An experimental analysis of quenching of continuously heated vertical rod with aqueous Al2O3 nanofluid
| Parent link: | Resource-Efficient Technologies: electronic scientific journal/ National Research Tomsk Polytechnic University (TPU).— , 2015-.— 2405-6537 Vol. 3, iss. 4.— 2017.— [P. 378-384] |
|---|---|
| Other Authors: | Nirupama Patraa, Vivek Guptab, Ravi Singhb, Singha R. S., Pradyumna Ghoshb, Arun Nayakc |
| Summary: | Title screen Quenching characteristics of metallic vertical rod with an internal heater has been investigated in pure water and water-based nanofluid with alumina nanoparticles of 0.001% by volume. Initial temperature of the testing rod (12 mm diameter and 1000 mm length) ranges from 200 °C to 250 °C. The internal heater may be used to simulate the decay heat generated by the nuclear fuel rod after the power plant shutdown. Tests have been performed with varied range of experimental conditions of decay heat, constant water and nanofluid flow rates. The cooling curves follow a general trend of a rapid temperature drop up to almost 100 °C of the rod surface temperature irrespective of the operating parameters and the location of the thermocouple. The obtained results during quenching process indicated that HTC (heat transfer coefficient) for nanofluids are more than de-ionized water. It was also observed that in identical circumstances, the quenching time of the specimen in Al2O3 nanofluid considerably decreased as compared to water. The results exhibit that nanofluids can enhance the reflood heat transfer performance in terms of quenching rate for a long vertical rod causing liquid-droplets-induced depositions of nanoparticles resulting in making a pre-coating effect characterized by higher wettability. |
| Published: |
2017
|
| Subjects: | |
| Online Access: | http://earchive.tpu.ru/handle/11683/50317 |
| Format: | Electronic Book Chapter |
| KOHA link: | https://koha.lib.tpu.ru/cgi-bin/koha/opac-detail.pl?biblionumber=575702 |
Similar Items
Кинетика реакторов на быстрых нейтронах
by: Селезнев Е. Ф. Евгений Федорович
Published: (Москва, Наука, 2013)
by: Селезнев Е. Ф. Евгений Федорович
Published: (Москва, Наука, 2013)
Heat transfer of fuel assemblies with four rods
by: Коротких А. Г. Александр Геннадьевич
Published: (2022)
by: Коротких А. Г. Александр Геннадьевич
Published: (2022)
Changes in the state of heat-resistant steel induced by repeated hot deformation
Published: (2018)
Published: (2018)
Комбинирование АЭС с многофункциональными энергетическими установками
by: Аминов Р. З. Рашид Зарифович
Published: (Москва, Наука, 2018)
by: Аминов Р. З. Рашид Зарифович
Published: (Москва, Наука, 2018)
Processing of heavy residual feedstock on Mo/Al[2]O[3]-catalytic systems obtained using polyoxomolybdate compounds
Published: (2019)
Published: (2019)
Influence of Al-Si-N interlayer on residual stress of CVD diamond coatings
by: Gaydaychuk A. V. Alexander Valerievich
Published: (2019)
by: Gaydaychuk A. V. Alexander Valerievich
Published: (2019)
Обеспечение радиационной безопасности персонала и населения, охрана окружающей среды при эксплуатации АЭС учебное пособие
by: Акатов А. А.
Published: (Санкт-Петербург, СПбГТИ (ТУ), 2020)
by: Акатов А. А.
Published: (Санкт-Петербург, СПбГТИ (ТУ), 2020)
Определение остаточных напряжений при пластическом деформировании методом электротензометрии
by: Анфилофьев А. В.
Published: (1972)
by: Анфилофьев А. В.
Published: (1972)
Conjugate Heat Transfer in a Closed Volume with the Local Heat Sources and Non-Uniform Heat Dissipation on the Boundaries of Heat Conducting Walls
by: Maksimov V. I. Vyacheslav Ivanovich
Published: (2016)
by: Maksimov V. I. Vyacheslav Ivanovich
Published: (2016)
Using differential microcalorimeter new design with heat dissipation study in dispersed systems
by: Lotov V. A. Vasiliy Agafonovich
Published: (2016)
by: Lotov V. A. Vasiliy Agafonovich
Published: (2016)
Контроль остаточной намагниченности деталей перед проведением сварочных работ
by: Бакунов А. С.
Published: (2004)
by: Бакунов А. С.
Published: (2004)
Управление формированием остаточных напряжений при изготовлении ответственных деталей
by: Киселев Е. С.
Published: (Санкт-Петербург, Лань, 2022)
by: Киселев Е. С.
Published: (Санкт-Петербург, Лань, 2022)
Model of oxygen cutting of a metal plate with chemical heat release
by: Anisimova M. A. Mariya Aleksandrovna
Published: (2016)
by: Anisimova M. A. Mariya Aleksandrovna
Published: (2016)
Contributions of Various Mechanisms to the Hardening of Differentially Quenched Rails during Long-Term Operation
Published: (2018)
Published: (2018)
Оценка остаточного содержания Cs-137 на территории Томского района, подвергшегося выпадению радионуклидов
by: Бектенов Д. Е.
Published: (2023)
by: Бектенов Д. Е.
Published: (2023)
Простой термостабилизатор
by: Цибин В.
Published: (2003)
by: Цибин В.
