Possible application of carbon nanotubes to the field emission electron source for portable betatrons
| Parent link: | Nuclear Instruments and Methods in Physics Research Section A: Accelerators, Spectrometers, Detectors and Associated Equipment: Scientific Journal Vol. 539, iss. 1-2.— 2005.— [P. 16-24] |
|---|---|
| Other Authors: | Takehiro Ohnishi, Ichita Endo, Kenji Hayashi, Akitsugu Kohara, Takuo Yoshida, Chakhlov G. L. Gennady Lukyanovich, Malikov E. L. Evgeny Lvovich (L'vovich), Naydukov A. P. Aleksey Petrovich, Toshikazu Ekino, Fumitaka Nishiyama |
| Summary: | Title screen In order to study the feasibility of a carbon nanotube-based electron gun for small and portable betatrons, the characteristics of electron emission from carbon nanotubes were measured at around ?1?10?4 Pa, a typical pressure in the vacuum chamber of such betatrons. The sample cathodes were made from powders of single-walled nanotube (SWNT) and multi-walled nanotube (MWNT) that were fixed on the stainless steel plate with gold paste. We found that the emission was weaker at the lower vacuum for both MWNT and SWNT. However, when the vacuum level was restored to ?1?10?4 Pa after being kept at 4.0?10?4 Pa for 15 minutes, the emission-current recovered to some extent but did not fully come back to the original value. The observed current densities from SWNT and MWNT are 550 and 540 ?A/mm2, respectively, at the high-voltage we tried: 2 kV for SWNT and 1.1 kV for MWNT across a 300 ?m gap. It is likely that the carbon nanotube, under the pulsed operation, has advantages over the thermal cathode for the electron emitters of portable betatrons. Режим доступа: по договору с организацией-держателем ресурса |
| Published: |
2005
|
| Subjects: | |
| Online Access: | http://www.sciencedirect.com/science/article/pii/S0168900204021898 |
| Format: | Electronic Book Chapter |
| KOHA link: | https://koha.lib.tpu.ru/cgi-bin/koha/opac-detail.pl?biblionumber=637795 |
Similar Items
Boundary of electron beam release in betatron with comb-type poles
by: Ivanilova T. S.
Published: (2007)
by: Ivanilova T. S.
Published: (2007)
Simulation of injection and capture of beam electrons in small-size betatrons by the method of macroparticles
by: Grigoriev V. P.
Published: (2007)
by: Grigoriev V. P.
Published: (2007)
Investigation of the characteristics of the explosive-emission cathode based on carbon fiber in pulsed-periodic electron beam generation
Published: (2022)
Published: (2022)
Sensitivity of detection of micro-objects in radiography of thick composite steel objects using a new source of microfocus bremsstrahlung based on a betatron
by: Rychkov M. M. Maksim Mikhailovich
Published: (2023)
by: Rychkov M. M. Maksim Mikhailovich
Published: (2023)
A new approach to the economic synthesis of multi-walled carbon nanotubes using a Ni/MgO catalyst
Published: (2021)
Published: (2021)
Boron Nitride Nanotubes Versus Carbon Nanotubes: A Thermal Stability and Oxidation Behavior Study
Published: (2020)
Published: (2020)
Generation of Hard Bremsstrahlung at the Grazing Incidence of 18-MeV Electrons of a Betatron Beam on the Surface of Тa Foil 13 µm Thick
Published: (2019)
Published: (2019)
Simulation of electron field emission from the surface of ionic crystals under irradiation by pulsed electron beam
by: Stepanov S. A. Sergey Aleksandrovich
Published: (2012)
by: Stepanov S. A. Sergey Aleksandrovich
Published: (2012)
Partial Auxeticity of Laterally Compressed Carbon Nanotube Bundles
Published: (2021)
Published: (2021)
Computation of the impedance of a vacuum electron diode with emission current delay
by: Egorov I. S. Ivan Sergeevich
Published: (2019)
by: Egorov I. S. Ivan Sergeevich
Published: (2019)
Mechanical and Rheological Properties of Biodegradable Polycaprolactone/Carbon Nanotube Composites
by: Lebedev S. M. Sergey Mikhailovich
Published: (2020)
by: Lebedev S. M. Sergey Mikhailovich
Published: (2020)
Integration of Carbon Nanotubes in an HFCVD Diamond Synthesis Process in a Methane-Rich H2/CH4 Gas Mixture
Published: (2023)
Published: (2023)
Wear-resistant polyetheretherketone composites with carbon nano- and microfibers
Published: (2018)
Published: (2018)
Graphene nanoribbon winding around carbon nanotube
Published: (2017)
Published: (2017)
Investigation of charge balance in diode unit of pulse electron accelerator
by: Pushkarev A. I. Aleksandr Ivanovich
Published: (2007)
by: Pushkarev A. I. Aleksandr Ivanovich
Published: (2007)
The influence of single-walled carbon nanotubes additives on the structure and hydrogenation behavior of magnesium hydride
Published: (2025)
Published: (2025)
