Wear and friction of transformation-toughened CMC and MMC; Wear; Vol. 249, iss. 10-11

Wear and friction of transformation-toughened CMC and MMC; Wear; Vol. 249, iss. 10-11

Մատենագիտական մանրամասներ
Parent link:	Wear: Scientific Journal Vol. 249, iss. 10-11.— 2001.— [P. 892-900]
Այլ հեղինակներ:	Savchenko N. L. Nikolai Leonidovich, Korolev P. V., Melnikov A. G. Alexander Grigorievich, Tarasov S. Yu. Sergei Yulievich, Kulkov S. N. Sergey Nikolaevich
Ամփոփում:	Title screen The sliding wear properties of transformation-toughened CMC and MMC coupled with high-speed steel have been studied at speeds in the range 0.9–9.4 m/s for MMC and 0.2–11.1 m/s for CMC and at a pressure of 5 MPa. It was shown that at low sliding speeds (0.2–4 m/s), both friction coefficient and wear rate of the yttria-doped tetragonal zirconia polycrystal ceramics (Y-TZP) increased with sliding speed and then decreased after reaching the maximum. The wear rate of TiC–NiTi increases with the increase in the sliding speed in the range of 0.9–9.4 m/s, whereas the friction coefficient followed an inverse trend. At low speeds, the tribological behavior of both ceramics and hard was controlled by the action of the transformation-toughening mechanism. In case of ceramics, a continuous transfer layer formed to serve as a protective transfer layer on the specimen surface during high-speed wear. In case of TiC–NiTi, softened or even melted binder is extruded from an interparticle area onto pin/disk interface and thus determines wear behavior of such a system at sliding speed higher than 4 m/s Режим доступа: по договору с организацией-держателем ресурса
Լեզու:	անգլերեն
Հրապարակվել է:	2001
Խորագրեր:	электронный ресурс труды учёных ТПУ wear износ transformation-toughened materials трансформация упрочняющие материалы zirconium цирконий adhesion адгезия transfer layer слои
Առցանց հասանելիություն:	http://dx.doi.org/10.1016/S0043-1648(01)00822-5
Ձևաչափ:	Էլեկտրոնային Գրքի գլուխ
KOHA link:	https://koha.lib.tpu.ru/cgi-bin/koha/opac-detail.pl?biblionumber=636229

Նմանատիպ նյութեր

Effect of grain size and amount of zirconia on the physical and mechanical properties and the wear resistance of zirconia-toughened alumina; Ceramics International; Vol. 46, iss. 7
Հրապարակվել է: (2020)

Alloying contact zones by metallic nanopowders in sliding wear; Wear; Vol. 257, iss. 5-6
‌: Tarasov S. Yu. Sergei Yulievich
Հրապարակվել է: (2004)

Transition between Modes of Adhesion and Sliding Friction in Contacts of Axially Symmetric Bodies; Journal of Friction and Wear; Vol. 40, iss. 1
‌: Lyashenko Ya. A. Yakov Aleksandrovich
Հրապարակվել է: (2019)

Acoustic emission characterization of sliding wear under condition of direct and inverse transformations in low-temperature degradation aged Y-TZP and Y-TZP-AL2O3; Friction; Vol. 6, iss. 3
Հրապարակվել է: (2018)

Limiting shape due to fretting wear in an adhesive contact in Dugdale approximation; Physical Mesomechanics; Vol. 19, iss. 4
‌: Chai Y. S.
Հրապարակվել է: (2016)

Subsurface layer formation during sliding friction; Wear; Vol. 249, iss. 10-11
Հրապարակվել է: (2001)

Subsurface structural evolution and wear lip formation on copper single crystals under unlubricated sliding conditions; Wear; Vol. 410-411
Հրապարակվել է: (2018)

High Performance Polymer Composites: A Role of Transfer Films in Ensuring Tribological Properties-A Review; Polymers; Vol. 14, iss. 5
‌: Panin S. V. Sergey Viktorovich
Հրապարակվել է: (2022)

Design of Wear-Resistant UHMWPE-Based Composites Loaded with Wollastonite Microfibers Treated with Various Silane Coupling Agents; Applied Sciences; Vol. 10, iss. 13
Հրապարակվել է: (2020)

Contact Properties and Adhesion of Incompressible Power-Law Gradient Media with High Gradients; Physical Mesomechanics; Vol. 21, iss. 1
‌: Popov V. L. Valentin Leonidovich
Հրապարակվել է: (2018)

Overcoming Stability and Substrate Adhesion Challenges by Laser-Induced Transfer of MXenes; ACS Applied Materials and Interfaces; Vol. 17, iss. 50
Հրապարակվել է: (2025)

Properties of Nanocomposite Nickel-Carbon Films Deposited by Magnetron Sputtering; Russian Physics Journal; Vol. 60, iss. 8
Հրապարակվել է: (2018)

Combined Method of Cutting Tool Treatment; Surface Modification of Materials by Ion Beams (SMMIB-2019)
‌: Tarbokov V. A. Vladislav Aleksandrovich
Հրապարակվել է: (2019)

Hydrogen Sorption Kinetics of SiC-Coated Zr-1Nb Alloy; Coatings; Vol. 9, iss. 1
Հրապարակվել է: (2019)

On the Hydrogen Permeability and Adhesion of TiN/Ti Coatings Produced on Zr-1% Nb Alloy by Vacuum Ion-Plasma Methods; Journal of Surface Investigation. X-ray, Synchrotron and Neutron Techniques; Vol. 14, iss. 5
Հրապարակվել է: (2020)