Published: (2003)
Analyzing patterns of heat generated by the tensile loading of steel rods containing discontinuity-like defects
by: Moyseychik E. Eugeny
Published: (2017)
by: Moyseychik E. Eugeny
Published: (2017)
Вып. 18
Published: (Москва, Редакция литературы по черной и цветной металлургии, 1939)
Published: (Москва, Редакция литературы по черной и цветной металлургии, 1939)
Natural convection in a trapezoidal cavity filled with a micropolar fluid under the effect of a local heat source
by: Miroshnichenko I. V.
Published: (2017)
by: Miroshnichenko I. V.
Published: (2017)
Регламентация режимов шлифования с учётом субструктурных и структурно-фазовых превращений в материале поверхностного слоя
by: Драпкин Б. М.
Published: (2003)
by: Драпкин Б. М.
Published: (2003)
Асимптотический анализ системы M^[n]/GI/1 с учетом остаточного времени обслуживания
by: Назаров А. А. Анатолий Андреевич
Published: (2024)
by: Назаров А. А. Анатолий Андреевич
Published: (2024)
Установки индукционного нагрева учебное пособие
by: Немков В. С.
Published: (Красноярск, СФУ, 2018)
by: Немков В. С.
Published: (Красноярск, СФУ, 2018)
Микротермостат с совмещёнными нагревателем и датчиком температуры
by: Куликов В. А.
Published: (2002)
by: Куликов В. А.
Published: (2002)
Расчет и конструирование нагревателей электропечей сопротивления
Published: (Москва, Энергия, 1966)
Published: (Москва, Энергия, 1966)
Термокаталитическое превращение тяжелого остаточного сырья в присутствии полиоксомолибдатных соединений
Published: (2018)
Published: (2018)
Прогнозирование степени дезактивации катализатора крекинга при переработке вакуумного газойля и его смесей с легким газойлем коксования и остатками масляного производства
Published: (2021)
Published: (2021)
Расчет электрического нагревателя сопротивления применительно к сварке труб в монтажных условиях
Published: ( 1972)
Published: ( 1972)
Чудо-стельки
Published: (2014)
Published: (2014)
Convective Heat Transfer in a Vertical Rectangular Duct Filled with a Nanofluid
by: Umavathi J. C.
Published: (2016)
by: Umavathi J. C.
Published: (2016)
Mathematical modelling of conjugate heat transfer and fluid flow inside a domain with a radiant heating system
by: Kuznetsov G. V. Geny Vladimirovich
Published: (2018)
by: Kuznetsov G. V. Geny Vladimirovich
Published: (2018)
Вопросы оценки качества сварки полиэтиленовых труб с применением муфт с закладными нагревателями
by: Соколов В. А.
Published: (2004)
by: Соколов В. А.
Published: (2004)
Низкотемпературные нагреватели из композиционных материалов в промышленности и быту
by: Горелов В. П. Валерий Павлович
Published: (Москва, Энергоатомиздат, 1995)
by: Горелов В. П. Валерий Павлович
Published: (Москва, Энергоатомиздат, 1995)
Simulation of Intermetallic Synthesis in a Cylindrical Mold under Induction Heating
by: Bukrina N. V.
Published: (2018)
by: Bukrina N. V.
Published: (2018)
Общеобменная вентиляция цехов с тепловыделениями
by: Акинчев Н. В. Николай Васильевич
Published: (Москва, Стройиздат, 1984)
by: Акинчев Н. В. Николай Васильевич
Published: (Москва, Стройиздат, 1984)
Control rod calibration simulation using Monte Carlo code for the IRT-type research reactor
Published: (2016)
Published: (2016)
Transversal vibrations of elastic rod in magnetic field under simultaneous kinematic and force action
by: Tomilin A. K. Aleksander Konstantinovich
Published: (2017)
by: Tomilin A. K. Aleksander Konstantinovich
Published: (2017)
Прочность стекла сборник статей пер. с англ.
Published: (Москва, Мир, 1969)
Published: (Москва, Мир, 1969)
Конструкции вакуумных электропечей сопротивления и их узлов
by: Лейканд М. С. Михаил Соломонович
Published: (Москва, Госэнергоиздат, 1961)
by: Лейканд М. С. Михаил Соломонович
Published: (Москва, Госэнергоиздат, 1961)
Безопасность эксплуатации автоклавов
by: Шишков Н. А. Николай Андронович
Published: (Москва, Стройиздат, 1978)
by: Шишков Н. А. Николай Андронович
Published: (Москва, Стройиздат, 1978)
Численный анализ динамической реакции железобетонной опоры ЛЭП на действие сейсмовзрывных нагрузок. Горный информационно-аналитический бюллетень (научно-технический журнал) № 4 (специальный выпуск 5)
by: Гильманов Р. А.
Published: (Москва, Горная книга, 2019)
by: Гильманов Р. А.
Published: (Москва, Горная книга, 2019)
Similar Items
-
Кинетика реакторов на быстрых нейтронах
by: Селезнев Е. Ф. Евгений Федорович
Published: (Москва, Наука, 2013) -
Heat transfer of fuel assemblies with four rods
by: Коротких А. Г. Александр Геннадьевич
Published: (2022) -
Changes in the state of heat-resistant steel induced by repeated hot deformation
Published: (2018) -
Комбинирование АЭС с многофункциональными энергетическими установками
by: Аминов Р. З. Рашид Зарифович
Published: (Москва, Наука, 2018) -
Processing of heavy residual feedstock on Mo/Al[2]O[3]-catalytic systems obtained using polyoxomolybdate compounds
Published: (2019)