Biodegradable Electrically Conductive Polycaprolacton-Based Composites Filled with Carbon Nanotubes
by: Lebedev S. M. Sergey Mikhailovich
Published: (2020)
by: Lebedev S. M. Sergey Mikhailovich
Published: (2020)
Effect of Carbon Nanotubes and Graphene Nanoplatelets on the Mechanical Properties of Zirconia-Based Composites
Published: (2020)
Published: (2020)
Формирование дозного поля электронного пучка с помощью пластикового компенсатора
Published: (2018)
Published: (2018)
The effect of powder aggregates, carbon nanotubes and surfactants on the kinetics of synthesis and dissociation of gas hydrates
Published: (2025)
Published: (2025)
Positron Annihilation in a Composite Based on Magnesium Hydride and Carbon Nanotubes during Dehydrogenation
Published: (2022)
Published: (2022)
Mechanical Response of Carbon Nanotube Bundle to Lateral Compression
Published: (2020)
Published: (2020)
N-functionalized hierarchical carbon composite derived from ZIF-67 and carbon foam for efficient overall water splitting
Published: (2022)
Published: (2022)
Enhancement of mechanical and electrical properties of epoxy-based composites filled with intact or oxidized carbon nanotubes
Published: (2019)
Published: (2019)
Chain Model for Carbon Nanotube Bundle under Plane Strain Conditions
Published: (2019)
Published: (2019)
A Combined Model of Charging of the Surface and Bulk of a Dielectric Target by Electrons with the Energies 10–30 keV
by: Zykov V. M. Vladimir Mikhailovich
Published: (2018)
by: Zykov V. M. Vladimir Mikhailovich
Published: (2018)
Electromagnetic field features at interaction of relativistic electron with matter
Published: (2011)
Published: (2011)
Combined device for vacuum electron diode adjustment
by: Egorov I. S. Ivan Sergeevich
Published: (2018)
by: Egorov I. S. Ivan Sergeevich
Published: (2018)
Repetitive source of pulsed electron beams
Published: (2012)
Published: (2012)
Data on the structure, chemical state of carbon and discharge characteristics of multi-walled carbon nanotubes and composites based on them modified by pulsed ion beam
Published: (2019)
Published: (2019)
Thermal Stability and Flammability of Epoxy Composites Filled with Multi-Walled Carbon Nanotubes, Boric Acid, and Sodium Bicarbonate
Published: (2021)
Published: (2021)
Pressure and Temperature Effect on Hydrogen Sorption of Carbon Material
by: Gulidova L. V. Ludmila Vladimirovna
Published: (2015)
by: Gulidova L. V. Ludmila Vladimirovna
Published: (2015)
Thermal Behavior and Flammability of Epoxy Composites Based on Multi-Walled Carbon Nanotubes and Expanded Graphite: A Comparative Study
Published: (2020)
Published: (2020)
An investigation of the Cherenkov X-rays from relativistic electrons
Published: (2005)
Published: (2005)
Variation of Vickers microhardness and compression strength of the bioceramics based on hydroxyapatite by adding the multi-walled carbon nanotubes
Published: (2019)
Published: (2019)
Optical Absorption Imaging by Photothermal Expansion with 4 nm Resolution
Published: (2018)
Published: (2018)
Controlling the Specimen Surface Temperature During Irradiation With a Submillisecond Electron Beam Produced by a Plasma-Cathode Electron Source
Published: (2021)
Published: (2021)
Synthesis and characterization of carbon nanomaterials functionalized by direct treatment with sulfonating agents
Published: (2020)
Published: (2020)
The Effect of High-Energy Ball Milling Conditions on Microstructure and Hydrogen Desorption Properties of Magnesium Hydride and Single-Walled Carbon Nanotubes
by: Kudiyarov V. N. Victor Nikolaevich
Published: (2021)
by: Kudiyarov V. N. Victor Nikolaevich
Published: (2021)
Formation of Pulsed-Periodic Beam of Metal Ions of Submillisecond Duration with High Power Density
by: Ryabchikov A. I. Aleksandr Ilyich
Published: (2025)
by: Ryabchikov A. I. Aleksandr Ilyich
Published: (2025)
Similar Items
-
Boundary of electron beam release in betatron with comb-type poles
by: Ivanilova T. S.
Published: (2007) -
Simulation of injection and capture of beam electrons in small-size betatrons by the method of macroparticles
by: Grigoriev V. P.
Published: (2007) -
Investigation of the characteristics of the explosive-emission cathode based on carbon fiber in pulsed-periodic electron beam generation
Published: (2022) -
Sensitivity of detection of micro-objects in radiography of thick composite steel objects using a new source of microfocus bremsstrahlung based on a betatron
by: Rychkov M. M. Maksim Mikhailovich
Published: (2023) -
A new approach to the economic synthesis of multi-walled carbon nanotubes using a Ni/MgO catalyst
Published: (2021)