Рассеяние энергии и адгезионные свойства квазигерцевского контакта материалов с памятью формы; Известия Томского политехнического университета [Известия ТПУ]; Т. 323, № 2 : Математика и механика. Физика
Հրապարակվել է: (2013)

On the possibility of frictional damping with reduced wear: A note on the applicability of archards law of adhesive wear under conditions of fretting; Physical Mesomechanics; Vol. 21, iss. 1
‌: Li Qiang
Հրապարակվել է: (2018)

The effect of pulsed electron beam melting on microstructure, friction and wear of WC–Hadfield steel hard metal; Wear; Vol. 257, iss. 1-2
Հրապարակվել է: (2004)

Influence of Plasma-Immersion Titanium-Ion Implantation on the Kinetics of Hydrogen Penetration into E110 Zirconium Alloy; Journal of Surface Investigation. X-ray, Synchrotron and Neutron Techniques; Vol. 12, No. 3
Հրապարակվել է: (2018)

Theoretical and technological basics of the friction Units’ resource increasing; Solid State Phenomena; Vol. 303
Հրապարակվել է: (2020)

Effect of friction on subsurface layer microstructure in austenitic and martensitic steels; Wear; Vol. 231, iss. 2
‌: Tarasov S. Yu. Sergei Yulievich
Հրապարակվել է: (1999)

Adhesive contact of rough brushes; Beilstein Journal of Nanotechnology; Vol. 9, iss. 1
‌: Li Qiang
Հրապարակվել է: (2018)

Transformation of Acoustic Pulses into Electromagnetic Signals in Defective Structures; Journal of Nondestructive Evaluation; Vol. 39
Հրապարակվել է: (2020)

Effects of sintering curves on microstructure, physical and mechanical properties and on low temperature degradation of zirconia-toughened alumina; Journal of the European Ceramic Society; Vol. 41, iss. 16
Հրապարակվել է: (2021)

On the Gas-Phase Hydrogenation of E110 Zirconium Alloy with a Chromium Coating; Journal of Surface Investigation. X-ray, Synchrotron and Neutron Techniques; Vol. 18
Հրապարակվել է: (2024)

Sapropel-based supports as novel macroporous carbon-mineral adsorbents for enzymatic active substances; Resource-Efficient Technologies; Vol. 2, Iss. 4
Հրապարակվել է: (2016)

Interfacial Distribution of Chemical Elements in Fe–Cr–V–Mn–C Coatings Produced by Electron-Beam Cladding in Vacuum; Russian Physics Journal; Vol. 65, iss. 1
‌: Galchenko N. K. Nina Konstantinovna
Հրապարակվել է: (2023)

Effect of Adhesion on Mechanical and Tribological Properties of Glass Fiber Composites, Based on Ultra-High Molecular Weight Polyethylene Powders with Various Initial Particle Sizes; Materials; Vol. 13, iss. 3
Հրապարակվել է: (2020)

Structure, mechanical and tribological properties of Ti-doped and Cr-doped a-C:H:SiOx coatings; Vacuum; Vol. 219, Pt. A
Հրապարակվել է: (2024)

Свойства полимерных композитов на основе поливинилового спирта; Известия Томского политехнического университета [Известия ТПУ]; Т. 325, № 3 : Химия и химические технологии
‌: Труфакина Л. М. Людмила Михайловна
Հրապարակվել է: (2014)

Influence of the Substrate Material on the Formation and Properties of Micro-Arc Coatings with Particles of β-Tricalcium Phosphate; Russian Physics Journal; Vol. 65, iss. 6
Հրապարակվել է: (2022)

Adhesive impact of an elastic sphere with an elastic half space: Numerical analysis based on the method of dimensionality reduction; Mechanics of Materials; Vol. 92
‌: Lyashenko Ya. A. Yakov Aleksandrovich
Հրապարակվել է: (2016)

Свойства полимерных композитов на основе поливинилового спирта с наполнителем - наночастицами меди; Известия Томского политехнического университета [Известия ТПУ]. Инжиниринг георесурсов; Т. 326, № 6
‌: Труфакина Л. М. Людмила Михайловна
Հրապարակվել է: (2015)

Reception of two and three-phase combined dispersive systems with the use of centrifugal mixer; Procedia Chemistry; Vol. 10 : Chemistry and Chemical Engineering in XXI century
Հրապարակվել է: (2014)

Differential equation for tool wear; Russian Engineering Research; Vol. 34, iss. 12
‌: Petrushin S. I. Sergey Ivanovich
Հրապարակվել է: (2015)

Synthesis of Technical Ceramics in a Beam of Fast Electrons; Russian Physics Journal; Vol. 66, iss. 4
Հրապարակվել է: (2023)

Influence of SiO2 micro-particles onto microstructure, mechanical properties and wear resistance of uhmwpe based composite under dry sliding friction; Высокие технологии в современной науке и технике (ВТСНТ-2017)
Հրապարակվել է: (2017)

A comparison study between electrospun polycaprolactone and piezoelectric poly(3-hydroxybutyrate-co-3-hydroxyvalerate) scaffolds for bone tissue engineering; Colloids and Surfaces B: Biointerfaces; Vol. 157
Հրապարակվել է: (2017)

Improvement of Mechanical Properties and Adhesion of Ti-Al-Si-N Coatings by Alloying with Ta; Lubricants; Vol. 10 iss. 8
Հրապարակվել է: (2022)

Возможности лигносульфонатов для извлечения минералов из природных руд методом флотации; Известия Томского политехнического университета [Известия ТПУ]. Инжиниринг георесурсов; Т. 336, № 4
‌: Тептерева Г. А. Галина Алексеевна
Հրապարակվել է: (2025)