

Influence of the Shaper Design of Pneumohydraulic Impact Device on the Form and Duration of the Impact Impulse; Applied Mechanics and Materials; Vol. 756 : Mechanical Engineering, Automation and Control Systems (MEACS2014)
od: Angatkina O. O.
Izdano: (2015)

Исследование структуры покрытий, сформированных ВЧ-магнетронным распылением мишени из кремнийзамещённого гидроксиапатита; Перспективы развития фундаментальных наук; Т. 1
od: Грубова И. Ю. Ирина Юрьевна
Izdano: (2009)

Высокочастотное магнетронное распыление как способ получения тонких, сверхупругих, беспористых биопокрытий для медицины; Современные техника и технологии; Т. 1
od: Сурменев Р. А. Роман Анатольевич
Izdano: (2007)

Mechanical Behavior of Light Alloys with Bimodal Grain Size Distribution; Applied Mechanics and Materials; Vol. 756 : Mechanical Engineering, Automation and Control Systems (MEACS2014)
od: Skripnyak V. A. Vladimir Albertovich
Izdano: (2015)

Investigation of hydrogenation parameters influence on hydrogen sorption rate by Zr-1%Nb alloy with nickel layer; Известия вузов. Физика; Т. 58, № 9-3
Izdano: (2015)

Физико-механические характеристики ВЧ-магнетронных покрытий на основе серебросодержащего гидроксиапатита; Известия вузов. Физика; Т. 56, № 10
Izdano: (2013)

Влияние процесса распыления на структуру ВЧ-магнетронных тонких пленок; Перспективы развития фундаментальных наук
od: Шаронова А. А. Анна Александровна
Izdano: (2013)

The influence of changes in the composition of substrate on the mechanical properties of coatings; Mechanical Engineering, Automation and Control Systems (MEACS)
od: Ilina A. S.
Izdano: (2015)

The Reactive Deposition of TiO[x] Thin Films; Advanced Materials Research; Vol. 1040 : High Technology: Research and Applications 2014 (HTRA 2014)
od: Sidelev D. V. Dmitry Vladimirovich
Izdano: (2014)

Physical-Mechanical Characteristics of RF Magnetron Sputter-Deposited Coatings Based on Silver-Doped Hydroxyapatite; Russian Physics Journal; Vol. 56, iss. 10
Izdano: (2014)

Adaptive Structural Reconfigurable Algorithms of Control Abstract; Applied Mechanics and Materials; Vol. 756 : Mechanical Engineering, Automation and Control Systems (MEACS2014)
od: Shidlovskiy S. V. Stanislav Viktorovich
Izdano: (2015)