Engineering support for improving quality of layer-by-layer laser sintering
| Parent link: | The 7th International Forum on Strategic Technology (IFOST-2012), September 18-21, 2012, Tomsk: [proceedings]/ National Research Tomsk Polytechnic University (TPU). [4 p.].— , 2012 |
|---|---|
| Päätekijä: | |
| Muut tekijät: | |
| Yhteenveto: | Title screen Improvement problem has been considered for a laser sintered surface layer. Purposely built experimental setup was decribed together with a four-factor experiment design on laser sintering PMS-1 copper powder. A mathematical model describing the effect of laser sintering process parameters on the surface roughness has been proposed. Practical recommendation for improving the quality of the surface layer is given. Режим доступа: по договору с организацией-держателем ресурса |
| Julkaistu: |
2012
|
| Aiheet: | |
| Linkit: | http://dx.doi.org/10.1109/IFOST.2012.6357719 |
| Aineistotyyppi: | Elektroninen Kirjan osa |
| KOHA link: | https://koha.lib.tpu.ru/cgi-bin/koha/opac-detail.pl?biblionumber=636294 |
| Yhteenveto: | Title screen Improvement problem has been considered for a laser sintered surface layer. Purposely built experimental setup was decribed together with a four-factor experiment design on laser sintering PMS-1 copper powder. A mathematical model describing the effect of laser sintering process parameters on the surface roughness has been proposed. Practical recommendation for improving the quality of the surface layer is given. Режим доступа: по договору с организацией-держателем ресурса |
|---|---|
| DOI: | 10.1109/IFOST.2012.6357719 |